Epson Emp Monitor V4.22 User Manual

30
Setting the mail notification functionThe mail notification function can be used to send corresponding notification 
messages to a preset e-mail address when a projector that is connected to the 
network assumes a certain status, or if it experiences a problem or warning. By 
using this function, the operator can be notified of a projectors status or 
problems even when the operator is in a different location from the projectors.
PROCEDURE
Select Mail notification function from the Tool 
menu.
The Set...

31
Setting the mail notification function
Click [Notification event] and check the items for mail 
notification in the window that appears.Click [OK].
When the Set mail notification function window appears 
again, repeat Steps 3 and 4 to set the events to be notified.
When the setup is complete, click [OK].
34
5 

32
An e-mail notifying the operator of a problem/warning/status is issued
If the projector experiences a problem or enters a status requiring attention, 
an e-mail like that shown below is  sent to the address specified for 
Recipient mail address.
If there is more than one problem , warning, or status, the corresponding 
messages are output to separate lines.
The details contained in the e-mail m essage can consist of the following.
Messages to inform that the projector has recovered from the error or...

33
Application lock functionYou can use the application lock to prevent third parties from operating the 
projectors using EMP Monitor and from changing settings without authority. 
Opening and closing EMP Monitor and status monitoring can still be carried 
out even when the application lock is applied.
In addition, when a password has been set, the password must be entered in 
order to cancel the application lock. This ensures that the application lock can 
not be easily cancelled, and thus improves...

34
TroubleshootingProjectors cannot be monitored or controlled An e-mail message is not sent when a problem 
occurs with a projector
Cause
Remedy
Is the projector connected to 
the network correctly?
Connect the network cable correctly. 
sNetwork Cable Connections in the 
projectors  Users Guide
Has the projector been set 
up correctly for connection 
to the network?
Check the settings for the Network 
configuration menu command.
sProjectors  Users Guide
Has EMP Monitor been 
installed on the computer...

35
All rights reserved. No part of this publication may be reproduced, 
stored in a retrieval system, or transmitted in any form or by any means, 
electronic, mechanical, photocopying, recording, or otherwise, without 
the prior written permission of Seiko Epson Corporation. No patent 
liability is assumed with respect to the use of the information contained 
herein. Neither is any liability assumed for damages resulting from the 
use of the information contained herein.
Neither Seiko Epson Corporation...