Epson Projector BrightLink Pro 1430Wi User Manual

							Lamp life
Normal Power Consumption mode:
Up to about 4000 hours
ECO Power Consumption mode:
Up to about 6000 hours
Note: Turn off this product when not in use to prolong the life of the projector. Lamp life will vary
depending upon mode selected, environmental conditions, and usage. Brightness decreases over time.
Parent topic: Technical Specifications
Remote Control Specifications Reception range 19.7 feet (6 m)
Batteries Two alkaline or manganese AA
Parent topic: Technical Specifications
Interactive Pen Specifications Batteries One AA alkaline
Size 6.3 inches (161 mm) long; diameter 0.94 inches (24 mm)
Weight 1.06 oz (30 g), excluding the battery
Parent topic: Technical Specifications
Touch Unit Specifications The Touch Unit comes only with the BrightLink Pro 1430Wi.
Technology Infrared Laser (Class 1)
Dimensions Height: 3.7 inches (95 mm)
Width: 8.2 inches (207 mm)
Depth: 2 inches (51 mm)
Weight 15.9 oz (450 g)
301 
						

							Parent topic:
Technical Specifications
Projector Dimension Specifications Height(excluding feet) 6.1 inches (155 mm)
Width 14.4 inches (367 mm)
Depth 14.8 inches (375 mm)
Weight 12.3 lb (5.6 kg)
Parent topic: Technical Specifications
Projector Electrical Specifications Rated frequency 50/60 Hz
Power supply 100 to 240 VAC ±10%
3.8 to 1.7 A
Power consumption Operating:
(100 to 120 V) Normal Power Consumption mode: 384 W
ECO Power Consumption mode: 288 W
Standby:
0.31 W (Communication Off), 2.4 W (Communication On)
Power consumption Operating:
(220 to 240 V) Normal Power Consumption mode: 365 W
ECO Power Consumption mode: 274 W
Standby:
0.42 W (Communication Off), 2.5 W (Communication On)
Parent topic: Technical Specifications
302 
						

							Projector Environmental Specifications
Temperature Operating:
Up to 4921 feet (1500 m): 41 to 95 °F (5 to 35 °C)
4921 feet (1500 m) to 9843 feet (3000 m) : 41 to 86 °F (5 to 30 °C)
Storage: 14 to 140 °F (–10 to 60 °C)
Humidity (relative, non- Operating: 20 to 80%
condensing) Storage: 10 to 90%
Operating altitude Up to 4921 feet (1500 m)
Up to 9843 feet (3000 m) with High Altitude Mode enabled
Parent topic: Technical Specifications
Projector Safety and Approvals Specifications United States FCC Part 15 Class B (DoC)
UL60950-1 2nd edition (cTUVus Mark)
Canada ICES-003 Class B
CSA C22.2 No. 60950-1
Parent topic: Technical Specifications
Supported Video Display Formats For best results, your computers monitor port or video card resolution should be set to display in the
projectors native resolution. However, your projector includes Epsons SizeWise chip that supports other
computer display resolutions, so your image will be resized to fit automatically.
Your computers monitor port or video card refresh rate (vertical frequency) must be compatible with the
projector. (See your computer or video card manual for details.)
The table here lists the compatible refresh rate and resolution for each compatible video display format.
Display format Refresh rate (in Hz)Resolution (in pixels)
Computer signals (analog RGB)
303 
						

							Display format
Refresh rate (in Hz)Resolution (in pixels)
VGA 60/72/75/85640 × 480
SVGA 56/60/72/75/85800 × 600
XGA 60/70/75/851024 × 768
WXGA 601280 × 768
60 1366 × 768
60/75/85 1280 × 800
WXGA+ 60/75/851440 × 900
WXGA++ 601600 × 900
SXGA 70/75/851152 × 864
60/75/85 1280 × 1024
60/75/85 1280 × 960
SXGA+ 60/751400 × 1050
WSXGA+* 601680 × 1050
UXGA 601600 × 1200
MAC13 67640 × 480
MAC16 75832 × 624
MAC19 751024 × 768
59 1024 × 768
MAC21 751152 × 870
Composite video
TV (NTSC) 60720 × 480
TV (SECAM) 50720 × 576
TV (PAL) 50/60720 × 576
Component video
SDTV (480i) 60720 × 480
SDTV (576i) 50720 × 576
304 
						

							Display format
Refresh rate (in Hz)Resolution (in pixels)
SDTV (480p) 60720 × 480
SDTV (576p) 50720 × 576
HDTV (720p) 50/601280 × 720
HDTV (1080i) 50/601920 × 1080
HDMI input signals
VGA 60640 × 480
SVGA 60800 × 600
XGA 601024 × 768
WXGA 601280 × 800
60 1366 × 768
WXGA+ 601440 × 900
WXGA++ 601600 × 900
WSXGA+ 601680 × 1050
SXGA 601280 × 960
60 1280 × 1024
SXGA+ 601400 × 1050
UXGA 601600 × 1200
SDTV (480i/480p) 60720 × 480
SDTV (576i/576p) 50720 × 576
HDTV (720p) 50/601280 × 720
HDTV (1080i) 50/601920 × 1080
HDTV (1080p) 24/30/50/601920 × 1080
MHL input signals
VGA 60640 × 480
SDTV (480i/480p) 60720 × 480
SDTV (576i/576p) 50720 × 576
305 
						

							Display format
Refresh rate (in Hz)Resolution (in pixels)
HDTV (720p) 50/601280 × 720
HDTV (1080i) 50/601920 × 1080
HDTV (1080p) 24/301920 × 1080
* Wide resolution only
Parent topic: Technical Specifications
USB Display System Requirements Your computer system must meet the system requirements here to use the projectors USB Display
software.
Requirement Windows Mac
Operating system Windows XP Professional, Home OS X 10.5.x (32-bit), and 10.6.x, Edition, and Tablet PC Edition (32-bit) 10.7.x , 10.8.x, 10.9.x (32- and 64- bit)
Windows Vista Ultimate, Enterprise,
Business, Home Premium, and Home
Basic (32-bit)
Windows 7 Ultimate, Enterprise,
Professional, and Home Premium (32-
and 64-bit); Home Basic and Starter (32-
bit)
Windows 8.x, Pro, and Enterprise (32-
and 64-bit)
USB version USB 1.1 and above (USB 2.0 recommended)
CPU Mobile Pentium III 1.2 GHz or faster Power PC G4 1 GHz or faster (Core
(1.6 GHz or faster recommended) Duo 1.83 GHz or faster
recommended)
Memory 256MB or more (512MB or more 512MB or more
recommended)
Hard disk space 20MB or more
Display Resolution between 640 × 480 and 1600 × 1200, 16-bit color or greater
306 
						

							Parent topic:
Technical Specifications
Related references
Projector Setup Settings - Extended Menu
307 
						

							Notices
Check these sections for important notices about your projector.
Recycling
Important Safety Information
Important Safety Instructions
FCC Compliance Statement
Wireless Telegraphy Act Regulations
Trademarks
Open Source Software License
Copyright Notice
Recycling Epson offers a recycling program for end of life products. Please go to epson.com/recyclefor information
on how to return your products for proper disposal.
Parent topic: Notices
Important Safety Information Caution:Never look into the projector lens when the lamp is turned on; the bright light can damage your
eyes. Never let children look into the lens when it is on. Never open any cover on the projector, except
the lamp and filter covers. Dangerous electrical voltages inside the projector can severely injure you.
Except as specifically explained in this Users Guide, do not attempt to service this product yourself.
Refer all servicing to qualified service personnel.
Warning: The projector and its accessories come packaged in plastic bags. Keep plastic bags away
from small children to avoid any risk of suffocation.
Caution: When you replace the lamp, never touch the new lamp with your bare hands; the invisible
residue left by the oil on your hands may shorten the lamp life. Use a cloth or glove to handle the new
lamp.
Parent topic: Notices
308 
						

							Important Safety Instructions
Follow these safety instructions when setting up and using the projector:
• Do not look into the lens when the projector is on. The bright light can damage your eyes. Avoidstanding in front of the projector so the bright light does not shine into your eyes.
• Do not place the projector on an unstable cart, stand, or table.
• Do not operate the projector on its side, or while tilted to one side. Do not tilt the projector more than 3° forward or back.
• If the projector is mounted on a ceiling or wall, it should be installed by qualified technicians using mounting hardware designed for use with this projector.
• When installing or adjusting a ceiling or wall mount, do not use adhesives to prevent the screws from loosening and do not use oils or lubricants. This may cause the projector case to crack and the
projector to fall from its ceiling mount. This could cause serious injury to anyone under the mount and
could damage the projector.
• Do not use the projector near water, sources of heat, high-voltage electrical wires, or sources of magnetic fields.
• Use the type of power source indicated on the projector. Use of a different power source may result in fire or electric shock. If you are not sure of the power available, consult your dealer or power company.
• Place the projector near a wall outlet where the plug can be easily unplugged.
• Take the following precautions when handling the plug: Do not hold the plug with wet hands. Do not insert the plug into a dusty outlet. Insert the plug firmly into the outlet. Do not pull the power cord when
disconnecting the plug; always be sure to hold the plug when disconnecting it. Do not overload wall
outlets, extension cords, or power strips. Failure to comply with these precautions could result in fire or
electric shock.
• Do not place the projector where the cord can be walked on. This may result in fraying or damage to the plug.
• Unplug the projector from the wall outlet before cleaning. Use a dry cloth (or, for stubborn dirt or stains, a moist cloth that has been wrung dry) for cleaning. Do not use liquid or aerosol cleaners, any
sprays containing flammable gas, or solvents such as alcohol, paint thinner, or benzine.
• Do not block the slots and openings in the projector case. They provide ventilation and prevent the projector from overheating. Do not operate the projector on a sofa, rug, or other soft surface, or set it
on top of loose papers. Do not cover the projector with a blanket, curtain, or tablecloth. If you are
setting up the projector near a wall, leave at least 7.9 inches (20 cm) of space between the wall and
the air exhaust vent.
• Do not operate the projector in a closed-in cabinet unless proper ventilation is provided.
309 
						

							• Never allow objects of any kind to enter any openings in the projector. Do not leave objects, especially
flammable objects, near the projector. Never spill liquid of any kind into the projector.
• If you are using two or more projectors side-by-side, leave at least 2 feet (60 cm) of space between the projectors to allow for proper ventilation.
• You may need to clean the air filter and vent. A clogged air filter or vent can block ventilation needed to cool the projector. Do not use canned air, or the gases may leave a residue.
• Do not store the projector outdoors for an extended length of time.
• Except as specifically explained in this manual, do not attempt to service this product yourself. Refer all servicing to qualified personnel. Opening or removing covers may expose you to dangerous
voltages and other hazards.
• Never open any covers on the projector except as specifically explained in this manual. Never attempt to disassemble or modify the projector. Refer all repairs to qualified service personnel.
• Unplug the projector from the wall outlet and refer servicing to qualified service personnel under the following conditions: if it does not operate normally when you follow the operating instructions, or
exhibits a distinct change in performance; if smoke, strange odors, or strange noises come from the
projector; if the power cord or plug is damaged or frayed; if liquid or foreign objects get inside the
projector, or if it has been exposed to rain or water; if it has been dropped or the housing has been
damaged.
• Do not touch the plug during an electrical storm. Otherwise, you may receive an electric shock.
• Unplug the projector when it will not be used for extended periods.
• Do not use the projector where it may be exposed to rain, water, or excessive humidity.
• Do not use or store the projector where it may be exposed to smoke, steam, corrosive gases, excessive dust, vibration, or shock.
• Do not use the projector where flammable or explosive gases may be present.
• Do not use or store the projector or remote control in a hot location, such as near a heater, in direct sunlight, or in a closed vehicle.
• If you use the projector in a country other than where you purchased it, use the correct power cord for that country.
• Do not stand on the projector or place heavy objects on it.
• Do not use the projector outside of the required temperature range of 41 to 95 °F (5 to 35 °C) at an altitude of 4921 feet (1500 m) or less, or 41 to 86 °F (5 to 30 °C) at a higher altitude. Doing so may
cause an unstable display and could lead to projector damage. Do not use or store the projector where
it may be exposed to sudden changes in temperature.
310