HP Pavilion Dv6 1200 Artist Edition Entertainment Notebook Pc Series Manual

Modem module
NOTE:The modem module spare part kit does not include a modem module cable. The modem
module cable is included in the Cable Kit, spare part number 533466-001. See 
Cable Kit on page 29
for more Cable Kit spare part number information.
DescriptionSpare part number
Modem module for use in all countries and regions except Australia and New Zealand510100-001
Modem module for use only in Australia and New Zealand 510100-011
Before removing the modem module, follow these steps:
1.Shut down the...

3.Lift the modem module (3) straight up to disconnect it from the system board.
Reverse this procedure to install the modem module.
Audio/infrared board
DescriptionSpare part number
Audio/infrared board for use with computers equipped with discrete graphics memory (includes
cable)512836-001
Audio/infrared board for use with computers equipped with UMA graphics memory (includes cable) 511892-001
Before removing the audio/infrared board, follow these steps:
1.Shut down the computer. If you are unsure...

Remove the audio/infrared board:
1.Disconnect the audio/infrared board cable (1) from the LIF connector on the system board.
2.Remove the Phillips PM2.5x7.0 screw (2) that secures the audio/infrared board to the base
enclosure.
3.Release the clip (3) built into the base enclosure that secures the audio/infrared board.
4.Lift the audio/infrared board (4) straight up to remove it from the base enclosure.
Reverse this procedure to install the audio/infrared board.
USB board
DescriptionSpare part number
USB...

d.Display assembly (see Display assembly on page 68).
e.Top cover (see 
Top cover on page 80).
Remove the USB board:
1.Disconnect the USB board cable (1) from the LIF connector on the system board.
2.Remove the Phillips PM2.5×7.0 screw (2) that secures the USB board to the base enclosure.
3.Remove the USB board (3) from the base enclosure.
Reverse this procedure to install the USB board.
Power connector cable
DescriptionSpare part number
Power connector cable533465-001
Before removing the power connector...

d.Display assembly (see Display assembly on page 68).
e.Top cover (see 
Top cover on page 80).
f.USB board (see 
USB board on page 85).
g.System board (see 
System board on page 88).
Remove the power connector cable:
1.Remove the power connector cable (1) from the clips and routing channel (2) built into the base
enclosure.
2.Remove the Phillips PM2.5×7.0 screw (3) that secures the power connector and bracket to the
base enclosure.
3.Remove the power connector bracket (4).
4.Remove the power connector...

System board
NOTE:The system board spare kit includes replacement thermal material.
DescriptionSpare part number
For use with computers equipped with discrete graphics subsystem memory and 1 GB of dedicated
memory509450-001
For use with computers equipped with discrete graphics subsystem memory and 512 MB of
dedicated memory509451-001
For use with computers equipped with UMA graphics subsystem memory509449-001
For use with computers equipped with SidePort memory 570379-001
Before removing the system...

2.Disconnect the following cables from the system board:
(2) Audio/infrared board cable
NOTE:The audio/infrared board cable connects to a LIF connector on the system board.
(3) USB board cable
NOTE:The USB board cable connects to a LIF connector on the system board.
(4) Power connector cable
3.Remove the Phillips PM2.5×7.0 screw (1) that secures the system board to the base enclosure.
4.Lift the right side (2) of the system board until it rests at an angle.
5.Remove the system board (3) by sliding it up...

TV tuner module cable
NOTE:The TV tuner module cable is available in the Cable Kit, spare part number 533466-001.
Before removing the TV tuner module cable, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then...

Modem module cable
NOTE:The modem module cable is available in the Cable Kit, spare part number 533466-001. The
modem module cable includes the RJ-11 jack.
Before removing the modem module cable, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the...

Fan/heat sink assembly
NOTE:The fan/heat sink assembly spare kit includes replacement thermal material.
DescriptionSpare part number
For use only with computers equipped with graphics subsystems with discrete memory532141-001
For use only with computers equipped with graphics subsystems with UMA memory 532142-001
NOTE:To properly ventilate the computer, allow at least a 7.6-cm (3-inch) clearance on the right side
and rear panel of the computer. The computer uses an electric fan for ventilation. The fan...