Electrolux Ewn 10470 W User Manual

Technical data
Dimensions Width 60 cm
85 cm
63 cm Height
Depth
Water supply pressure Minimum 0,05 MPa
0,8 MPa Maximum
CottonMaximum Load6kg
MaximumSpin Speed1000 rpm 
Electrical connection
Voltage - Overall power -
FuseInformation on the electrical connection is given
on the rating plate on the inner edge of the
appliance door
technical dataelectrolux  31
132963290_EN.qxd  22/02/2008  10.00  Pagina  31
 

Consumption values
Water
consumption 
(in litres)Programme Energy
consumption 
(in kWh)Programme
duration 
(in minutes)
Cottons 90°2.157
Cottons 60° 1.354
Cottons Eco 60° (*) 1.0246
Synthetics 60°
0.9 46
x
For the duration of the
programmes, please
refer to the display on
the control panel.
Handwash 40° 0.4552 Delicates 40° 0.557
Wool 40° 0.4552
The consumption data shown on this
chart is to be considered purely
indicative, as it may vary depending on
the quantity and type of laundry, on the
inlet water...

Installation
Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit
devices so that they can be refitted if the
machine ever has to be transported
again.
1. After removing all the packaging,
carefully lay machine on it’s back to
remove the polystyrene base from the
bottom.
2. Remove the power supply cable and
the draining hose from the hose
holders on the rear of the appliance.
3. With a suitable spanner unscrew and
remove the central rear...

34electroluxinstallation
6. Open the porthole, take out the inlet
hose from the drum and remove the
polystyrene block fitted with the
adhesive tape on the door seal.
7. Fill the smaller upper hole and the two
large ones with the corresponding
plastic plug caps supplied in the bag
containing the instruction booklet.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets,
rugs etc. Check that the machine does
not touch the wall or...

3. Set the hose correctly by loosening
the ring nut. 
After positioning the inlet hose, be
sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened.
If it is too short and you do not wish to
move the tap, you will have to
purchase a new, longer hose specially
designed for this type of use.
Water drainage
The end of the drain hose can be
positioned in three ways:
Hooked over...

Electrical connection
Information on the electrical connection
is given on the rating plate on the inner
edge of the appliance door.
Check that your domestic electrical
installation can take the maximum load
required, also taking into account any
other appliances in use.
Connect the machine to an earthed
socket.
The manufacturer does not accept
any responsibility for damage or
injury through failure to comply
with the above safety precaution.
The power supply cable must be
easily accessible after...

environment concerns electrolux  37
Environment concerns
Packaging materials
The materials marked with the symbol
are recyclable.
>PEPSPP

38electroluxnotes
132963290_EN.qxd  22/02/2008  10.00  Pagina  38
 

132963290_EN.qxd  22/02/2008  10.00  Pagina  39
 

ANC number: 132 963 290 - 00 - 072008
132963290_EN.qxd  22/02/2008  10.00  Pagina  40