HP Envy 6 Service Manual

7.Remove the 4 Phillips PM 2x2 display panel screws.
8.Remove any tabs or tape adhering to the display panel (1), and then move the panel towards the
keyboard (2).
NOTE:Support the display panel as you lean the panel forward.
Component replacement procedures 33 

9.Release the support strip (1) covering the display panel connector. Disconnect the display panel
cable from the display panel (2), and then remove the panel (3).
Reverse this procedure to install the display panel.
Base enclosure
Description Spare part number
Base enclosure (Red) 686096–001
Base enclosure (Black) 690197–001
Base enclosure (Red) 689855–001
Before disassembling the computer, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation,...

Remove the base enclosure:
1.Turn the computer face down, remove the 12 Phillips PM 7.5 millimeter long screws.
2.Remove the bottom enclosure.
NOTE:To remove the bottom enclosure, use a thin, non-conductive tool such as the HP Tool
Shroud separator, available on the HP website.
Component replacement procedures 35 

Battery
DescriptionSpare part number
4-cell, 60WHr 4.1AH Li-ion battery 681951-001
Before removing the battery, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer....

4.Remove the battery from the computer (3).
Reverse this procedure to install the battery.
Component replacement procedures 37 

Hard drive
DescriptionSpare part number
320-GB 7200RPM SATA 7mm 634862–005
320-GB 5400RPM SATA 7mm 645193–005
500-GB 5400RPM SATA 7mm 683802–005
32-GB mSATA solid-state drive (SSD) 687100–001
128-GB mSATA solid-state drive (SSD) 687101–001
Before removing the hard drive or SSD, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected...

2.Remove the hard drive (3).
3.Remove the hard drive connector cable (1). Remove the 4 screws (2) securing the hard drive
bracket to the hard drive, and then remove the hard drive bracket (3).
4.Remove the hard drive (3).
Remove the mSATA solid-state drive:
Component replacement procedures 39 

▲Remove the screw (1), and then remove the mSATA solid-state drive (2).
Reverse these procedures to reassemble and install the hard drive.
40 Chapter 4   Removal and replacement procedures 

RTC battery
DescriptionSpare part number
RTC battery686922–001
Before removing the RTC battery, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.Remove the...

Reverse this procedure to install the RTC battery on computer models. When installing the RTC
battery, make sure the “+” sign faces up.
42 Chapter 4   Removal and replacement procedures