Epson Projector Emp 30 User Manual

Printed in Japan
402534100
02.07-.5A(C05)
E 

About the Manuals and Notations Used
The documentation for your EPSON projector is divided into the following four manuals. Refer to the 
manuals in the order given below.
Unpacking and Installation Guide
This manual contains information on the procedures from unpacking the projector through to starting to use the 
projector, and also describes the included accessories.
Safety Instructions/World-Wide Warranty Terms
This manual contains information on using the projector safely, and also includes safety...

1
Contents
Features of the Projector ......................................................................................... 2
Basic Operations
Turning On the Projector .......................................................................................... 6
Connecting the Power Cable........................................................................................... 6
Turning On the Power and Projecting Images ................................................................ 7
Turning Off the...

2
Features of the Projector
Keystone distortion in projected images can be 
corrected easily. 
This makes images appear correctly even when 
the projector has been set up on a tilted vertical 
angle. (p.13)
Cinema filter function
You can boost the quality of films by attaching the cinema filter that is supplied 
with the projector and then changing the Cinema Filter setting in the Video 
menu to ON. This automatically causes video images such as films to be 
projected at the optimum tint.
Automatic setup...

3 

5
Basic 
Operations
This chapter describes basic operations such as turning 
projection on and off and adjusting the projected images.
Turning On the Projector ................................... 6
•
•• •Connecting the Power Cable .............................................. 6
•
•• •Turning On the Power and Projecting Images.................. 7
Turning Off the Projector ................................... 9
Adjusting the Screen Image ............................ 11
•
•• •Adjusting the Image Size...

6
Turning On the Projector
This section describes the procedure from turning on the power to projecting images.
Procedure
1Check that the power is turned off for 
the projector and all components 
connected to the projector.
2Connect the  video source or computer 
to the projector. (
Setup Guide)
3
Remove the lens cover.
4Connect the accessory power cable to 
the projector.
Check that the power cable connector is facing 
the same way as the power inlet on the projector, 
and then insert the power cable...

7
Basic Operations
Procedure
1
Turn on the power for all equipment 
connected to the projector.
For a video source, press the [Play] button at the 
video source to start playback if necessary.
Check that the Power indicator has stopped 
flashing and is lit orange.
2Press the [Power] button on either the 
projectors control panel or the remote 
control to turn on the power for the 
projector.
The Power indicator flashes green, and after a 
short period it stops flashing and projection starts.
Wait until...

Turning On the Projector
8
•
•• •If only one signal source has been connected, the signals from that source will be 
projected without needing to press one of the buttons from the previous table.
•
•• •If the No-Signal. message does not disappear, check the connections again.
•
•• •If a laptop computer or a computer with an LCD screen has been connected to the 
projector, the images may not be projected straight away. After making the connections, 
check that the computer has been set up to output...