Electrolux Esl 65070 User Manual

Make sure that there is detergent
in the detergent dispenser before
you start a new programme.
At the end of the programme
When the programme is completed, an
intermittent acoustic signal operates and
the end indicator comes on.
1.Press the on/off button to deactivate
the appliance.
2.Close the water tap.
If you do not press the on/off but-
ton, the Auto Off function auto-
matically deactivates the appli-ance after some minutes. This
helps to decrease the energy con-
sumption.
Important
• Let the dishes...

• Make sure that the spray arms can
move freely before you start a pro-
gramme.
8.4 Before starting a
programme
Make sure that:
• The filters are clean and correctly instal-
led.
• The spray arms are not clogged.• The position of the items in the baskets
is correct.
• The programme is applicable for the
type of load and for the degree of soil.
• The correct quantity of detergent is
used.
• There is dishwasher salt and rinse aid
(unless you use combi detergent tab-
lets).
• The cap of the salt container...

6.Assemble the filter (A) and put it into
position in filter (B). Turn it clockwise
until it locks.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.
9.2 Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.
9.3 External cleaning
Clean the appliance with a moist soft
cloth.Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or...

ProblemPossible solution
You cannot activate the appli-
ance.Make sure that the mains plug is connected
to the mains socket.
 Make sure that there is not a damaged fuse in
the fuse box.
The programme does not start.Make sure that the appliance door is closed.
 If the delay start is set, cancel the setting or
wait for the end of the countdown.
The appliance does not fill with
water.Make sure that the water tap is open.
 Make sure that the pressure of the water sup-
ply is not too low. For this...

ance is in setting mode, refer to ‘Set-
ting and starting a programme.
2.Press and hold function buttons (B)
and (C) at the same time until the indi-
cators of function buttons (A), (B) and
(C) start to flash.
3.
Press function button (B).
• The indicators of function buttons
(A) and (C) go off.
• The indicator of function button (B)
continues to flash.• The end indicator is off.
4.
Press function button (B).
• The end indicator comes on. The
rinse aid dispenser is active.
5.
Deactivate the appliance to...

www.electrolux.com/shop
117933341-A-422012