honda nc700 x xa xd owners 2012 User Manual

							28
Operation Guide
Indicators
 Low oil pressure indicator
Comes on when the ignition 
switch is turned on.
Goes off when the engine starts.
If it comes on while engine is 
running: 
(P98)
 PGM-FI (Programmed Fuel Injection)  malfunction indicator lamp (MIL)
 High coolant  temperature indicator
If it comes on while riding: 
(P97)
Comes on briefly when the ignition switch is  turned on with the engine stop switch in 
the Run   position. Comes on when the ignition switch is turned on with the engine 
stop switch in the Off   position.
If it comes on while engine is running: 
(P98)
 ABS (Anti-lock Brake System) indicator  (NC700XA/XD only)
Comes on when the ignition  switch is turned on. 
Goes off when your speed  reaches approximately 
10 km/h (6 mph).
If it comes on while riding: 
(P99)
12 NC700X Revision-42MGS6010.book  28 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分  
						

							29
Operation GuideHISS indicator (P120)
• Comes on briefly when the ignition switch is turned on with 
the engine stop switch in the 
Run   position. Goes off if the 
ignition key has the correct 
coding.
• Flashes every 2  seconds for 24 
hours when the ignition switch is 
turned off.
 High beam indicator
 Left turn signal indicator
 Right turn signal indicator
 Neutral indicator
Comes on when the transmission 
is in Neutral.
 Parking brake indicator
(NC700XD only)
Lights as a reminder that you 
have not released the parking 
brake lever.
12 NC700X Revision-42MGS6010.book  29 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分  
						

							30
Operation Guide
Switches
(NC700X/XA)
Engine stop switch
Should normally remain in the 
Run  position.
uIn an emergency, switch to 
the Off   position to stop 
the engine.
 Hazard switch
Switchable when  the ignition 
switch is on. Can be turned to 
off regardless of the ignition 
switch position.
u The signals continue flashing 
with the ignition switch is 
OFF or LOCK after the 
hazard switch is on.
 Start button
 Horn button
 Turn signal switch
u Pressing the switch turns 
the turn signal off.
Headlight dimmer/Passing light 
control switch
•  : High beam
•  : Low beam
•  : Flashes the high beam headlight.
12 NC700X Revision-42MGS6010.book  30 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分  
						

							31continued
Operation Guide
Steering Lock
Lock the steering when parking to help 
prevent theft.
A U-shaped wheel lock or similar device is 
also recommended.❙Locking
! a Turn the handlebar al l the way to the left.
! b Push the key down, and turn the ignition 
switch to the LOCK position.
uJiggle the handlebar if  the lock is difficult 
to engage.
! c Remove the key.
❙Unlocking
Insert the key, push it in, and turn the 
ignition switch to the OFF position.
Ignition Switch
Switches the electrical sy stem on/off, locks the 
steering.
u Key can be removed when in the OFF or LOCK 
position. ON
Turns electrical system 
on for starting/riding.
OFFTurns engine off.
LOCKLocks steering.
Push
Ignition key
!
a
!b
Turn
12 NC700X Revision-42MGS6010.book  31 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分  
						

							32
Switches (Continued)
Operation Guide
(NC700XD)
Parking brake lever and Release button
Be sure the parking brake is applied while parking and 
warming up the engine.
uMake sure the parking brake lever is released before riding.
To apply the parking brake lock
Pull the parking brake lever back to lock the rear wheel.
uBe sure the release button pops out and 
parking brake lever is not released.
u The parking brake lock will not function 
if the parking brake is not adjusted properly. 
(P81)
To release the parking brake lock
Release the parking brake lever 
by lightly pulling in the lever ( !a) 
and pressing the release button ( !b).
uBefore riding, check that the 
parking brake indicator is 
turned off and make sure 
that the parking brake is 
fully released so there is 
no drag on the rear wheel.
 Hazard switch (P30)
Headlight dimmer/
Passing light control 
switch
•  : High beam
•  : Low beam
• :
Shift up switch (+)
To shift up the gear. 
(P42)
 Turn signal switch
uPressing the switch turns 
the turn signal off.
Shift down switch (-)
To shift down the gear. 
(P42)
!a
!b
Flashes the high 
beam headlight.
12 NC700X Revision-42MGS6010.book  32 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分  
						

							33
Operation Guide
Ignition Switch
Switches the electrical system 
on/off, locks the steering.
uKey can be removed when in 
the OFF or LOCK position.
 Start button
 Horn button
N-D switch
To shift between Neutral and 
AT MODE. 
(P41)
Steering Lock: (P31)
AT/MT switch
To shift between the 
AT MODE and MT MODE. 
(P41)
Engine stop switch
Should normally remain in the 
Run  position.
uIn an emergency, switch to 
the Off   position to stop 
the engine.
12 NC700X Revision-42MGS6010.book  33 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分  
						

							34
Operation Guide
Starting the Engine
(NC700X/XA)
Start your engine using the following 
procedure, regardless of whether the engine 
is cold or warm.
!a Make sure the engine stop switch is in the 
Run  position.
! b Turn the ignition swit ch to the ON position.
! c Shift the transmission to Neutral (N indicator 
comes on). Alternatively, pull in the clutch 
lever to start your motorcycle with the 
transmission in gear  so long as the side 
stand is raised.
! d Press the start button  with the throttle 
completely closed.
If the engine does not start:
!a Open the throttle fully and press the start 
button for 5 seconds.
!b Repeat the normal starting procedure.
!c If the engine starts, ope n the throttle slightly 
if idling is unstable.
!d If the engine does not start, wait 10 seconds 
before trying steps !a  & !b  again.
❙If Engine Will Not Start (P96)
NOTICE
•If the engine does not start within 5 seconds, turn the 
ignition off and wait 10 seconds before trying to start 
the engine again for recovery of battery voltage.
• Extended fast idling and revving the engine can 
damage the engine, and the exhaust system.
• Snapping the throttle or fast  idling for more than about 
5 minutes may cause exhaust pipe discolouration.
! a
! d
! b
!
c
12 NC700X Revision-42MGS6010.book  34 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分  
						

							35
Operation Guide
continued
(NC700XD)
Start your engine using the following 
procedure, regardless of whether the engine 
is cold or warm.
NOTICE
•If the engine does not start  within 5 seconds, turn the 
ignition off and wait 10 seconds before trying to start 
the engine again for reco very of battery voltage.
• Extended fast idling and revving the engine can 
damage the engine, and the exhaust system.
• Snapping the throttle or fast idling for more than about 
5 minutes may cause exhaust pipe discolouration.
!c
!a
!d
! b
!e
! a Make sure the engine stop switch is in the 
Run  position.
! b Turn the ignition switch to the ON position.
! c Check the transmission in Neutral 
(N indicator comes on).
! d Press the start button with the throttle 
completely closed.
! e Make sure the parking brake lever is 
released before riding.
❙If Engine Does Not Start (P34)
12 NC700X Revision-42MGS6010.book  35 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分  
						

							36
Starting the Engine (Continued)
Operation Guide
When you stop the engine
!aTo stop the engine, put gear to Neutral 
(N indicator comes on).
uIf you turn the igniti on switch to the OFF 
position when the motorcycle in gear, the 
engine will shut off with the clutch 
disengaged.
!b Turn the ignition switch off.
!c Pull the parking brake lever when you park 
the motorcycle.
12 NC700X Revision-42MGS6010.book  36 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分  
						

							37continued
Operation Guide
Shifting Gears
(NC700X/XA)
Your motorcycle transmission has six forward 
gears in a one-down, five-up shift pattern.
If you put the motorcyc le in gear with the 
side stand down, the engine will shut off.
(NC700XD)
NC700XD is equipped with an automatically 
controlled 6-speed transmission. It can be 
shifted automatically (by AT MODE) or 
manually (by MT MODE).
12 NC700X Revision-42MGS6010.book  37 ページ  ２０１１年１２月１３日　火曜日　午後４時１４分