HP Compaq Presario W19q User Guide

							 
 
Preset Display Modes 
Standard Resolution Horizontal Frequency 
(kHz) Vertical Frequency (Hz) 
Dos-mode 720 x 400 31.47 70.0 
VGA 640 x 480 31.47 60.0 
VGA 640 x 480 37.50 75.0 
SVGA 800 x 600 37.879 60.0 
SVGA 800 x 600 46.875 75.0 
XGA 1024 x 768 48.363 60.0 
XGA 1024 x 768 56.476 70.0 
XGA 1024 x 768 60.02 75.0 
SXGA 1280 x 1024 64.00 60.0 
SXGA 1280 x 1024 80.00 75.0 
WXGA+ 1440 x 900 55.935 59.8 
WXGA+  1440 x 900  70.635  74.984  
Physical Characteristics 
Connector Types 15-pin Mini D-Sub VGA, DVI-D, headphone-out 
Signal Cable Type Detachable 
    
Dimensions & Weight:   
Height (with base) 14.0 inches (356.5 mm) 
Width 17.3 inches (438.5 mm) 
Depth 8.3 inches (211 mm) 
Weight (monitor only) 12.61 (4.85 kg) 
Weight (with packaging) 17.00 lb (6.54 kg)  
Environmental 
Temperature:   
Operating 5°C to +35°C 
Non-Operating –20°C to +60°C 
Humidity:   
Operating 15% to 90% (non-condensing) 
Non-Operating 15% to 90% (non-condensing) 
Altitude:   
Operating 0~3,658m (0~12,000 ft) 
Non-Operating 0~12,192m (0~40,000 ft)  
 
						

							 
 
Power Cord Set Requirements 
The monitor power supply is provided with automatic line switching (ALS). This feature allows the monitor to 
operate on input voltages in the range of 100–240V, 50/60 Hz, 1.5A. 
The power cord set (flexible cord or wall plug) received with the monitor meets the requirements for use in the 
country/region where the equipment was purchased. 
If you need to obtain a power cord for a different country/region, you should purchase a power cord that is 
approved for use in that country/region. 
The power cord must be rated for the product and for the voltage and current marked on the product’s electrical 
ratings label. The voltage and current rating of the cord should be greater than the voltage and current rating 
marked on the product. In addition, the cross-sectional area of the wire must be a minimum of 0.75 mm² or 
18AWG, and the length of the cord must be between 4.94 ft (1.5 m) and 12 ft (3.6 m). If you have questions 
about the type of power cord to use, contact your HP-authorized service provider. 
A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or 
against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits from 
the product. 
 
Pin Assignments 
Pin Number 
15-Pin Side of 
the Signal Cable
 
1 Video-Red 
2 Video-Green 
3 Video-Blue 
4 Ground 
5 Detect Cable 
6 GND-R 
7 GND-G 
8 GND-B 
9 +5V 
10 Ground 
11 Ground 
12 DDC-Serial data 
13 H-sync 
14 V- s y n c 
15 DDC-Serial clock  
 
						

							 
 
 
Pin 
No. Signal Name Pin 
No. Signal Name Pin  
No. Signal Name 
1  TMDS Data 2–  9  TMDS Data 1–  17  TMDS Data 0– 
2  TMDS Data 2+  10  TMDS Data 1+  18  TMDS Data 0+ 
3  TMDS Data 2/4 Shield  11  TMDS Data 1/3 Shield  19  TMDS Data 0/5 Shield 
4  TMDS Data 4–  12  TMDS Data 3–  20  TMDS Data 5– 
5  TMDS Data 4+  13  TMDS Data 3+  21  TMDS Data 5+ 
6  DDC Clock  14  +5V Power  22  TMDS Clock Shield 
7  DDC Data  15  Ground (for +5V)  23  TMDS Clock+ 
8  N.C.  16  Hot Plug Detect  24  TMDS Clock–  
Plug and Play DDC2B Feature 
This monitor is equipped with VESA DDC2B capabilities according to the VESA DDC STANDARD. It allows the 
monitor to inform the host system of its identity and, depending on the level of DDC used, communicate 
additional information about its display capabilities. 
The DDC2B is a bi-directional data channel based on the I²C protocol. The host can request EDID information 
over the DDC2B channel. 
 
						

							 
  
Back to Contents Page 
LCD Monitor Quality and Pixel Policy 
 
The HP LCD Monitor uses high-precision technology, manufactured according to high standards, to help 
guarantee trouble-free performance. Nevertheless, the display may have cosmetic imperfections that appear as 
small bright or dark spots. This is common to all LCD displays used in products supplied by all vendors and is not 
specific to the HP LCD Monitor. These imperfections are caused by one or more defective pixels or subpixels.  
• A pixel consists of one red, one green, and one blue subpixel. 
• A defective whole pixel is always turned on (a bright spot on a dark background), or it is always off (a dark 
spot on a bright background). The first is the more visible of the two. 
• A defective subpixel (dot defect) is less visible than a defective whole pixel and is small and only visible on a 
specific background. 
To locate defective pixels, the monitor should be viewed under normal operating conditions and in normal 
operating mode at a supported resolution and response rate, from a distance of approximately 50 cm (16 in). 
We expect that, over time, the industry will continue to improve its ability to produce displays with fewer cosmetic 
imperfections, and we will adjust guidelines as improvements are made. 
For more information about your w19b / w19e / W19q LCD Monitor, refer to the HP Web site at: 
http://www.hp.com/support
 
 
						

							 
  
Back to Contents Page 
Agency Regulatory Notices 
 
Federal Communications Commission Notice 
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does 
cause harmful interference to radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more of the following measures:  
• Reorient or relocate the receiving antenna. 
• Increase the separation between the equipment and the receiver. 
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  
• Consult the dealer or an experienced radio or television technician for help. 
 
Modifications 
The FCC requires the user to be notified that any changes or modifications made to this device that are not 
expressly approved by Hewlett-Packard Company may void the user’s authority to operate the equipment. 
 
Cables 
Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain 
compliance with FCC rules and regulations. 
 
						

							 
 
Declaration of Conformity for Products Marked with FCC Logo, 
United States Only 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this 
device may not cause harmful interference, and (2) this device must accept any interference received, including 
interference that may cause undesired operation. 
For questions regarding your product, contact: 
Hewlett-Packard Company 
P. O. Box 692000, Mail Stop 530113 
Houston, Texas 77269-2000 
Or 
call: 1-(800)-474-6836 
For questions regarding this FCC declaration, contact: 
Hewlett-Packard Company 
P. O. Box 692000, Mail Stop 510101 
Houston, Texas 77269-2000 
Or 
call: 1-(281)-514-3333 
To identify this product, refer to the part, series, or model number found on the product. 
 
						

							 
 
Canadian Notice 
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment 
Regulations. 
 
Av i s  C a n a d i e n  
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du 
Canada. 
 
European Union Regulatory Notice 
This product complies with the following EU directives:  
• Low Voltage Directive 73/23/EEC 
• EMC Directive 89/336/EEC 
Compliance with these directives implies conformity to applicable harmonized European standards (European 
Norms) which are listed on the EU Declaration of Conformity issued by Hewlett-Packard for this product or 
product family. 
This compliance is indicated by the following conformity marking placed on the product: 
  
This marking is valid for non-Telecom products and EU 
harmonized Telecom products (e.g., Bluetooth). xxxx*  
This marking is valid for EU non-harmonized Telecom 
products. *Notified body number (used only if applicable — 
refer to the product label). 
 
 
 
						

							 
 
Disposal of Waste Equipment by Users in Private Households in the 
European Union 
 
This symbol on the product or on its packaging indicates that this product must not be disposed of with your other 
household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a 
designated collection point for the recycling of waste electrical and electronic equipment. The separate collection 
and recycling of your waste equipment at the time of disposal will help to conserve natural resources and ensure 
that it is recycled in a manner that protects human health and the environment. For more information about where 
you can drop off your waste equipment for recycling, please contact your local city office, your household waste 
disposal service or the shop where you purchased the product. 
 
Japanese Notice 
 
 
						

							 
 
Japanese Power Cord Notice 
 
 
Japanese Material Content Declaration 
A Japanese regulatory requirement, defined by Specification JIS C 0950, 2005,  
mandates that manufacturers provide Material Content Declarations for certain  
categories of electronic products offered for sale after July 1, 2006. To view the  
JIS C 0950 material declaration for this product, visit www.hp.com/go/jisc0950
 
 
 
Korean Notice 
 
 
Materials Disposal 
This HP product contains Mercury in the fluorescent lamp in the display LCD that might require special handling 
at end-of-life. 
Disposal of this material can be regulated because of environmental considerations. For disposal or recycling 
information, please contact your local authorities or the Electronic Industries Alliance (EIA) (www.eiae.org
). 
 
						

							 
HP Recycling Program 
HP offers product end-of-life return programs for HP and other manufacturers’ hardware in several geographic 
areas. 
The terms and availability of these programs vary by geography because of differences in regulatory 
requirements and local customer demand. For information on the HP recycling program, refer to the HP Web site 
at: http://www.hp.com/recycle
 
 
EPA Energy Star Compliance 
 
Products marked with the ENERGY STAR
® logo on the packaging box qualify with the U.S. Environmental 
Protection Agency’s ENERGY STAR® guidelines for energy efficiency. 
Products with the ENERGY STAR
® label are designed to use less energy, help you save money on utility bills, and 
help protect the environment. 
ENERGY STAR
® is a registered trademark owned by the U.S. government.