HP Pavilion 15 Bc200 Notebook Pc Manual

							SSD (M.2)DescriptionSpare part numberGNRC SSD 128 GB 2280 M2 SATA-3 Value TL827560-017GNRC SSD 256 GB 228 0M2 PCIe 3x4SS NVMeTLC TL847109-005GNRC SSD512GB 2280M2PCIe3x4SS NVMeTLC TL847110-002
Before removing the SSD, follow these steps:
1.Turn o

						

							MemoryDescriptionSpare part numberMemory 4 GB 2133 MHz 1.2v DDR4 shared820569-0058 GB 2133 MHz 1.2v DDR4 shared820570-0052 GB 2133 MHz 1.2v DDR4 shared851379-005GNRC-SODIMM 4GB 2400MHz 1.2v DDR4862397-855GNRC-SODIMM 8GB 2400MHz 1.2v DDR4862398-855ASSY-SODIMM 2GB 2400MHz 1.2v DDR4864271-855IMPORTANT:Make special note of each screw and screw lock size and location during removal 
and replacement.
Before removing the memory, follow these steps:
1.Shut down the computer.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by 

						

							3.Grasp the edge of the memory module (2), and then gently pull the memory module out of the memory 
module slot.CAUTION:To prevent damage to the memory module, hold the memory module by the edges only. Do 
not touch the components on the memory module. 
To protect a memory module after removal, place it in an electrostatic-safe container.
To install a memory module:
CAUTION:To prevent damage to the memory module, hold the memory module by the edges only. Do not 
touch the components on the memory module.
1.Align the notched edge (1) of the memory module with the tab in the memory module slot.
Component replacement procedures35   
						

							2.With the memory module at a 45-degree angle from the surface of the memory module compartment 
(2), press the module into the memory module slot until it is seated.
3.Gently press the memory module down (3), applying pressure to both the left and right edges of the 
memory module, until the retention clips snap into place.
CAUTION:To prevent damage to the memory module, be sure that you do not bend the memory 
module.36Chapter 5   Removal and replacement procedures for authorized service provider parts  
						

							WLAN moduleDescriptionSpare part numberWLAN module, 11AC 7265NV M.2 D0 MOW        793840-005IMPORTANT:Make special note of each screw and screw lock size and location during removal 
and replacement.
Before removing the WLAN module, follow these steps:
1.Shut down the computer.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by 

						

							Reverse this procedure to install the WLAN module.38Chapter 5   Removal and replacement procedures for authorized service provider parts 
						

							BatteryDescriptionSpare part numberBattery 3C 61WH 5.37Ah LI TE03061XL-PR849910-8504C 63Wh 4.112A LI TE04063XL-PL905277-855Battery cable858968-001
Remove the battery:
WARNING!To reduce potential safety issues, use only the user-replaceable battery provided with the 
computer, a replacement battery provided by HP, or a compatible battery purchased from HP.CAUTION:Removing a user-replaceable battery that is the sole power source for the computer can cause 
loss of information. To prevent loss of information, save your work or shut down the computer through 
Windows before removing the battery.
Before removing the battery, follow these steps:
1.Shut down the computer.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by 

						

							40Chapter 5   Removal and replacement procedures for authorized service provider parts 
						

							2.Remove 4 Phillips 2x5 screws (1), lift the battery (2), and then slide the battery to remove it from the 
connector 
(3).
To insert the battery, reverse the removal procedures.
Component replacement procedures41 
						

							USB boardDescriptionSpare part numberUSB board858975-001USB board cable856729-001IMPORTANT:Make special note of each screw and screw lock size and location during removal 
and replacement
Before removing the SD card reader board, follow these steps:
1.Shut down the computer.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by