Epson AcuLaser C2600N User Manual

Installing Options311
8
8
8
8
8
8
8
8
8
8
8
8
4. Identify the ROM module slots.
Note:
There are two ROM slots, and either slot can be used to attach the 
ROM module.
5. Insert the ROM module horizontally into the slot until the clip 
comes out.
c
Caution:
❏Do not force the ROM module into the socket.
❏Be sure to insert the ROM module in the correct 
direction.
❏Never remove the ROM module installed on the 
standard ROM socket (P). 
 

312Installing Options 6. Reattach the cover to the back side of the printer and secure 
it with the four screws.
7. Reconnect the power cord and turn the printer on.
To confirm that the option is installed correctly, print a Status 
Sheet. See  Printing a Status Sheet on page 370.
If P5C is not listed as an installed emulation on the status sheet, 
try reinstalling the module. Make sure that it is securely seated 
into the ROM slot on the circuit board.
Removing the P5C ROM module
c
Caution:
Before you...

Replacing Consumable Products313
9
9
9
9
9
9
9
9
9
9
9
9
Chapter 9 
Replacing Consumable Products
Replacement Messages
When you see the following messages on the LCD panel or the 
window of EPSON Status Monitor 3, replace the appropriate 
consumable products. You can continue to print for a short time 
after a message appears, but Epson recommends early 
replacement to maintain print quality and extend the life of your 
printer.
Note:
To clear the warning, select Clear All Warning from the control...

314Replacing Consumable Products
* T h e  l e t t e r s  C ,  M ,  Y ,  o r  K  a p p e a r  i n  t h i s  p o s i t i o n ,  i n d i c a t i n g  t h e  c o l o r  o f  t h e  t o n e r  
to be replaced. For example, the message Y Toner Low means that the 
amount of toner remaining in the yellow toner cartridge is low.
Note:
Messages appear for one consumable product at a time. After replacing 
a consumable product, check the LCD panel for replacement messages 
for other consumable products.
Even if...

Replacing Consumable Products315
9
9
9
9
9
9
9
9
9
9
9
9
Toner Cartridge
Handling precautions
Always observe the following handling precautions when 
replacing the consumable products:
❏Installing a genuine toner cartridge is recommended. Using a 
non-genuine toner cartridge may affect print quality. Epson 
shall not be liable for any damages or problems arising from 
the use of consumable products not manufactured or 
approved by Epson.
❏When handling toner cartridge, always place them on a clean...

316Replacing Consumable Products
Replacing a toner cartridge
Follow the steps below to replace a toner cartridge.
1. Prepare a new cartridge of the color (K, C, M or Y) displayed on 
the LCD panel.
2. Open cover D.
3. Hold the toner cartridge knob and tilt it toward you.
 

Replacing Consumable Products317
9
9
9
9
9
9
9
9
9
9
9
9
4. Remove the empty toner cartridge from the printer.
5. Take the protective materials off of the new cartridge, and 
gently shake the new toner cartridge a few times.
6. Take the new toner cartridge out of its package, and remove 
the plastic protective cover from the toner cartridge.
 

318Replacing Consumable Products 7. Insert the new cartridge into the printer.
8. Close the toner cartridge cover.
 

Replacing Consumable Products319
9
9
9
9
9
9
9
9
9
9
9
9
9. Close cover D.
  Photoconductor Unit
Handling precautions
Always observe the following handling precautions when 
replacing the consumable products:
❏The photoconductor unit weighs 1.3 kg (2.9 lb). Be sure to hold 
it firmly by the handle when carrying it.
❏When replacing the photoconductor unit, avoid exposing it 
to room light any longer than three minutes. 
❏Be careful not to scratch the surface of the drum. Also, avoid 
touching the drum,...

320Replacing Consumable Products ❏When storing the photoconductor unit, make sure to attach 
the protective cover to the photoconductor unit and put it in 
the sealed blackout package and the box in which the 
photoconductor unit was sold, and store it in a safe level place. 
❏Do not tilt the photoconductor unit.
w
Warning:
❏Do not dispose of the used consumable products in fire, as it 
may explode and cause injury. Dispose of it according to local 
regulations.
❏Keep the consumable products out of the...