GTE Omni Si Database Technical Practices Issue 1 Manual

TL-130500-1001____.-.-__~.----~--- -______~--
01LEFT DISPLAY CHARACTERS l-1 6RlGHT DISPLAY CHARACTERS 17-3210
4CALL32 APHANUMERIC CHARACTER DISPLAY*INITIALIZATIONN.WAlTlNGREQUESTINDICATORINDICATOR
HEP .
TLK /MONDIAL (SUPV)WAS)
D1MF KEY PAD
Figure 17.6Agent Instrument Controls and indicators
Agent Instrument17.8.1 One analog voice channel and one full-duplex,
Interfacedigital, data link channel allow each Agent Instrument to
communicate with the system. An Agent Instrument can be
optionally equipped with...

Agent Instrument17.8.2 Each Agent Instrument has five EPROM (Erasable
ControlL And
Programmable Read-Only-Memory) chips. These EPROMs
initializationcontain generic software that allows the Agent Instrument to
function in the CAS Main, ACD, or supervisory modes. If the
system includes two or more Agent Instruments, at least one of
the instruments will be equipped for supervisory functions. There
may be up to eight supervisory functions in a fully configured
system.
During system startup, the system sends...

SVR 5210 

TL-130500-1001
displayed. Manual dialing causes the digits, as entered via the
keypad, to be displayed.
EMER (Emergency) Pushbutton - Depressing the EMER
pushbutton signals the supervisor that 
anagent requiring
supervisory action on an incoming line 1 call . At the supervisory
position, this pushbutton allows the user to silence the alerting
tone and display the agent ID and type of assistance required.
(Refer to MUTE.) After depressed the EMER pushbutton, the
EMER LED flashes at 120 IPM this...

TL-130500-1001
KEDU (KEY ENTRY
18.0 The KEDU (Key Entry Display Unit) (Figure 18.1)
DISPLAY UNIT)provides control and display of Hotel/Motel features including
l Automatic wake-up service
l Room message waiting (indicator lamp) service@ Room restriction to prevent unauthorized calling
l Do not disturb service
l Room status (maid service)
l Message units metering
l Month/day/hour/minute display
A maximum of two KEDUs can connect to the system, with one
assigned as the master with extended control over the...

TL-130500-1001
DISPLAY PANEL- KEYPAD
I
LEDS
PUSHBUTTONS
Figure 18.1
KEDU (Key Entry Display Unit)
KEDUI18.1 The KEDU interfaces with the system via the SIDML (SI
System InterfaceDual Modem and Current Loop) FB-17209-A card located in a
PCMUS slot.
l The SIDML provides full-duplex, 110, 300 or 1,200 baud.
20ma, current loop data link. There are two in/out ports per
card, and each port support a KEDU or a printer
8 The system supports a maximum ,of two FB-17209-A SIDML
cards and is limited to a 
ma’ximum...

TL-130500-1001Controls,18.2 The KEDU controls, indicators, and displays (Figure 18.2)
Indicators,are listed below:
and DisplaysALM RESET. (Alarm Reset). Allows the alarm to be reset.
CLEAR. Allows the removal of data or time information from the
KEDU memory.
DATA-RESPONSE CODE. When DONT DIST, MESG METER,
MESG WTG, ROOM RSTR, or ROOM STAT functions are
requested, the LED lights, and the display indicates the
respective data and/or response code.
DONT 
DIST. (Do Not Disturb). Allows a room number to be...

TL-130500-1001ROOM NUMBER. Lights the LED and indicates the room
number (3 or 4 digits) when DON 
DIST, MESG METER, MESG
WTG, ROOM RSTR, ROOM STAT, or WAKE-UP functions are
being executed.ROOM RSTR (Room Restriction). Allows the entry of a room
number to be restricted from DOD (Direct Outside Dialing).ROOM STAT (Room Status). Allows the status of a room to be
displayed as follows: available or unavailable, occupied or
unoccupied; if maid service is needed, in progress or completed.
SECURITY LOCK....

TL-130500-1001
I  Fll F,F, ” R
e110
0.
MONTHDAYHOURMINUTERESPONSECODE
HHBB HHBH :-
ROOM0NUMBERDATA0
tt
/DISPLAY FIELDS
LED FIELD 
B0 THROUGH L
q 101
nlnnLED FIELD ALED FIELD C
lIzNEl01
LzrllicIcIKEY PAD
ALA
RESETWAKEUPMESGROOMTIMEMESGROOMDONTCLEARENTER/
METERRSTRWAITSTATDISTEXECUTE
SVR 5210Figure 18.2 KEDU Button Function8187s-251 

TL-130500-1001
S-252ala7THIS PAGE IS INTENTIONALLY LEFT BLANK.
SVR 5210