Home > Honda > Generator > Honda Eu 2000 I Owners Manual

Honda Eu 2000 I Owners Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Honda Eu 2000 I Owners Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 328 Honda manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							49
    Use a brush to remove carbon deposits from the spark arrester
    screen.
    Inspect the screen for breaks or tears and replace it if necessary.
    Check the muffler gasket; replace if damaged. Reinstall the muffler
    gasket, the spark arrester, the muffler, and the muffler protector in
    the reverse order of removal. 3.
    4.
    5.
    06/12/21 09:21:15 31Z07602_050 
    						
    							50 TRANSPORTING/STORAGE
    TRANSPORTING
    Take care not to drop or strike the generator when transporting. Do not
    place heavy objects on the generator. To prevent fuel spillage when transporting, the generator should be
    secured upright in its normal operating position, with the engine
    switch OFF and the fuel tank cap vent lever turned fully
    counterclockwise to the ‘‘OFF’’position. If the generator has been used, allow it cool for at least 15 minutes
    before loading the generator on the transport vehicle. A hot engine
    and exhaust system can burn you and can ignite some material.
    Do not lay the generator on its side when moving, storing, or
    operating it. Oil may leak and damage the engine or your property.
    06/12/21 09:21:21 31Z07602_051 
    						
    							Î
    Î
    Î
    51
    STORAGE
    STORAGE TIME RECOMMENDED SERVICE PROCEDURE TO
    PREVENT HARD STARTING Before storing the unit for an extended period:
    1. Be sure the storage area is free of excessive humidity and dust.
    2. Service according to the table below:
    Less than 1 month
    1 to 2 months
    2 to 6 months
    6 months or moreNo preparation required
    Fill with fresh gasoline and add gasoline
    stabilizer . Run the engine for 10 minutes to
    use up the non-treated gasoline.
    Fill with fresh gasoline and add gasoline
    stabilizer . Run the engine for 10 minutes to
    use up the non-treated gasoline.
    Or drain the gasoline (page 52 ).
    Drain the gasoline (page 52 ).
    Remove the spark plug. Put a tablespoon of
    engine oil into the cylinder. Turn the engine
    slowly with the starter grip to distribute the
    oil. Reinstall the spark plug.
    Change the engine oil (page 42 ).
    After removal from storage, fill with fresh
    gasoline before starting.
    Use gasoline stabilizers that are formulated to extend storage
    life. Follow the instructions included with the gasoline stabilizer.
    Contact your authorized Honda generator dealer for gasoline
    stabilizer recommendations.
    06/12/21 09:21:27 31Z07602_052 
    						
    							52
    Storage Procedure
    You can be burned or seriously injured when handling fuel. Gasoline is highly flammable and explosive.
    Keep heat, sparks, and flame away.
    Handle fuel only outdoors.
    Wipe up spills immediately.
    DRAIN SCREW
    NON-CALIFORNIA TYPE SHOWN
    Drain the gasoline.
    Unscrew the fuel tank cap, remove the debris screen, and empty
    the fuel tank into an approved gasoline container using a
    commercially available hand siphon. Reinstall the debris screen
    and the fuel tank cap.
    Loosen the cover screw and remove the maintenance cover.
    Loosen the carburetor drain screw.
    Drain the gasoline from the carburetor into a suitable container.
    Remove the spark plug maintenance cover.
    Remove the spark plug cap.
    Turn the engine switch to the ON position.
    Pull the starter grip 3 to 4 times to drain the gasoline from the fuel
    pump into a suitable container.
    Turn the engine switch to the OFF position.
    Tighten the carburetor drain screw. 1.
    a.
    b.
    c.
    d.
    e.
    f.
    g.
    h.
    i.
    j.
    06/12/21 09:21:34 31Z07602_053 
    						
    							53
    Change the engine oil (see page 42).
    Remove the spark plug, and pour about a tablespoon of clean
    engine oil into the cylinder. Crank the engine several revolutions to
    distribute the oil, then reinstall the spark plug.
    Reinstall the spark plug cap on the spark plug securely.
    Reinstall the spark plug maintenance cover.
    Reinstall the maintenance cover and tighten the cover screw
    securely.
    Pull the starter grip slowly until you feel resistance, then return the
    starter grip gently. This closes the valves so moisture cannot enter. 2.
    3.
    4.
    5.
    6.
    7.
    06/12/21 09:21:38 31Z07602_054 
    						
    							54 TROUBLESHOOTING
    When the engine will not start:
    Is there fuel in the
    tank?
    Is there enough oil
    in the engine?
    Is the spark plug in
    good condition?
    If the engine still
    does not start, take
    the generator to an
    authorized Honda
    generator dealer.Refill the fuel tank
    (see page 30).
    Add the recom-
    mended oil (see
    page 28).
    Clean, readjust gap,
    and dry the spark
    plug. Replace it if
    necessary (see
    page 46). YES
    YESNO
    NO
    YESNO
    06/12/21 09:21:43 31Z07602_055 
    						
    							55
    Appliance does not operate:
    Check the electrical ap-
    pliance or equipment for
    any defects.
    Is the DC circuit protector
    on? No electricity at the DC receptacle:Take the generator to an
    authorized Honda generator
    dealer.
    Take the generator to an
    authorized Honda generator
    dealer.
    Replace the electrical ap-
    pliance or equipment.
    Take the electrical ap-
    pliance or equipment to an
    electrical shop for repair.
    Stop and restart the engine. Is the output indicator
    light ON? (see page 13)
    Is the overload
    indicator light ON?
    (see page 13)
    Turn the DC circuit protector
    on (see page 16).
    Take the generator to an
    authorized Honda generator
    dealer. YES
    NO DEFECTS
    DEFECTS NO
    YESNO
    NO
    YES
    06/12/21 09:21:50 31Z07602_056 
    						
    							56 WIRING DIAGRAM
    06/12/21 09:22:11 31Z07602_057 
    						
    							57 INITIAL USE INSTRUCTIONS
    ADDING ENGINE OIL
    WITHOUT OIL
    Do not overfill the engine with oil.
    COVER SCREW
    MAINTENANCE COVER
    OIL FILLER CAP/DIPSTICK
    UPPER LIMIT
    The generator is shipped in the engine.
    With the generator in a level position, remove the oil filler cap/
    dipstick.
    If the engine is overfilled, the
    excess oil may be transferred to the air cleaner housing and air filter.
    Screw in the oil filler cap/dipstick securely.
    Reinstall the maintenance cover. Add enough SAE 10W-30 API service classification SJ or later (or
    equivalent) oil to bring the oil level to the upper limit of the oil filler
    neck. SAE 10W-30 oil is recommended for general use; for
    additional recommendations, see page . Loosen the cover screw and remove the maintenance cover. Place the generator on a level surface. 1.
    28 2.
    3.
    4.
    5.
    6.
    06/12/21 09:22:22 31Z07602_058 
    						
    							58
    ADDING FUEL
    Gasoline is highly flammable and explosive.
    Stop the engine and keep heat, sparks, and flame away.
    Handle fuel only outdoors.
    Wipe up spills immediately. You can be burned or seriously injured when handling fuel. This engine is certified to operate on unleaded gasoline with a pump
    octane rating of 86 or higher.
    Never use stale or contaminated gasoline or an oil/gasoline mixture.
    Avoid getting dirt or water in the fuel tank.
    If the fuel level is low, refuel in a well-ventilated area with the engine
    stopped. If the engine has been running, allow it to cool first. Never
    refuel the engine inside a building where gasoline fumes can reach
    flames or sparks.
    You may use regular unleaded gasoline containing no more than 10%
    Ethanol (E10) or 5% Methanol by volume. In addition, Methanol must
    contain cosolvents and corrosion inhibitors.
    Use of fuels with content of Ethanol or Methanol greater than shown
    above may cause starting and/or performance problems. It may also
    damage metal, rubber, and plastic parts of the fuel system.
    Engine damage or performance problems that result from using a fuel
    with percentages of Ethanol or Methanol greater than shown above
    are not covered under warranty.
    With the engine stopped, add fuel to the generator in a well-ventilated
    area.
    06/12/21 09:22:32 31Z07602_059 
    						
    All Honda manuals Comments (0)