HP DesignJet 8000sr User Manual

16.Close the front cover (1).
The following message is displayed on the front panel:
17.Select  YES and press the  OK key to confirm replacement.
ENWW Wiper liquid bottle replacement 81
How do I maintain the printer
 

Wiper sponge replacement
The wiper sponge ensures that the wiper blade can correctly clean the printheads. The wiper sponge should
be replaced approximately every six months or when the following message is displayed:
NOTE Please contact HP Support to obtain the Wi per Sponge Replacement Kit containing the
new wiper sponge and wiper liquid bottle.
CAUTION The use of safety glasses and gloves is recommended when performing cleaning
and maintenance operations.
Always use genuine HP cleaning kits. These...

6.When the following message is displayed, open the front cover (1).
7.Open the right maintenance cover (1).
ENWW Wiper sponge replacement 83
How do I maintain the printer
 

8.Carefully lift the empty wiper liquid bottle from the wiper liquid holder enough to make sure any
remaining liquid drains into the printer.
NOTE It is recommended that you put on the gloves  that came with the HP Wiper Cleaning
Kit.
WARNING! Make sure that the wiper liquid does  not drip onto other parts of the printer.
9. Remove and discard the wiper liquid bottle from the wiper liquid holder.
10. Remove the wiper sponge by pulling out the tray  (1). Do not remove the tray completely.
84 Chapter 6...

11.Tilt the wiper sponge tray to empty any  excess liquid into the drainage tray.
12.Open the carriage maintenance cover, remove the wiper sponge (1) and close the cover.
ENWW Wiper sponge replacement 85
How do I maintain the printer
 

13.Insert a new wiper sponge.
14.Remove the wiper liquid bottle cap (1) from the  new bottle supplied in the Wiper Sponge Replacement
Kit.
15. Make sure that the plastic seal (1) is well positi oned in the hole of the wiper liquid dispenser cap.
86 Chapter 6   How do I maintain the printer ENWW
How do I maintain the printer
 

16.Insert the wiper liquid dispenser cap (1).
17.Place the wiper liquid bottle in the wiper liquid holder  and push it firmly down to ensure it is fully
engaged.
ENWW Wiper sponge replacement 87
How do I maintain the printer
 

18.Close the right maintenance cover (1).
19.Close the front cover (1).
The following message is di splayed on the front panel:
20.Select  YES and press the  OK key to confirm replacement.
Wiper blade replacement
The wiper blade cleans the printheads. Replace the  wiper blade every three months or when the following
message is displayed:
88 Chapter 6   How do I maintain the printer ENWW
How do I maintain the printer
 

CAUTIONThe use of safety glasses and gloves is recommended when performing cleaning
and maintenance operations.
Always use Genuine HP Cleaning and Maint enance Kits. These have been designed for
maintaining high-quality imaging performance and reliable printer operation. Using non-HP
supplies may cause poor print quality, printer malfunction, printer failure, or a safety hazard.
When the  PRINTER READY  message appears on the front panel, press the  ONLINE key to take the printer
offline.
1. Press the...

7.Open the right maintenance cover (1).
8.The wiper blade (1) is located on t he left in the maintenance area.
90 Chapter 6   How do I maintain the printer ENWW
How do I maintain the printer