GTE Omni Si Database Technical Practices Manual

COL.NO.
31-32
. . . .
33-34
35-36TL-130400-1001
Table 10.6
Entry Fields for Record Code TC (Continued)
COL.NAME
Dutgoing Signal
20 Trunk Group
Vumber30 Trunk Group
Vlember
lumberVALID
ENTRIES
ID 
= immediate dial
:DOD)
JllS = wink start
DD = delay dialing
SO = seize out
.- = N/A
IO-99 = the CO
:runk group
lumber assignedo a system trunk
Jroup for AIOD
a- = N/A
IO-99 = the COrunk group
nember number
Issigned to a
;yrs;lterunk group
I- = N/A
SVR 5210
8187COMMENTS
This field determines the outgoing start...

--TL-130400-1001
Table 10.6 Entry Fields for Record Code TC (Continued)
This field determines the night answer position
redetermined1 destination.
ilot number (right
-The destination can be a predetermined
pilot number or a universal night answer
position. If a UNA is used, it can be any
combination of the four UNA zones.
-If an entry of 0000-9999 is made, the
displayable COS assigned to the trunk group
(of which this trunk is a member) must allow
station access. COS for trunk groups is
2 destination....

TL-130400-1001Record Code NA:
Nailed Trunk10.7 Record Code NA, Figure 10.7, defines the permanent
connection data between trunk circuits. Information selected
Connectionincludes to and from nailed connection data.
-I
IFROMI
-:-;-T-T-t-T-t-T-t-t-T-T-~1111111111111111111
1819~0111213141516171819
, . . . It-T-t-t-T-s-t-T-s-s-T-T-T-T-T-T-T-T-T-T-T-{1212121212121212121213131313131313131313 14 Ii-11011121314151617181910111213141516171819101
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-~I III I I...

TL-130400-1001
Table 10.7 Entry Fields for Record Code NA
COL.COL.VALID
NO.NAMEENTRIESCOMMENTS
12-13Nailed00-47 = numberAssign the nailed connection trunk software
Connectionidentification number.
Identification
number 
21
14-15.: From:Trunk00-63 = trunkThis field determines the trunk group (00-63)
Groupgroup numbernumber of the from trunk.
16Fcom:PEC0.~ PEC number_This field determines the PEC number (always
0) of the from trunk.
17-19From:Trunk000-063 = trunkThis field determines the trunk number...

TL-130400-1001Record Code DA:10.8 Record Code DA, Figure 10.8, provides for the absorption
Trunk Groupof digits by the CO on a per trunk group basis. Digits are not
Digit Absorptionabsorbed but are passed over to the end office and are only
monitored by the system. These digits are used by the system to
determine the start of an NPA or toll code, which is used to
perform code restriction. The NPA or toll code must be sent
from a non-common control end office. If the end office has no
digit absorption...

 rTL-I 30400-l 001
t---------,---~----------------------‘-------‘---------I---------------------~-,III5
IIIIIII1I
DIG ACCESSSECOND PLUS
DIG ACCESS
DIG VALUE
Figure 10.8Record Code DA: Trunk Group Digit Absorption Data Sheet
Table 10.8
Entry Fields for Record Code DA
COL.NO.
12-13
14-23
24-33COL.NAMETrunk GroupFirst Digit Action
Digit 
Value:1 -0
Second PlusDigits Action
Digit Value:1 -0VALID
ENTRIES
00-63 = trunkgroup number
C = cut inA = absorb and
unlock
R = absorbrepeatedly
C = cut inA = absorb and...

TL-130400-1001
MOST11.0 This section describes the record codes required to
ECONOMICALdefine the MERS features. The following record codes
ROUTEare required:
SELECTION
l Record Code MR defines the NPA(s) requiring six-digit
analysis.
l Record Code RP defines the routing list.
. . . .SVR 5210l Record Code SI defines the trunks allowed by a specific
NPA/ABC.l Record Code TR defines the ABC codes for an NPA that
requires six-digit analysis.
l Record Code NR defines the ABC codes for an NPA that does
not...

TL-130400-1001Record Code MR:
MERS Six-Digit11.1 Record Code MR, Figure ll.lA, defines the NPA(s)
Translated NPA(Number Plan Area) that is given six-digit analysis throughMEW. This is done before calls going to the NPA(s) are routed
to outgoing trunks.
The HNPA (Home Number Plan Area) of the site must
also be included on this record code. This is because some of
the 
ABCs (or NNXs) within the HNPA will be local and will not
have a toll charge, while other 
ABCs within the HNPA will be
foreign and will...

TL-130400-I 001Table 11.1Entry Fields for Record Code MRCOMMENTS
Route Selectioncode.This number is used by the system for
identification purposes.
-The entry for 01 must be the HNPA.
Entries 02-19 are used by 
NPAs that need
six-digit analysis.
-It is recommended to list 
NPAs used in
ascending order from 2-9.
-Any NPA that requires six-digit analysis
throughMERS and is not listed on this record
-The 
NPAs must be in order. Gaps are not
allowed in the NPA numbers.
-After listing the HNPA, start with the...

- -TL-130400-1001
This diagram represents an application which can never
be used to initiate the MERS On-Net and MERS Off-Net features.
Dialed 1st Diqit of
Station Number
.  
.(Code 
?fpe 116)
Dialed 
Dl/D2 Digits
TD
NOTE: Translation Type must never
specify MRN or MRS.
Figure 11 .l BNon-MERS Application
D-222at87SVR 5210