Electrolux Ewn 10470 W User Manual

programme information electrolux  21
Blanket
40° - ColdSeparate
programme for a
single blanket,
bedspread.Rinses 
Spin
Max. load kg 2
SPINREDUCTION
O
For cancelling the
wash programme
which is running and
to switch the
machine off.
Wool 
40° - Cold
Specially tested
programme for wool
garments bearing the
“Pure new wool, non-
shrink, machine
washable” label.
SPINREDUCTION/
R
INSEHOLD
Main wash
Rinses 
Short spin 
Max. load kg 2
Programme/
TemperatureType of laundryOptionsDescription of
programme
Washing...

22electroluxprogramme information
Rinses
With this programme it is possible to rinse and spin cotton
garments which have been washed by hand.
The machine performs 3 rinses, followed by a final long spin
at maximum speed. 
The spin speed can be reduced by pressing button 
3. 
Drain
For emptying out the water of the last rinse in
programmes with the Rinse Hold or No Spin option. 
Turn first the programme selector dial to O, then select
programme Drain and press button 
8.
Spin
Separate spin for hand washed...

care and cleaningelectrolux  23
Care and cleaning
You must DISCONNECT the appliance
from the electricity supply, before you
can carry out any cleaning or
maintenance work.
Descaling
The water we use normally contains
lime. It is a good idea to periodically use
a water softening powder in the
machine. Do this separately from any
laundry washing, and according to the
softening powder manufacturers
instructions. This will help to prevent the
formation of lime deposits.
After each wash
Leave the door open...

24electroluxcare and cleaning
Insert the detergent dispenser drawer
in the guide rails and push it in.
Washing drum
Rust deposits in the drum may occur
due to rusting foreign bodies in the
washing or tap water containing iron.
Important! Do not clean the drum with
acidic descaling agents, scouring
agents containing chlorine or iron or
steel wool.
1. Remove any rust deposits on the
drum with a cleaning agent for
stainless steel.
2. Run a washing cycle without any
washing to clean off any cleaning
agent...

 when no more water comes out,
unscrew the pump cover, using a
pliers, and remove the filter.
Always keep a rag nearby to dry up
spillage of water when removing the
cover.
 Remove any objects from the pump
impeller by rotating it.
 replace the filter into the pump
paying attention to insert it properly.
When done, screw it firmly 



	
 replace the emergency emptying cap
into the filter cover and fix it firmly 
 Close the pump door.




care and cleaningelectrolux  25...

When the appliance is in use and
depending on the programme selected
there can be hot water in the pump. 
Never remove the pump cover during a
wash cycle, always wait until the
appliance has finished the cycle, and is
empty. When replacing the cover,
ensure it is securely retightened so as
to stop leaks and young children being
able to remove it.
Cleaning the water inlet filter
If your water is very hard or contains
traces of lime deposit, the water inlet
filter may become clogged.
It is therefore a good...

What to do if...
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before contacting your local Service
Centre, please carry out the checks listed below.
During machine operation it is possible that the redlight of button 8blinks, at the
same some acoustic signals sound and one of the following alarm codes appears on
the display to indicate that the machine is not working:
●E10: problem with the water supply
●E20: problem...

28electroluxwhat to do if...
MalfunctionPossible causeSolution
The machine does not
empty and/or does not
spin:●The drain hose is
squashed or kinked. E20
●The drain pump is
clogged. E20
The Rinse Hold option
has been selected.
●The laundry is not evenly
distributed in the drum.
●Check the drain hose
connection.
●Clean the drain pump.
●Select the Drain or Spin
programme.
●Redistribute the laundry.
There is water on the
floor:●Too much detergent or
unsuitable detergent
(creates too much foam)
has been...

MalfunctionPossible causeSolution
The machine vibrates
or is noisy:●The transit bolts and
packing have not been
removed.
●The support feet have
not been adjusted.
●The laundry is not evenly
distributed in the drum.
●Maybe there is very little
laundry in the drum.
●Check the correct
installation of the
appliance.
●Check the correct
levelling of the appliance.
●Redistribute the laundry.
●Load more laundry.
Spinning starts late or
the machine does not
spin:●The electronic unbalance
detection device has cut...

30electroluxwhat to do if...
MalfunctionPossible causeSolution
If you are unable to identify or solve the
problem, contact our service centre.
Before telephoning, make a note of the
model, serial number and purchase
date of your machine: the Service
Centre will require this information.

	

	
	


	

	
The machine makes an
unusual noise●The machine is fitted
with a type of motor
which makes an...