Honeywell 8 Channel Dvr Manual

HREP Color Digital Video Recorder User Guide
Document 800-06847 Rev B61
08/10
Figure 2-54 BUZZER OUT Setup Menu
These settings determine the behavior and actions that will trigger the internal buzzer. 
2. Configure the following behavior settings:
3. Configure the action settings:
NoteRemember to select APPLY and click   to save all settings before exiting 
these menus.
Configuring E-Mail Notification
1. Click E-MAIL NOTIFICATION on the left side of the EVENT/SENSOR window.
The E-MAIL NOTIFICATION setup...

62 Installation
Figure 2-55 E-MAIL NOTIFICATION Setup Menu
These settings determine the behaviors and actions that will send an e-mail to a remote 
user. 
2. Configure the behavior settings:
3. Configure the action settings:
NoteE-mail settings must also be configured in the Modifying User Details on page 
52 and Configuring E-Mail Notification on page 61.
NOTIFICATIONTurn ON/OFF e-mail notification.
SETUP CHANGEConfigure whether a setup change triggers an e-mail 
notification.
HDD EVENTConfigure whether...

HREP Color Digital Video Recorder User Guide
Document 800-06847 Rev B63
08/10
Configuring Disk Management Settings
Select DISK MANAGEMENT in the Main system setup window, then click  . The DISK 
MANAGEMENT setup window opens.
Figure 2-56 DISK MANAGEMENT Setup Window
Highlight DISK MANAGEMENT, then press   to manage the internal hard drives.
NoteWhen a RECORD TIME LIMIT is set, the OVERWRITE option cannot be 
changed. 
RECORD TIME LIMITIn certain circumstances, it might be necessary to limit the 
amount...

64 Installation
RECORD SETUP
Click MENU   on the control panel.
The SETUP window appears.
Figure 2-57 SETUP Window
Click RECORD SETUP in the SETUP window.
The RECORDING window appears. 
Figure 2-58 RECORDING Setup Window
Configuring the Recording Behavior of your DVR
Use the   to configure the settings on the RECORDING OPERATION window. See 
Figure 2-58. 
SCHEDULE MODESelect either DAILY (one schedule applies to every 
day of the week) or WEEKLY (each day of the week 
has its own schedule).
PRE EVENT...

HREP Color Digital Video Recorder User Guide
Document 800-06847 Rev B65
08/10
Configuring Continuous/Motion Recording
1. Click CONTINUOUS/MOTION RECORDING on the left side of the RECORDING 
setup window. 
The CONTINUOUS/MOTION RECORDING Setup window opens.
2. Press   to choose this window.
Figure 2-59 CONTINUOUS/MOTION RECORDING Setup Window
3. Use this window to configure scheduled and motion detection settings. There are two 
tabs for configuration:
Configuring SIZE/FPS/QUALITY
1. If it is not already...

66 Installation
Figure 2-60 Configuring SIZE/FPS/QUALITY Time Bar
Each green cursor box represents one hour. 
The table below the time bar shows the recording settings for this time period.
2. Select a length of time on the schedule. A new configuration window opens. 
Figure 2-61 Configuring SIZE/FPS/QUALITY Window
Frames available 

HREP Color Digital Video Recorder User Guide
Document 800-06847 Rev B67
08/10
3. Configure the SIZE, FPS, QUALITY, and AUDIO for each channel. Click  to save a 
setting. Click   to cancel a setting and exit that setting. 
4. Select OK, then press  to save your settings. Press   or navigate to CANCEL 
then press   to exit without saving the changes.
When configuring 16 channels, the channels are divided into two groups of 8. 
NoteThe maximum recording frame rate for each group is 240FPS at a resolution...

68 Installation
Configuring the Schedule
1. Use the cursor keys to navigate to SCHEDULE, then press . 
Figure 2-62 Configuring the Schedule
2. To change the SCHEDULE settings, press  again. 
The schedule box highlights in green.
3. Press and hold , then use the cursor keys to drag and select the recording time 
and the channels. 
Figure 2-63 Selected Channels and Time
4. Click   again when you have made your selection.
The EVENT window opens.  

HREP Color Digital Video Recorder User Guide
Document 800-06847 Rev B69
08/10
Figure 2-64 EVENT Window
5. Select the type of event recording (NONE, CONTINUOUS, MOTION, 
CONTINUOUS/MOTION), then click OK. The EVENT window closes. 
Color Codes for the Schedule Screen
The schedule screen uses four differently colored blocks to indicate the different recording 
modes.
Configuring Alarm Setup
Click ALARM RECORDING on the left side of the RECORDING setup window. 
The ALARM RECORDING Setup window opens....

70 Installation
NoteAlarm-activated recording can be used in conjunction with 
Continuous/Motion Recording. For example, you can configure your DVR to 
record continuously at a low frame rate (set in Continuous/Motion Recording), 
and then to increase to a higher frame rate during an alarm input (set in 
ALARM SETUP). 
Configuring Panic Recording
Click PANIC RECORDING on the left side of the RECORDING setup window. 
The PANIC RECORDING Setup window opens.
Figure 2-65 PANIC RECORDING Setup Window
During...