GTE Omni Si Database Technical Practices Issue 1 Manual

TL-130500-1001H/HC (HOTEL/HEALTH19.0 The H/HC printer provides hard-copy records of the
CARE) PRINTER
H/HC services. Any combination of outputs from the message
metering, room status, do not disturb, room restriction, message
waiting, and wake-up features can be obtained on the 
H/HCprinter. Each of these six features can be selectively controlled
to print whenever the feature is activated and/or deactivated (from
any authorized control point), or whenever a print command is
issued from a KEDU.
The...

TL-130500-1001Figure 19.1
Axiom Printer Used with (or without) KEDU
in Hotel/Health Care Applications
H/HC
Printer/System19.1 The printer interfaces with the system via the 
SIDML card,
located in a PCMUS slot.
Interfacel The card provides a 20ma transmit circuit to the 
H/HC printer.
l A single simplex data pair from the card supports the printer.
l The printer is slaved to the system.
NOTE: For description of the SIDML card, see paragraph 3.6.17.
Power for the 
H/HC printer typically comes from a local...

MAINTENANCE
TERMINALMaintenanceTerminal/System
InterfaceSVR 5210TL-130500-1001
20.0 The maintenance terminal records system traffic
data and system faults and provides the means for performing
data base changes and requesting maintenance procedures and
diagnostics. The system uses a TTY printer or video display
terminal as a maintenance terminal. The maintenance terminal
can be equipped with a printer when a hard-copy print-out is
required.
20.1 The maintenance terminal interfaces with the system via
one...

TL-130500-1001Terminal Types20.2 The user is required to identify the terminal(s) to be used
and Mode offor the ports of the interface card. The terminal types are
Operationentered into the data base via CPG or Recent Change. The
terminal types are listed in Table 20.1.
Table 20.6 Terminal Types
11/  2 = XT300GTE XT300
i3= LS31Lear Siegler ADM31, ADM32
S-256
/4= TELE
Televideo 900 Series
,
15 = ASGN-1Customer define j-1
6= ASGN-2Customer defined-2
‘7= TTYHard copy terminals or “DUMB” CRTs
Other...

TL-130500-1001
MDR (MESSAGE21.0 The MDR feature in the system is implemented via
DETAIL RECORDING)
software and common system hardware. The software
HARDWAREassociated with the MDR feature uses common or shared
memory.MDR Printer/21.1 The MDR printer interfaces with the system via one port
System Interface
of the FB-20992 NSDC (Narrow Serial Device Controller) card
located in slot 6 of the Get Started File.
NOTE: The NSDC card is described in paragraph 3.4.7.
The system can only support one NSDC card...

TL-130500-1001
NSDC card port 1 output is programmed to transmit data at
speeds fast enough to avoid loss of data under the heaviest
traffic conditions. The baud rates are 110, 300 and 1200. The
baud rate and other options are programmable in the 
office-dependent data base.
When selecting the speed for the output device from MDR port 0
or MDR port 1, the amount of traffic being handled by the system
must be considered. The MDR file is capable of buffering a fixed
amount of call record blocks, after...

TL-130500-1001FB-20992-A
NARROW
SERIAL
DEVICE
CONTROLLER
(NSDC)
:.
I
PORT 0--------
I1 PORT 1
20 ma LOOP+
FGTE
MODIFIED
EBCDICCOMPUTER
/
OR
< 

TL-130500-1001
Table 21.1Fujitsu GTE-Modified EBCDIC
DECIMALHEXADECIMAL
CHARACTEREQUIVALENTiO
11
2
2
3
3
44
55
66I
88BLANK 
/llALPHA a/l 2
C1100identifying character/the number 12-1 (See Note 2)
BETA 
6/l 3
EI
15II=1111/ The number 15 (See Note 2)IBINARY
EQUWALENTMDR USEThe number zero (See Note 1)
The number one
The number five
The number six
The number seven
The number eight
The number nine
The number 10 (dialed digit zero)
(See Note 1)
A blank space/identifying character/
the number 11 (See Note 2)...

SW 5210TL-130500-1001
The MDR feature is an option that provides the means for
recording call information pertaining to incoming trunk calls,
outgoing trunk calls, and trunk-to-trunk calls.
Hardware associated with the MDR feature provides the
following:
l Interface with the program and data base memory
l Interface with the buffer memory
l Interface the input/output to external equipment8l87S-261 

TL-130500-1001S-262THIS PAGE IS INTENTIONALLY LEFT BLANK.8l87SW 5210