HP Designjet T620 610 mm User Manual

7.Unscrew and remove the cutter stop using the TORX PLUS screwdriver provided with the new
cutter. The screw is captive and will not fall out.
8.Remove the old cutter.
9.Take the new cutter from the maintenance kit and move the plunger at the top slowly back and
forth within its housing to check that it moves freely.
98 Chapter 10   Maintaining the printer ENWW
Printer maintenance
 

10.Slide the new cutter into position on the cutter rail.
The two wheels on the bottom of the cutter should engage the central ridge on the cutter rail, and
the two bushing guides should fit into the groove in the upper part of the cutter rail.
Check that the cutter runs smoothly up and down the rail. You can leave it anywhere on the rail;
the printer will park it correctly later.
11. Fit the cutter stop onto the end of the cutter rail, holding it there with one hand while you tighten
the screw with the...

12.Put the left end cover back on the printer, aligning the protrusions with the holes in the printer.
13.Close the ink cartridge cover.
14.At the front panel, turn the printer back on. The printer checks that the cutter has been correctly
installed. Look at the front panel and follow its instructions if there is any problem.
Maintain the ink cartridges
During the normal lifetime of a cartridge, no specific maintenance is required. However, in order to
maintain the best print quality, replace a cartridge...

If you need to leave the printer turned off for a long time, follow the additional steps below.
1.Turn off the power using the  Power key on the front panel.
2. Also turn off the power switch at the rear of the printer.
3. Disconnect the printers power cable.
4. Before transporting the printer, secure the rear tray in the closed position with tape. Otherwise, the
tray could open and perhaps break and fall out of the printer.
CAUTION: If you turn the printer upside down, ink could escape into the printer...

If you experience very slow progress while uploading the firmware file to the printer, the reason could
be that you are using a proxy server. In that case, try bypassing the proxy server and accessing the
Embedded Web Server directly.
●In Internet Explorer 6 for Windows, go to 
Tools > Internet Options  > Connections > LAN
Settings , and check the  Bypass proxy server for local addresses box. Alternatively, for more
precise control, click the  Advanced button and add the printers IP address to the list...

ENWWSecure Disk Erase103
Printer maintenance
 

104 Chapter 10   Maintaining the printerENWW
Printer maintenance
 

11 Accessories
●How to order supplies and accessories
●
Introduction to the accessories
ENWW 105
Accessories
 

How to order supplies and accessories
There are two alternative ways to order supplies or accessories for your printer:
●Visit 
http://www.hp.com/go/T620/accessories/
 on the Web.
● Contact HP Support (see 
Contact HP Support on page 156
).
The rest of this chapter lists the available supplies and accessories, and their part numbers.
Order ink supplies
The following ink supplies can be ordered for your printer.
Table 11-1   Ink cartridges
CartridgePart number
HP 72 69 ml Photo Black Ink CartridgeC9397A...

●(E) indicates papers available in Europe, the Middle East and Africa
● (J) indicates papers available in Japan
● (L) indicates papers available in Latin America
● (N) indicates papers available in North America
If the part number is not followed by parentheses, the paper is available in all regions.
Table 11-3  Roll paper
Paper typeg/m²LengthWidthPart numbers
HP Bond and Coated Paper
HP Universal Inkjet Bond Paper
80150 ft = 45.7 m23.39 in = 594 mm (A1)Q8003A (AJ)
24 in = 610 mmQ1396A
300 ft = 91.4...