Getnet Router GR-524WA User Manual

							 103 TCP/IP, UDP 
Transmission Control Protocol/Internet Protocol (TCP/IP) and Unreliable 
Datagram Protocol (UDP). TCP/IP is the standard protocol for data 
transmission over the Internet. Both TCP and UDP are transport layer protocol. 
TCP performs proper error detection and error recovery, and thus is reliable. 
UDP on the other hand is not reliable. They both run on top of the IP (Internet 
Protocol), a network layer protocol. 
 
TELNET 
It is the virtual terminal protocol in the Internet suite of protocols. Allows users 
of one host to log into a remote host and act as normal terminal users of that 
host. 
 
VCI 
Virtual Circuit Identifier is part of the ATM cell header. A VCI is a tag indicating 
the channel over which a cell will travel. The VCI of a cell can be changed as 
it moves between switches via Signaling. 
 
VPI 
Virtual Path Identifier is part of the ATM cell header. A VPI is a pipe for a 
number of Virtual Circuits. 
 
WAN 
Wide Area Network is a network that connects computers located in 
geographically separate areas (e.g. different buildings, cities, countries). The 
Internet is a wide area network. 
 
 
 
Web-based management Graphical User Interface (GUI) 
Many devices support a graphical user interface that is based on the web 
browser. This means the user can use the familiar Netscape or Microsoft 
Internet Explorer to Control/configure or monitor the device being managed. 
 
 
 
 
  
						

							 104
F F
e e
d d
e e
r r
a a
l l
   
C C
o o
m m
m m
u u
n n
i i
c c
a a
t t
i i
o o
n n
   
C C
o o
m m
m m
i i
s s
s s
i i
o o
n n
   
I I
n n
t t
e e
r r
f f
e e
r r
e e
n n
c c
e e
   
S S
t t
a a
t t
ee
m m
e e
n n
t t
   
   
This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of FCC Rules.  These limits are designed to 
provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses, and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful 
interference to radio communications.   
However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following 
measures:   
1. Reorient or relocate the receiving antenna. 
2. Increase the separation between the equipment and receiver. 
3. Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected. 
4. Consult the dealer or an experienced radio technician for help. 
FCC Caution 
This device and its antenna must not be co-located or operating in conjunction with 
any other antenna or transmitter. 
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions: (1) this device may not cause harmful interference, and (2) 
this device must accept any interference received, including interference that may 
cause undesired operation. 
 Any changes or modifications not expressly approved by the party responsible for 
compliance could void the authority to operate equipment. 
Federal Communications Commission (FCC) Radiation Exposure Statement 
This equipment must be installed and operated in accordance with provided 
instructions and a minimum 20 cm spacing must be provided between computer 
mounted antenna and person’s body (excluding extremities of hands, wrist and feet) 
during wireless modes of operation.  
 The equipment version marketed in US is restricted to usage of the channels 1-11 
only. 
R&TTE Compliance Statement 
This equipment complies with all the requirements of DIRECTIVE 1999/5/EC OF 
THE EUROPEAN PARLIAMENT AND THE COUNCIL of March 9, 1999 on radio 
equipment and telecommunication terminal Equipment and the mutual recognition of 
their conformity (R&TTE) 
The R&TTE Directive repeals and replaces in the directive 98/13/EEC 
(Telecommunications Terminal Equipment and Satellite Earth Station Equipment) As 
of April 8, 2000. 
Safety 
This equipment is designed with the utmost care for the safety of those who install 
and use it. However, special attention must be paid to the dangers of electric shock 
and static electricity when working with electrical equipment. All guidelines of this and 
of the computer manufacture must therefore be allowed at all times to ensure the 
safe use of the equipment. 
EU Countries Intended for Use  
The ETSI version of this device is intended for home and office use in Austria, 
Belgium, Denmark, Finland, France, Germany, Greece, Ireland, Italy, Luxembourg, 
Bulgaria, Cyprus, Czech Republic, Estonia, Hungary, Latvia, Lithuania, Malta, Poland, 
Romania, Slovakia, Slovenia, the Netherlands, Portugal, Spain, Sweden, and the 
United Kingdom. 
The ETSI version of this device is also authorized for use in EFTA member states: 
Iceland, Liechtenstein, Norway, and Switzerland. 
EU Countries not intended for use   
						

							 105
None 
A declaration of conformity is available on www.getnet.com.tw
 
 
 
N2037 
						

							 106