HP Designjet 111 User Manual

							Use ink economically
Here are some recommendations for making economical use of ink.
●For draft prints, use plain paper and select Fast print quality.
●Clean the printheads only when needed, and clean only those printheads that need cleaning.
Cleaning the printheads can be useful, but it uses a small amount of ink.
●Leave the printer permanently turned on so that it can maintain the printheads in good condition
automatically. This regular printhead maintenance uses a small amount of ink. However, if it is
not done, the printer may need to use much more ink later to restore the health of the
printheads.
ENWWUse ink economically 25
Printing
 
						

							5 Ink-system maintenance
Replace ink cartridges
1.Open the front hinged flap at the right of the printer.
2.Gripping it by its shorter top edges, lift the ink cartridge vertically up and out of the printer.
3.Lower the new ink cartridge into its slot until it clicks into place and is quite secure.
26 Chapter 5   Ink-system maintenance ENWW
Ink maintenance
 
						

							4.Repeat the preceding two steps for each ink cartridge that you wish to replace.
5.Close the outer flap.
Replace printheads
NOTE:After a printhead is replaced, the printer will automatically realign the printheads.
1.Open the front hinged flap at the right of the printer.
2.Open the second (back) part of the flap and lift it right back.
3.The print carriage will move to the left and then back to the right. Wait for it to stop.
4.Pull the printhead cover up and towards you, so that the hook at the front unlatches itself, and
then push the whole cover back so that the printheads are exposed.
ENWWReplace printheads 27
Ink maintenance
 
						

							5.Lift the small handle at the top front and use it to pull the printhead vertically up and out of the
printer.
6.Take the new printhead and remove the tape that protects its electrical contacts and ink nozzles.
7.Lower the new printhead into place and close its small handle.
28 Chapter 5   Ink-system maintenance ENWW
Ink maintenance
 
						

							8.Push the printhead gently into place, so that it is quite secure.
9.Repeat the preceding four steps for each printhead that you wish to replace.
10.Pull the printhead cover towards you, ensuring that the hook at its front edge latches onto the
tab, and then push it away from you to close the cover.
11.Close the rear part and then the front part of the outer flap.
ENWWReplace printheads 29
Ink maintenance
 
						

							6 Supplies and accessories
Supported paper types
The following paper types are currently provided for use with your printer.
NOTE:This list is likely to change over the course of time. For the latest information, see
http://www.hp.com/go/111/accessories/.
NOTE:Paper types that HP does not support may nevertheless be compatible with your printer.
Key to availability:
●(A) indicates papers available in Asia (excluding Japan)
●(E) indicates papers available in Europe, the Middle East and Africa
●(J) indicates papers available in Japan
●(L) indicates papers available in Latin America
●(N) indicates papers available in North America
If the part number is not followed by parentheses, the paper is available in all regions.
Table 6-1  Roll paper
Paper type g/m² Length Width Part numbers
HP Bond and Coated Paper
HP Universal Bond Paper 80 45.7 m (150 ft) 610 mm (24 in) Q1396A
HP Bright White Inkjet Bond Paper 90 45.7 m (150 ft) 420 mm (16.54 in) (A2) Q1446A (J)
594 mm (23.39 in) (A1) Q1445A (EJ)
610 mm (24 in) C1860A (LN),
C6035A (AEJ)
HP Recycled Bond Paper 80 45.7 m (150 ft) 420 mm (16.54 in) (A2) CG892A (E)
610 mm (24 in) CG889A (EN)
HP Cockle-free Coated Paper 100 45.7 m (150 ft) 610 mm (24 in) CG883A (EN)
HP Cockle-free Heavyweight
Coated Paper170 30.5 m (100 ft) 610 mm (24 in) CG886A (EN)
HP Universal Coated Paper 95 45.7 m (150 ft) 610 mm (24 in) Q1404A (AEJN)
HP Coated Paper 90 45.7 m (150 ft) 420 mm (16.54 in) (A2) Q1443A (J)
594 mm (23.39 in) (A1) Q1442A (EJ)
610 mm (24 in) C6019B
HP Inkjet Coated Paper 90 45.7 m (150 ft) 457 mm (18 in) Q7897A (EJN)
30 Chapter 6   Supplies and accessories ENWW
Supplies
 
						

							Table 6-1  Roll paper (continued)
Paper type g/m² Length Width Part numbers
HP Universal Heavyweight Coated
Paper120 30.5 m (100 ft) 610 mm (24 in) Q1412A (AEJN)
HP Heavyweight Coated Paper 131 30.5 m (100 ft) 610 mm (24 in) C6029C (AEJN)
HP Technical Paper
HP Natural Tracing Paper 90 45.7 m (150 ft) 420 mm (16.54 in) (A2) Q1440A (J)
594 mm (23.39 in) (A1) Q1439A (J)
610 mm (24 in) C3869A
HP Translucent Bond Paper 67 45.7 m (150 ft) 610 mm (24 in) C3860A (AJN)
HP Vellum 75 45.7 m (150 ft) 610 mm (24 in) C3862A (N)
HP Film (Technical and Graphic)
HP Matte Film 160 38.1 m (125 ft) 610 mm (24 in) 51642A (AEJN)
HP Photographic Paper
HP Universal Instant-Dry Gloss
Photo Paper190 30.5 m (100 ft) 610 mm (24 in) Q6574A
TIP:The dye inks used by your printer will fade very quickly on instant-dry photo papers. If you plan to display the prints for
more than two weeks, you should laminate them to achieve longer life.
HP Premium Plus Gloss Photo
Paper280 15.2 m (50 ft) 610 mm (24 in) Q5488A
HP Premium Plus Satin Photo
Paper280 15.2 m (50 ft) 457 mm (18 in) Q7920A
610 mm (24 in) Q5491A
HP Universal High-Gloss Photo
Paper190 30.5 m (100 ft) 610 mm (24 in) Q1426A (AEJN)
HP Universal Semi-Gloss Photo
Paper190 30.5 m (100 ft) 610 mm (24 in) Q1420A (AEJN)
HP Proofing Paper
HP Professional High-gloss
Contract Proofing Paper200 30.5 m (100 ft) 457 mm (18 in) Q8664A (EN)
610 mm (24 in) Q8663A (EN)
HP Professional Semi-gloss
Contract Proofing Paper235 30.5 m (100 ft) 457 mm (18 in) Q8049A (EN)
610 mm (24 in) Q7971A (EN)
HP Matte Proofing Paper 146 30.5 m (100 ft) 457 mm (18 in) Q7896A (EJN)
610 mm (24 in) Q1968A (AEJN)
HP Premium Semi-gloss Proofing
Paper240 30.5 m (100 ft) 457 mm (18 in) CG462A (E)
610 mm (24 in) CG463A (E)
Table 6-2  Sheet paper
Paper type g/m² Length Width Part numbers
HP Bond and Coated Paper
ENWWSupported paper types 31
Supplies
 
						

							Table 6-2  Sheet paper (continued)
Paper type g/m² Length Width Part numbers
HP Coated Paper 90 610 mm (24 in) 457 mm (18 in) Q1961A (AEJN)
914 mm (36 in) 610 mm (24 in) Q1962A (AEN)
HP Photographic Paper
HP Premium Plus Gloss Photo
Paper280 483 mm (19 in) 330 mm (13 in) Q5486A
610 mm (24 in) 457 mm (18 in) Q5487A
HP Premium Plus Satin Photo
Paper280 483 mm (19 in) 330 mm (13 in) Q5489A
610 mm (24 in) 457 mm (18 in) Q5490A
HP Proofing Paper
HP Professional High-gloss
Contract Proofing Paper200 483 mm (19 in) 330 mm (13 in) Q8662A (EN)
HP Professional Semi-gloss
Contract Proofing Paper235 483 mm (19 in) 330 mm (13 in) Q7970A (EJN)
HP Matte Proofing Paper 146 483 mm (19 in) 330 mm (13 in) Q1967A (AEJN)
HP Premium Semi-gloss Proofing
Paper240 483 mm (19 in) 330 mm (13 in) CG461A (E)
Supported paper sizes
Roll paper
The minimum width of roll paper is 4.3 in (110 mm) and the maximum width is 24 in (610 mm).
Cut-sheet paper
 Width Length Thickness
Tray minimum 76 mm (3 in) 142 mm (5.6 in) –
Tray maximum (C+) 457 mm (18 in) 610 mm (24 in) Envelopes: 0.4 mm (0.015 in)
Other papers: 0.2 mm (0.008 in)
Front path minimum 110 mm (4.3 in) 205 mm (8.1 in) –
Front path maximum (A1 oversize) 625 mm (24.6 in) 1625 mm (63.9 in) 0.2 mm (0.008 in)
Rear path minimum 110 mm (4.3 in) 205 mm (8.1 in) –
Rear path maximum (A1 oversize) 625 mm (24.6 in) 1625 mm (63.9 in) 0.4 mm (0.015 in)
Order ink cartridges and printheads
The following table shows for each item the part number and selectability number, and also shows
the capacity of the ink cartridges.
Color Ink cartridge Printhead
Yellow C4838AN, HP 11, 28 ml C4813A, HP 11
32 Chapter 6   Supplies and accessories ENWW
Supplies
 
						

							Color Ink cartridge Printhead
Black CH565A, HP 82, 69 ml C4810A, HP 11
Magenta C4837AN, HP 11, 28 ml C4812A, HP 11
Cyan C4836AN, HP 11, 28 ml C4811A, HP 11
Order accessories
The following accessories are available for use with your printer.
●External I/O print server (J4169A)
●Printer stand (Q1246A)
ENWWOrder accessories 33
Supplies
 
						

							7 HP Designjet System Maintenance
The HP Designjet System Maintenance utility provides several facilities that may help to solve printer
problems.
To start HP Designjet System Maintenance under Windows, double-click the HP Designjet System
Maintenance icon on your desktop. Alternatively, you can follow these steps:
1.From the Windows taskbar, select Start > Control Panel > Printers.
2.Right-click your printer’s icon and select Printing Preferences from the pop-up menu.
3.Select the Advanced tab and click the Maintenance button.
To start HP Designjet System Maintenance under Mac OS, click the HP Utility icon in the dock.
Alternatively, click the Utility icon in the printer proxy.
Under Windows or Mac OS, your Web browser should start automatically when you have followed the
instructions above.
If you cannot follow these instructions successfully:
●Perhaps your computer does not manage the printer. In this case, use HP Designjet System
Maintenance from the printer server.
●Perhaps the printer is managed by your computer but HP Designjet System Maintenance has
not been installed. In this case, install it from the HP Designjet 111 Software and Documentation
CD.
34 Chapter 7   HP Designjet System Maintenance ENWW
System Maintenance