Faroudja Fdp-Dila1 Installation And Operations Manual
Here you can view all the pages of manual Faroudja Fdp-Dila1 Installation And Operations Manual. The Faroudja manuals for Projector are available online for free. You can easily download all the documents as PDF.
Page 51
51 ENGLISH Cleaning and Replacing the Filter Clean the filter periodically. If the filter is heavily stained and does not get clean, or if it is d\ amaged, replace the filter with a new filter (part No.: LC30208). Otherwise, dirt may get inside \ and appear on the screen, possibly preventing you from enjoying the video image fully. If dirt gets inside or if you need information about the filter, consult your Faroudja dealer where you have purchased the projector or Faroujda service. 1Turn off the MAIN...
Page 52
52 Troubleshooting Solutions to common problems related to your projector are described her\ e. If none of the solutions presented here solves the problem, unplug the projector and consult a Faroudja-authorized dealer or Faroudja service. Symptom Probable cause Corrective action Page Power is not supplied. Light is not emitted, or light level is low. With power on, operation starts but stops in a few minutes. Video image does not appear, or audio sound does not occur. Video image dims. Color is poor or...
Page 53
53 ENGLISH * This projector is equipped with a microcomputer that may operate abnorma\ lly due to interference from external components.If this happens, turn off the main power and disconnect the power cord from the wall AC outlet. Then reconnect the power cord to AC outlet and turn on the main power again. (For the turning on and off the power, see pages 25 to 26.) Symptom Probable cause Corrective action Page The upper part of the video image bows or distorts. Video image and audio sound suddenly go...
Page 54
54 Specifications Optical mechanism system ¥ Projection method 3D-ILA device, 1 lens, 3 primary color optical shutter method ¥ D-ILA device 0.9 measured diagonally (1365 ´1024 pixels) ´ 3 (Total number of pixels : 4,193,280) ¥ Projecting lens Electric-driven zoom of 1.5 ´ ¥ Screen size 42 to 300 [recommended] to 521 [maximum] measured diagonally (*with aspect ratio : 4 : 3) ¥ Light-source lamp 420 W xenon lamp Electrical system ¥ Color system NTSC, NTSC4.43, PAL, SECAM (* Automatic switching / manual...
Page 55
55 ENGLISH Horizontal sync/composite sync signal (H/Cs) H : 1 to 5Vp-p, high impedance (positive/negative polarity) Cs : 1 to 5Vp-p, high impedance (positive/negative polarity) Vertical sync signal (V) V : 1 to 5Vp-p, high impedance (positive/negative polarity) * Some connected devices may not correspond to composite sync (Cs) or \ G on sync signal. ¥ AUDIO 1-line, stereo mini-jack ´ 1 (For COMPUTER IN-2) 0.5Vrms, high impedance [COMPUTER OUT (COMPUTER OUTPUT)] ¥ COMPUTER OUT 1-line, D-sub 3-row 15-pin...
Page 56
56 Specifications (Cont.) Outside dimensions nTo p nFrontnSide STAND BY LAMP TEMP EMERGENCY VIDEO COMPUTER SETTING QUICK ALIGN -2+3 16-3/4 (425)*1 5-1/4 (133)*1 (f104) 13- 3/8 (339) 14-7/8 (375) 8-1/8 (205)*1 6-5/8 (168)16- 3/4 (425)*1 14-1/4 (361)14- 7/8 (375) 9- 1/8 (231) 2-1/4 (55.5) 7-3/8 (187) 7- 5/8 (193) 9- 3/8 (246) 1- 5/8 (41)9- 3/8 (246) Unit: Inch (mm) *1: Protrusion excluded f4-1/8 DTV-format signals * The following are DTV-format signals that can be input. DTV-Formats 480i 480p 720p 1080i...
Page 57
57 ENGLISH nRS-232C terminal n COMPUTER IN-1 (PC) / COMPUTER OUT Terminal Pin number Signal name 1 N/C 2RD 3TD 4 N/C 5 GND Pin number Signal name 6 N/C 7 N/C 8 N/C 9 N/C Pin number Signal name 1 Red 2 Green 3 Blue 4 N/C 5 N/C 6 GND (Red) 7 GND (Green) 8 GND (Blue) Pin number Signal name 9 N/C 10 GND (SYNC) 11 GND 12 N/C 13 H.SYNC 14 V.SYNC 15 N/C Specifications (Cont.) 2 3 4 5 6 7 1 8 9 1 23 4 5 6 7 8 9 10 11 12 13 14 15 Pin assignment (Specifications for terminals) n Y/C terminal Pin number Signal name...
Page 58
WARRANTY LIMITED WARRANTY Faroudja Laboratories, Inc. (Faroudja) warrants that its products will be free of defects in workmanship and material and conform substantially to published specifications under normal use and service. This warranty is made to the first purchaser of the products and extends for twelve (12) months from the date of sale. The warranty for the light source lamp is 90 days. The warranty does not apply to products damaged as a result of accident, misuse, neglect, alteration,...