Home > Honeywell > Control panel > Honeywell control panel 4110XM User Manual

Honeywell control panel 4110XM User Manual

Here you can view all the pages of manual Honeywell control panel 4110XM User Manual. The Honeywell manuals for Control panel are available online for free. You can easily download all the documents as PDF.

Page 31

Fire Alarm System (cont’d) 
 
– 31 – 
National Fire Protection Association Recommendations on 
Smoke Detectors 
General   
With  regard  to  the  number  and  placement  of  smoke/he at  detectors,  we  subscribe  to 
the  recommendations  contained  in  the  National  Fire  Protection  Associations 
Standard #74 noted below.  
Early  warning  fire  detection  is  best  achieved  by  th e  installation  of  fire  detection 
equipment  in  all  rooms  and  areas  of  the  premises  as   follows:  A  smoke...

Page 32

Fire Alarm System (cont’d) 
 
– 32 – 
Emergency Evacuation 
Establish  and  regularly  practice  a  plan  of  escape  in  the  event  of  fire.  The  following 
steps are recommended by the National Fire Protecti on Association: 
2nd FLOOR
BACK
FRONTfloor_plan-002-V0
BATH
CLOSET
BEDROOM
BEDROOM
BEDROOM
1st FLOOR
BATH
KITCHEN
BEDROOM BEDROOM
PORCH
BACK DOOR
 
 Steps to Safety  
1.  Plan  on  your  detector  or  your  interior  and/or  ex
terior 
sounders warning all occupants. 
2.  Determine two means of...

Page 33

 
– 33 – 
Quick Guide to Basic System Functions 
FUNCTION  PROCEDURE  COMMENTS 
Check Zones Press READY key.  To view faulted zones when system  not ready. 
Arm System Enter code. Press arming key desired:  
(AWAY, STAY, INSTANT, MAXIMUM)  Arms system in mode selected. 
Quick Arm  
(if programmed) Press #. Press arming key desired: 
(AWAY, STAY, INSTANT, MAXIMUM)  Arms system in mode selected, quickly and 
without use of code. 
Bypass Zone(s)  Enter code. Press BYPASS key.  
Enter zone number(s) to be...

Page 34

 
– 34 – 
Summary of Audible/Visual Notification 
SOUND  CAUSE  DISPLAY 
LOUD, INTERRUPTED† 
Keypad & External  FIRE ALARM    FIRE
 and ALARM  are displayed; protection zone in alarm 
is displayed. 
LOUD, CONTINUOUS† 
Keypad & External  BURGLARY/AUDIBLE   
EMERGENCY ALARM   ALARM 
is displayed; protection zone in alarm is also 
displayed. 
ONE SHORT BEEP    
(not repeated)   
Keypad only  a. SYSTEM DISARM     
b. SYSTEM ARMING  ATTEMPT 
WITH AN OPEN ZONE 
 
c. BYPASS VERIFY   a. Only 
READY  is...

Page 35

 
– 35 – 
Protection Zones List 
One  or  more  sensing  devices  will  have  been  assigned  by  the  installer  of  your  alarm 
system  to  each  of  the  various  protection  zones  in  y our  system (although  not  every 
zone  number  can  be  used).   For  example,  the  sensing  device  on  your  Entry/Exit   door 
may  have  been  assigned  to  zone  06,  sensing  devices  on  windows  in  the  master 
bedroom to zone 10, and so on.   
Zone  numbers  07,  95  and  96  represent  Keypad  Panic...

Page 36

 
– 36 – 
OWNERS INSURANCE PREMIUM  
CREDIT REQUEST 
 
This  form  should  be  completed  and  forwarded  to  your  homeowners  insurance  carrier  for  possible 
premium credit. 
A.  GENERAL INFORMATION: 
  Insureds Name and Address: _______________________ ____________________________________  
    _________________________________________________ ___________  
  Insurance Company:   Policy No.:   ________________________  
 ADEMCO 4110XM   
  Type of Alarm:       Burglary      Fire      Both...

Page 37

 
– 37 – 
OWNERS INSURANCE PREMIUM  
CREDIT REQUEST (cont.) 
 
E.  SMOKE DETECTOR LOCATIONS: 
      Furnace Room      Kitchen      Bedrooms      Attic  
      Basement      Living Room      Dining Room      Hall  
F.  BURGLARY DETECTING DEVICE LOCATIONS: 
      Front Door      Basement Door       Rear Door      All Exterior Doors 
      1st Floor Windows      All windows      Interior Locations 
      All Accessible Openings, Including Skylights, Air Conditioners and Vents 
G.  ADDITIONAL PERTINENT...

Page 38

Regulatory Statements and Warnings 
– 38 – 
FEDERAL COMMUNICATIONS COMMISSION STATEMENTS  
The user shall not make any changes or modifications to the equipment unless 
authorized by the Installation Instructions or User s Manual. Unauthorized changes or 
modifications could void the users authority to op erate the equipment. 
CLASS B DIGITAL DEVICE STATEMENT 
This equipment has been tested to FCC requirements  and has been found acceptable 
for use. The FCC requires the following statement f or your...

Page 39

Regulatory Statements and Warnings (cont’d) 
 
– 39 – 
 
TELEPHONE/MODEM INTERFACE 
FCC Part 68 
This  equipment  complies  with  Part  68  of  the  FCC  rules.    On  the  front  cover  of  this  equipment  is  a  label  that contains the FCC registration number and Ringer Equ ivalence Number (REN).  You must provide this information to the telephone company when requested.  This equipment uses the following USOC jack: RJ31X  This  equipment  may  not  be  used  on  telephone-company -provided  coin...

Page 40

 
– 40 – 
IN THE EVENT OF TELEPHONE OPERATIONAL PROBLEMS 
If  your  security  system  has  been  connected  to  the  telephone  line,  and  there  is  trouble  with  regular 
telephone  service,  disconnect  the  security  system  from  the  telephone  line  by  removing  the  plug  from 
the RJ31X (CA38A in Canada) telephone wall jack (yo u should have been shown how to do this by your 
installing  company). Do  not  attempt  to  disconnect  the  telephone  line  con nection  inside  the  control...
Start reading Honeywell control panel 4110XM User Manual

Related Manuals for Honeywell control panel 4110XM User Manual

All Honeywell manuals