Epson AcuLaser C4200DNPC5 User Manual

Replacing Consumable Products331
9
9
9
9
9
9
9
9
9
9
9
9
Replacing the transfer unit
Follow the steps below to replace the transfer unit.
1. Press the latch on cover A and open the cover.
 

332Replacing Consumable Products
2. Grasp the two orange tabs and pull them up.
 

Replacing Consumable Products333
9
9
9
9
9
9
9
9
9
9
9
9
3. Pull the transfer unit out of the printer.
w
Warning:
Be careful not to touch the fuser, which is marked CAUTION 
HIGH TEMPERATURE , or the surrounding areas. If the 
printer has been in use, the fuser and the surrounding areas 
may be very hot.
4. Take the new transfer unit from its package.
 

334Replacing Consumable Products
5. Hold the new transfer unit by the orange tabs and lower it so 
the arrow on the transfer unit and the arrow inside the printer 
line up. Make sure the posts of the transfer unit fit into the 
guides.
 

Replacing Consumable Products335
9
9
9
9
9
9
9
9
9
9
9
9
6. Pull the transfer unit toward you and push the orange tabs into place.
w
Warning:
Be careful not to touch th e fuser, which is marked CAUTION 
HIGH TEMPERATURE , or the surrounding areas. If the 
printer has been in use, the fuser and the surrounding areas 
may be very hot.
 

336Replacing Consumable Products
7. Close cover A.
 

Cleaning and Transporting the Printer337
10
10
10
10
10
10
10
10
10
10
10
10
Chapter 10 
Cleaning and Transporting the Printer
Cleaning the Printer
New :quote
 t
he
 information
 from
 the s
imilar
 product
 and
 delete u
nnecessary
 i
nformationThe printer needs only minimal cleaning. If the printer’s outer 
case is dirty or dusty, turn off the printer and clean it with a soft, 
clean cloth moistened with a mild detergent.
c
Caution:
Never use alcohol or paint thinner to clean the printer cover. 
These...

338Cleaning and Transporting the Printer
2. Press the latch on cover A and open the cover.
3. Grasp the two orange tabs and pull them up.
 

Cleaning and Transporting the Printer339
10
10
10
10
10
10
10
10
10
10
10
10
4. Pull the transfer unit out of the printer.
w
Warning:
Be careful not to touch the fuser, which is marked CAUTION 
HIGH TEMPERATURE , or the surrounding areas. If the 
printer has been in use, the fuser and the surrounding areas 
may be very hot.
 

340Cleaning and Transporting the Printer
5. Gently wipe the transparent plastic window on the density 
sensor with a dry soft cloth or cotton swab.