Epson C3900 Manual

Error Messages (Warning)
This message... means... do this...
AUTH TIMEOUTThe user is automatically logged
off due to IEEE802.1X port
authentication.Reauthorize the IEEE802.1X port, and
then log on.
DEVICE 
NOT SUPPORTEDAn incompatible device is
connected.Do not connect an incompatible
device.
FUSER UNIT 
END OF LIFEThe fuser unit has reached the
end of its life.Replace the fuser unit and reset the
counter in the MAINTENANCE MENU/
SUPPLIES/REPLACE/FUSER UNIT
menu.
Note:
Printing can continue, however,...

This message... means... do this...
PAPER EMPTY  
TRAY XTray X (Tray 1, 2 or 3) is empty.
(Appears when SYS DEFAULT
MENU/ENABLE WARNING/PAPER
EMPTY/TRAY X is set to ON.)Load media into the specified tray.
Tray X ( T r a y  2  o r  3 )  i s  n o t  c o r r e c t l y
installed. 
(Appears when SYS DEFAULT
MENU/ENABLE WARNING/PAPER
EMPTY/TRAY X is set to ON.)Correctly install the specified tray.
PORT AUTH 
ACTIVEIEEE802.1X port is processing. Please wait until authentication
processing is completed.
REPLACE...

This message... means... do this...
COVER OPEN 
SIDE COVERThe printer’s right side cover is
open.Close the right side cover.
COVER OPEN 
TRAY3 COVERThe right side cover of Tray 3 is
open.Close the right side cover of the tray.
HOLD JOB ERROR 
UNABLE TO  
STORE JOBThe specified print job saved on
the hard disk is sent while the
hard disk is not installed.Print jobs can be saved only if a hard
disk is installed. If desired, install a
hard disk.
HOLD JOB ERROR 
“OPTIONAL” 
PRESS CANCELWhen printing a stored...

This message... means... do this...
PAPER ERROR 
“SIZE” 
“MEDIA”The media size/type set in the
printer driver is different from the
size/type of media loaded
(Appears when PAPER MENU/
PAPER SOURCE/TRAY CHAINING
is set.)Load the correct media size and type.
PAPER JAM 
DUPLEX1Media has misfed in the duplex. Press the 
 key to display the help
screen. Follow the instructions in the
help screen to remove the misfed
media. PAPER JAM 
DUPLEX2Media has misfed in the duplex.
PAPER JAM 
SECOND TRANSMedia has...

This message... means... do this...
TRAYX PAPER ERR 
“SIZE” 
“MEDIA”The media size/type set in the
printer driver is different from the
size/type of media loaded. This
message appears when the
PAPER MENU/PAPER SOURCE/
TRAY CHAINING menu is set to
OFF.Load the correct media size and type.
TRAYX SIZE ERR 
ADD 
“SIZE”The media size set in the printer
driver is different from the size of
media loaded.Load the correct media size into the
specified tray.
WASTE TONER FULL 
REPLACE BOTTLEThe waste toner 
bottle...

Chapter 9
Installing Accessories
Introduction
Note:
Use of accessories not manufactured or supported by Epson will void your warranty.
Dual In-Line Memory Module
(DIMM)512 MB DIMM
500-Sheet Paper Cassette Unit
(Tray 3)500-sheet tray included
Hard Disk DriveSATA Hard Disk
Note:
❏Installing accessories always requires that the printer and accessories are turned off and unplugged
during installation.
❏This printer does not support CompactFlash card.
Antistatic Protection
Note:
It’s very important to protect...

Dual In-Line Memory Module (DIMM)
Note:
You may need additional memory (DIMM) for complex graphics and for duplex (double-sided)
printing.
This machine detects only half of the amount of the installed memory.
Dual in-line memory module (or DIMM) is compact circuit board with surface-mount memory
chips.
There is 256 MB of onboard memory and one available memory expansion slot. The memory can be
expanded to a maximum of 768 MB (256 MB + 512 MB).
Installing a DIMM
Note:
It’s very important to protect the...

3. Slide the panel slightly to the down and lift it off the printer.
4. Insert the DIMM at an angle (about 45˚) into the connector, making sure that the notch on the unit
aligns with the tab on connector, and then press down carefully until it clicks into place.
Note:
❏Be sure to handle the DIMM by the edges only.
❏You will hear a click when the DIMM is properly placed.
5. Reinstall the panel and tighten two screws.
6. Reconnect all interface cables.
7. Reconnect the power cord, and turn on the printer....

Hard Disk Drive (C12C824511)
If you install a Hard Disk Drive, the followings can be performed:
❏Collate printing
❏Job printing/saving
❏Fonts/forms download
❏User Authentication/Account Track
❏Direct printing
Installing the Hard Disk Drive
Note:
It’s very important to protect the printer controller board and any associated circuit boards from
electrostatic damage. Before performing this procedure, review the antistatic caution on “Antistatic
Protection” on page 146. In addition, always handle circuit...

3. Slide the panel slightly to the down and lift it off the printer.
4. Attach the two cables to the hard disk drive.
5. Plug the two cables on the hard disk drive into the connector.
AcuLaser C3900 Series     User’s Guide
Installing Accessories     150