Electrolux Esf 66030 User Manual

care and cleaning electrolux  31
Prolonged periods of non-
operation 
If you are not using the machine for
any period of time you are advised to: 
1. Unplug the appliance and then
turn off the water. 
2. Leave the door ajar to prevent the
formation of any unpleasant
smells. 
3. Leave the inside of the machine
clean. 
Frost precautions 
Avoid placing the machine in a
location where the temperature is
below 0°C. If this is unavoidable,
empty the machine, close the
appliance door, disconnect the water
inlet...

The dishwasher will not start or stops during operation. 
Certain problems are due to the lack of simple maintenance or oversights,
which can be solved with the help of the indications described in the chart,
without calling out an engineer.
Switch off the dishwasher, open the door and carry out the following suggested
corrective actions.
Something not working
Fault codeMalfunction Possible cause Solution
continuous flashing
of the light of the
running
programme
appears in
the digital display
The...

something not working electrolux  33
Fault codeMalfunction Possible cause Solution
The programme
does not startThe dishwasher’s
door has not been
properly closed
The main plug is
not plugged in
Delay start has
been set
The fuse has
blown out in the
household fuse
box
Close the door
Replace the fuse
Insert the main
plug
If dishes are to be
washed
immediately,
cancel the delay
start
Once these checks have been carried
out; close the dishwasher’s door and
switch on the appliance. Press the
button of...

34electroluxsomething not working
If after all these checks, the problem
persists, contact your local Service
Force Centre.The wash results are not satisfactory
The dishes are not
clean
The wrong washing programme has been
selected.
The dishes are arranged in such a way as to stop
water reaching all parts of the surface. The
baskets must not be overloaded.
The spray arms do not rotate freely due to
incorrect arrangement of the load.
The filters in the base of the washing compartment
are dirty or...

technical data electrolux  35
Technical data
Dimensions Width 60 cm
85 cm
63.5 cm Height
Depth
Water supply pressure Minimum 0,05 MPa
0,8 MPa Maximum
Capacity12 place settings
Max. weight42 kg
Noise level45 dB (A)
Electrical connection
Voltage - Overall power -
FuseInformation on the electrical connection is given
on the rating plate on the inner edge of the
dishwasher’s door
Subject to change without notice
117998 54/0en  1-06-2006  11:01  Pagina 35
 

36electroluxtechnical data
The consumption values are intended
as a guide and depends on the
pressure and the temperature of the
water and also by the variations of the
power supply and the amount of
dishes.
Consumption values
Programme
duration 
(in minutes)Programme Energy
consumption 
(in kWh)Water
consumption 
(in litres)
*Intensive1,7 - 1,923 - 25
*Auto1,1 - 1,512 - 25
*Quick0,89
*
Eco
(Test programme
for test institutes)1,0515
*Glass0,8 - 0,914 - 16
*The programme duration is visible
in the digital...

hints for test institutes electrolux  37
Hints for test institutes
Testing in accordance with EN 60704
must be carried out with appliance
fully loaded and using the test
programme (see Consumption
values).Test in accordance with EN 50242
must be carried out when the salt
container and rinse aid dispenser
have been filled with salt and rinse aid
respectively and using the test
programme (see Consumption
values).
Arrangement upper basket
(take of the glass holder)
Arrangement lower basket
Arrangement...

38electroluxinstallation
Any electrical and/or plumbing
work required to install this
appliance should be carried out by
a qualified electrician and/or
plumber or competent person.
Remove all packaging before
positioning the machine.
If possible, position the machine next
to a water tap and a drain.
Fitting under a counter 
(kitchen worktop or sink)
By removing the machine’s worktop,
you can install it under a close fitting
sink unit or a pre-existing top,
providing the dimensions of the
recess...

installation electrolux  39
Levelling
Good levelling is essential for correct
closure and sealing of the door.
When the appliance is correctly
levelled, the door will not catch on
either side of the cabinet.
If the door does not close correctly,
loosen or tighten the adjustable feet
until the machine is perfectly level.
Water supply connections 
This dishwasher may be fed with
either hot (max. 60°) or cold water.
Nevertheless we advise you a cold
water supply.
A hot water supply is not always
efficient...

Water inlet hose with safety valve
After connecting the double-walled
water inlet hose, the safety valve is
next to the tap. Therefore the water
inlet hose is only under pressure
while the water is running. If the water
inlet hose starts to leak during this
operation, the safety valve cuts off the
running water.
Please take care when installing the
water inlet hose:
The electrical cable for the safety
valve is in the double-walled water
inlet hose. Do not immerse the
water inlet hose or the safety...