Epson Xp 202 Manual

1. Slide out the output tray.
2.
Slide the edge guides to adjust to the paper size you want to use.
3. Insert the paper with the printable side facing down until the printer partially pulls in the paper.
cImportant:
❏Load paper short edge 
first. However, when you have set the long edge as the width of the user 
defined size,
load paper long edge first.
❏Keep the paper straight to prevent it from being fed askew.
Note:
If the printer does not pull in the paper, load it again.
Related Information
&“Paper...

&“Available Paper and Capacities” on page 42
Loading Envelopes and Precautions
Envelopes can only be loaded in the rear paper feed. Load envelopes short edge first at the center with the flap
facing down, and slide the edge guides to the edges of the envelopes.
❏Fan and align the edges of the envelopes before loading. When the stacked envelopes are 
puffed up with air,
press them down to flatten them before loading.
❏Do not use envelopes that are curled or folded. Using these envelopes causes paper jams...

Related Information
&“List of Paper Types” on page 45 User's Guide
Loading Paper
53 

Placing Originals
Place originals on the scanner glass or the ADF. Use the scanner glass for originals that the ADF does not support.
You can scan multiple originals and both sides of the originals at the same time with the ADF.
Available Originals for the ADF
Available Paper Sizes A6 landscape/A5 to Ledger (Maximum 297 × 431.8 mm)
Paper Type Plain paper
Paper Thickness (Weight of Paper) 52 to 105 g/m2
Loading Capacity 50 sheets or 5 mm
To prevent paper jams, avoid placing the following originals in the...

3. Place the originals in the center of the ADF, facing up.
cImportant:
Do not load originals above the line just under the 
d symbol inside the ADF edge guide.
Note:
You can place originals smaller than A4 size with the long edge facing toward the ADF.
4. Slide the ADF edge guides to the edges of the originals.
The size of the originals is automatically detected.
Note:
Some sizes may not be automatically detected. In this situation, manually select the size of the originals.
Related Information...

Placing Originals on the Scanner Glass
!Caution:
Be careful not to trap your 
fingers when closing the document cover. Otherwise you may be injured.
cImportant:
When placing bulky originals such as books, prevent exterior light from shining directly onto the scanner glass.
1. Open the document cover.
2. Remove any dust or stains on the scanner glass.
3. Place the original face-down and slide it to the corner mark.
User's Guide
Placing Originals
56 

Note:
❏A range of 1.5 mm from the edges of the scanner glass is not scanned.
❏When originals are placed in the ADF and on the scanner glass, priority is given to the originals in the ADF.
4. Close the cover gently.
The size of the originals is automatically detected.
Note:
❏Some sizes may not be automatically detected. In this situation, manually select the size of the originals.
❏Remove the originals after scanning or copying. If you leave the originals on the scanner glass for a long time, they
may...

Managing Contacts
Registering a contacts list allows you to easily enter destinations. You can register up to 200 entries, and you can
use the contacts list when you enter a fax number, enter a destination for attaching a scanned image to an email,
and saving a scanned image to a network folder.
You can also register contacts in the LDAP server. See the Administrator's Guide to register contacts in the LDAP
server.
Registering Contacts
1. Select Contacts from the home screen, the Scan mode, or the...

5. Enter Name and Index Word, and then press Proceed.
6. Press the check box of the contacts that you want to register in the group.
Note:
❏You can register up to 199 contacts.
❏To deselect, press the check box of the contact again.
7.
Press Save.
Note:
To edit or delete a grouped contact, select the target grouped contact and press Edit or Delete.
Registration and Backup of Contacts Using a
Computer
You can register and backup contacts on the printer using EpsonNet Config. See the manual of EpsonNet...

Printing
Printing from the Control Panel
You can print data stored on a memory device, such as a USB flash drive, directly.
1. Load paper in the printer.
2. Insert a memory device into the printer's external interface USB port.
3. Enter Memor y Device from the home screen.
4. Select a file format.
Note:
If you have more than 999 images on your memory device, images are automatically divided into groups and the group
selection screen is displayed. Select the group that contains the image you want to...