HP Pavilion Dv6 1100 Entertainment Notebook Pc Series Manual

3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.Remove the battery (see 
Battery on page 59).
5.Remove the service cover (see 
Optical drive on page 60).
Remove the hard drive:
1.Disconnect the hard drive connector cable (1) from the system board.
2.Remove the four Phillips PM2.5×4.0 screws (2) that secure the hard drive to the computer.
3.Use the Mylar tab built into the hard drive bracket to lift and...

c.
Disconnect the hard drive connector cable (3) from the hard drive.
Reverse this procedure to reassemble and install the hard drive.
64 Chapter 4   Removal and replacement procedures 

RTC battery
DescriptionSpare part number
RTC battery608771-001
Before removing the RTC battery, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.Remove the...

Memory module
DescriptionSpare part number
8-GB (DDR3, 10600, 1333-MHz) 634091-001
4-GB (DDR3, 10600, 1333-MHz) 621569-001
2-GB (DDR3, 10600, 1333-MHz) 621565-001
1-GB (DDR3, 10600, 1333-MHz) 639736-001
Before removing a memory module, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from...

WLAN module
DescriptionSpare part number
For use on all computer models:
Atheros 9485GN 802.11b/g/n 1×1 WiFi and 3012 Bluetooth 4.0 Combo Adapter 655795-001
Broadcom 4313 802.11b/g/n 1×1 WiFi and 2070 Bluetooth 2.1+EDR Combo adapter
(BT3.0+HS ready)600370-001
Broadcom 4313 802.11b/g/n 1×1 WiFi Adapter 593836-001
Broadcom 4313GN 802.11b/g/n 1×1 WiFi and 20702 Bluetooth 4.0 Combo Adapter 657325-001
Ralink RT3090BC4 802.11b/g/n 1×1 WiFi and Bluetooth 2.1+EDR Combo Adapter
(BT3.0+HS ready)630705-001
Ralink...

Remove the WLAN module:
1.Disconnect the WLAN antenna cables from the terminals on the WLAN module.
NOTE:The #1/black WLAN antenna cable is connected to the WLAN module Main terminal.
The #2/gray WLAN antenna cable is connected to the WLAN module Aux terminal.
2.
Remove the two Phillips PM2.0×4.0 screws that secure the WLAN module to the system board.
(The WLAN module tilts up.)
3.Remove the WLAN module by pulling the module away from the slot at an angle.
68 Chapter 4   Removal and replacement procedures 

NOTE:If the WLAN antennas are not connected to the terminals on the WLAN module, the protective
sleeves must be installed on the antenna connectors, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
Component replacement procedures
69 

Keyboard
NOTE:The keyboard spare part kit includes a keyboard cable.
Description Spare part numberDescription Spare part number
Keyboard in black finish:
For use only with computer models
equipped with an AMD processor
in Brazil640436-201 For use only with computer models
equipped with an Intel processor
in Latin America640436-161
For use only with computer models
equipped with an AMD processor
in Bulgaria640436-261 For use only with computer models
equipped with an Intel processor
in South...

Description Spare part numberDescription Spare part number
For use only with computer models
equipped with an AMD processor
in Bulgaria644363-261 For use only with computer models
equipped with an Intel processor
in South Korea644363-AD1
For use only with computer models
equipped with an Intel processor
in India644363-D61 For use only with computer models
equipped with an Intel processor
in Taiwan644363-AB1
For use only with computer models
equipped with an Intel processor
in Israel644363-BB1 For use...

Remove the keyboard:
1.Remove the Phillips PM2.5×4.0 screw that secures the keyboard to the computer.
2.Rest the computer on its left side.
3.Open the computer.
4.Insert a screw driver or similar thin tool into the keyboard screw hole, and then press on the back
of the keyboard until the keyboard disengages from the computer.
5.Turn the computer right-side up with the front toward you.
72 Chapter 4   Removal and replacement procedures