Epson AcuLaser C1100D User Manual

171
2. Pull the blue lever on the right inside of the printer.
3. Move the blue cleaner slowly in and out once.
Note:
Move the cleaner completely in and out. Otherwise, the printer may 
not be cleaned effectively.
4. Push back the blue lever on the right inside of the printer.
 

172
5. Close cover A, then the cleaner cover.
Transporting the Printer
For long distances
If you need to transport your printer for long distances, carefully 
repack it using the original box and packing materials.
Follow the steps below to repack your printer.
1. Turn off the printer and remove the following items:
❏Power cord
❏Interface cable
❏Loaded paper
❏Photoconductor unit
❏Installed options
2. Attach the protective materials onto the printer, then repack 
the printer in its original box.
 

173
For short distances
Always pay attention to the following handling precautions when 
you need to move the printer for short distances.
If you are moving the printer on its own, two people should lift 
and carry the printer.
Follow the steps below to move the printer for short distances. 
1. Turn off the printer and remove the following items:
❏Power cord
❏Interface cable
❏Loaded Paper
❏Photoconductor unit
❏Installed options
2. Be sure to lift the printer by the correct positions as shown 
below.
3....

174
Finding a place for the printer
When relocating the printer, always choose a location that has 
adequate space for easy operation and maintenance. Use the 
following illustration as a guide for the amount of space required 
around the printer to ensure smooth operation. Dimensions 
shown in the illustration below are in millimeters.
To install and use any of the following options, you will need the 
indicated amount of additional space.
The 500-Sheet Paper Cassette Unit adds 130 mm (5.1 in.) to the...

175
❏Place the printer where you can easily unplug the power cord.
❏Keep the entire computer and printer system away from 
potential sources of interference, such as loudspeakers or the 
base units of cordless telephones.
❏Avoid using an electrical outlet that is controlled by wall 
switches or automatic timers. Accidental disruption of power 
can erase valuable information in your computer’s and 
printer’s memory.
c
Caution:
❏Leave adequate room around the printer to allow for sufficient 
ventilation....

176Troubleshooting
Chapter 8
Troubleshooting
Clearing Jammed Paper
If paper becomes jammed in the printer, the printer’s LCD panel 
and EPSON Status Monitor 3 provide alert messages.
Clear the paper jam by following the order of the indicated cover 
names displayed on the control panel or EPSON Status Monitor 3.
Precautions for clearing jammed paper
Be sure to observe the following points when you clear jammed 
paper.
❏Do not remove jammed paper by force. Torn paper can be 
difficult to remove and might...

Troubleshooting177
8
8
8
8
8
8
8
8
8
8
8
8
w
Warning:
❏Be careful not to touch the fuser, which is marked CAUTION 
HIGH TEMPERATURE, or the surrounding areas. If the 
printer has been in use, the fuser and the surrounding areas 
may be very hot.
❏Do not insert your hand deep into the fuser unit as some 
components are sharp and may cause injury.
Jam C (cover C)
Follow the steps below to clear paper jams at cover C.
1. Open cover C.
2. Raise the two green levers of the fuser unit to unlock it.
 

178Troubleshooting 3. Hold the guide up by holding the green tab, and gently pull 
out any sheets of paper. Be careful not to tear the jammed 
paper.
w
Warning:
Be careful not to touch the fuser, which is marked CAUTION 
HIGH TEMPERATURE, or the surrounding areas. If the 
printer has been in use, the fuser and the surrounding areas 
may be very hot.
4. Push down the two green levers of the fuser unit.
 

Troubleshooting179
8
8
8
8
8
8
8
8
8
8
8
8
5. Close cover C.
Jam D (cover D)
Follow the steps below to clear paper jams at cover D.
1. Raise the lever and open cover D.
 

180Troubleshooting 2. Gently pull out any sheets of paper that have fed part way 
into the printer.
Note:
When jammed paper cannot be found, proceed to the next step.
3. Raise the two green levers of the fuser unit to unlock it.
4. Hold the guide up by holding the green tab, and gently pull 
out any sheets of paper. Be careful not to tear the jammed 
paper.