Epson AcuLaser C9100 User Manual

Maintenance and Transportation241
7
7
7
7
7
7
7
7
7
7
7
7
Waste Toner Collector 
Handling precautions
Always observe the following handling precautions when 
replacing the consumable products.
Do not reuse toner found in the waste toner collector. 
w
Warning:
❏Do not dispose of the used consumable products in fire, as it 
may explode and cause injury. Dispose of it according to local 
regulations.
❏Keep the consumable products out of the reach of children. 
Replacing the waste toner collector
Follow the...

242Maintenance and Transportation 2. Hold the waste toner collector and draw it out as shown 
below. When drawing out the waste toner collector, firmly 
pull it since it has a drag resistance. Take care not to pull it too 
strongly as it could cause you to fall down.
Note:
When placing the waste toner collector that is removed, stand it on 
a flat surface as shown below to prevent the toner content from 
spilling out.
 

Maintenance and Transportation243
7
7
7
7
7
7
7
7
7
7
7
7
3. Install a new waste toner collector to the printer as shown 
below.
Note:
If the waste toner collector is not installed correctly, cover A may 
not be closed or an error massage will be displayed on the LCD panel. 
Make sure the waste toner collector is correctly installed in the frame 
of the printer.
 

244Maintenance and Transportation 4. Close cover A.
w
Warning:
Take care not to get your finger caught in the metal part 
inside cover A when closing it.
 

245
Cleaning the Printer
The printer needs only minimal cleaning. If the printer’s outer 
case is dirty or dusty, turn off the printer and clean it with a soft, 
clean cloth moistened with a mild detergent.
c
Caution:
Never use alcohol or paint thinner to clean the printer cover. 
These chemicals can damage the components and the case. Be 
careful not to get water onto the printer mechanism or any 
electrical components.
Cleaning the pickup roller
If the paper jam occurs frequently, wipe the pickup...

246
1. Pull out the standard lower cassette until it stops.
2. Thoroughly wipe the rubber parts of the pickup roller in the 
standard lower cassette with a dry cloth.
* pickup roller
*
 

247
Transporting the Printer
For long distances
If you need to transport your printer for long distances, carefully 
repack it using the original box and packing materials.
Follow the steps below to repack your printer.
1. Turn off the printer.
2. Unplug the power cord from the electrical outlet.
3. Remove all installed options. For information on removing 
options, see the section under Installing Options.
4. Attach the protective materials to the printer, then repack the 
printer in its original box....