Epson Powerlite S1+ Users Guide

11
Remote Control Before using the Remote ControlRemove the insulating tape.Using the Remote ControlOperate the remote control by aiming it at the remote control infrared receiver 
on the projector.
Operating range Operable distance:  Max. approximately 20 feet (6 m)
(May be shorter depending on conditions.)
Operable angle: approximately 30° horizontally, 15° vertically
* The remote control infrared receiver on the back of the projector can also be 
used under the same conditions.StorageWhen not using...

12
Installation InstallationInstallation methodSet up the projector so that it is at right angles to a screen.
Projection distance and screen size 
c
Be sure to read the Important Safety Instructions
 before installation.
p
When setting up the projector against a wall, leave a space of at least 
7.9 inches (20 cm) between the projector and the wall.
Projection distance:
3-34 feet
(89-1050 cm)
7.9 inches (20 cm) or more
90°
Center of 
lens
Distance from center of lens 
to bottom edge of screen
Distance...

13
Installation Other installation methodsRear projection(Using a translucent screen)Ceiling projectionCeiling/Rear projection
(Using a translucent screen)
The optional ceiling mount is required when installing the projector from a 
ceiling. Please contact your dealer if you wish to use this method, as special 
equipment is required for installation. See “
Optional Accessories
” on page 60
.
p
When using rear projection, or projecting from a ceiling, select the 
appropriate mode in the “Setting” 
→...

14
Connecting to a Computer Connecting to a Computer Compatible computersCondition 1: Check that the computer has an image output port, such as an 
RGB port, monitor port or CRT port.
Some computers with a built-in monitor and some notebook computers may 
not be compatible. Please refer to your computer manual for further details.
Condition 2: The display frequency and resolution of the computer must 
correspond to that of the projector. See “
Supported Display Resolutions
” on 
page 64
.
Notebook...

15
Connecting to a Computer When using a 5BNC port
When using a 13w3 port
Playing sound from a computerYou can play sound from a computer through the projector’s built-in speaker.Volume adjustmentPress [l] or [r] on the remote control.
You can also adjust the volume from the configuration menu.
([Menu] button → “Setting” → “Volume”) See “
Setting menu
” on page 39
.
p
 Select “Computer” in the “Image” 
→
 “Input signal” configuration 
menu. See “
Image menu
” on page 36
. 
 Do not bind the power cable...

16
Connecting to a Computer Connecting to an external monitorThe image being input into the projector can be displayed on a computer 
monitor.
Presentation Remote ControlYou can use the presentation remote control as a wireless mouse to control 
the mouse pointer on the computer screen.The presentation remote contains 
all the functions necessary for giving a presentation. Functions include: Page 
Up/Page Down, Left/Right mouse click, A/V mute, freeze, and mouse pointer. Compatible computersWindows
:...

17
Connecting to a Computer Installing the driver for WindowsScreen contents will differ according to the version of Windows you are using. 
This explanation uses screenshots taken from Windows 98.
Driver installation is not required for the Macintosh.
1Connect the accessory Presentation Remote Receiver to the USB 
port of the computer.
The “Add New Hardware” wizard is displayed.
Under normal circumstances, maintain the default settings and click 
“Next” to proceed.
2Click “Next.”3Keeping the defaults,...

18
Connecting to a Computer 
5Click on “Next” to confirm the message which is displayed.
6Click on “Finish.”
The installation of the driver is complete.p
The driver installation screen is displayed a second time.
(The presentation remote control driver has two parts; the mouse driver 
and the keyboard driver.) Follow the on-screen instructions to complete the 
installation.  

19
Connecting to a Computer Part Names and FunctionsOperate the presentation remote control by aiming it at the presentation remote receiver.
When using the Freeze or A/V Mute functions, aim the presentation remote control towards the remote control infrared receiver of the projector.[L Click] button
Acts as a mouse left-click.
[Freeze] button 
Keeps the current computer or 
video image on the screen. [Page Up] / [Page Down] buttons
Press these buttons to scroll back and forth 
through pages when...

20
Connecting to Video Equipment Operating range Operable distance: Maximum approximately 20 feet (6 m) 
(may be shorter depending on conditions)
Operable angle:      Approximately 30° horizontally, 15° verticallyConnecting to Video Equipment
Projecting video imagesFor Composite Video (DVD, VHS, Video games)
For S-Video (DVD, VHS, Video games)
c
When connecting, be sure to:
 Turn off the power for both the projector and the video equipment.
Damage may result if you try to make a connection when the...