Eiki Eip-4500l Dlp Projector Owners Manual

EIP-4500
OWNER’S MANUAL
EIKI INDUSTRIAL CO., LTD. 

Errata[
DEUTSCH]
Seite Falsch Richtig
82
Errata[
FRANÇAIS]
Page Incorrect Correct
Falls Sie Ihr Kennwort
vergessen haben
Wenn Sie das Kennwort vergessen haben, löschen Sie es,
indem Sie das folgende Verfahren befolgen; stellen Sie
anschließend ein neues Kennwort ein.
Falls Sie Ihr Kennwort
vergessen haben
Wenn Sie das Kennwort vergessen haben, löschen Sie es,
indem Sie das folgende Verfahren befolgen; stellen Sie
anschließend ein neues Kennwort ein.
MODELEIP-4500/EIP-4500L
Errata[
ENGLISH]
Page Incorrect...

ii
IMPORTANT
For your assistance in reporting the loss or theft of your
Projector, please record the Serial Number located on
the bottom of the projector and retain this information.
Before recycling the packaging, please ensure that you
have checked the contents of the carton thoroughly
against the list of “Supplied accessories” on page 11.
Model No.: EIP-4500
Serial No.: 

iii
SPECIAL NOTE FOR USERS IN THE U.K.
The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating a 13A fuse. Should
the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked 
 or  and of the same rating as
above, which is also indicated on the pin face of the plug, must be used.
Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted.
In the unlikely event of the socket outlet in your home not being compatible...

iv
The supplied CD-ROM contains SETUP GUIDE in English, German, French, Spanish, Italian, Portuguese and
Japanese.
Die mitgelieferte CD-ROM enthält Einrichtungs-Anleitung in Englisch, Deutsch, Französisch, Spanisch, Italienisch,
Portugiesisch und Japanisch.
Le CD-ROM fourni contient le guide d’installation en anglais, allemand, français, espagnol, italien, portugais et
japonais.
Den medföljande CD-ROM-skivan innehåller uppställningsguide på engelska, tyska, franska, spanska,
italienska, portugisiska och...

1
Before using the projector, please read this owner’s manual carefully.
1. WARRANTY
This is to assure that you immediately receive the full benefit of the parts, service and labor
warranty applicable to your purchase.
2. CONSUMER PRODUCT SAFETY ACT
To ensure that you will promptly receive any safety notification of inspection, modification, or
recall that EIKI may be required to give under the 1972 Consumer Product Safety Act, PLEASE
READ CAREFULLY THE IMPORTANT “LIMITED WARRANTY” CLAUSE.
WARNING:High...

2
WARNING:
The cooling fan in this projector continues to run for about 90 seconds after the projector enters the standby mode.
During normal operation, when putting the projector into standby mode always use the STANDBY-ON button on
the projector or on the remote control. Ensure the cooling fan has stopped before disconnecting the power cord.
DURING NORMAL OPERATION, NEVER TURN THE PROJECTOR OFF BY DISCONNECTING THE POWER CORD.
FAILURE TO OBSERVE THIS WILL RESULT IN PREMATURE LAMP FAILURE.
Caution...

3
56
Menu items
The menu can be operated to achieve two functions, adjustments and settings. (For setting
the menu items, see pages 58 and 59. )
Using the Menu Screen
Menu Selections (Adjustments)
Example: Adjusting “Bright”•This operation can also be performed by using the buttons on the projector.ENTER 
buttonMENU button
UNDO button Mouse/ 
adjustment
button ('/"/\/|)
Adjustment 
buttons ('/"/\/|) MENU button
UNDO buttonENTER button
Example: “Picture” screen menu for
INPUT 1 (RGB)...

4
Contents
Preparing
Introduction
How to Read This Owner’s Manual ............... 3
Contents .......................................................... 4
IMPORTANT SAFEGUARDS .......................... 7
How to Access the PDF SETUP GUIDE.......... 10
Accessories .................................................. 11
Part Names and Functions .......................... 13 Using the Remote Control ........................... 17
Usable Range .................................................... 17
Inserting...

5
Using
Basic Operation
Using the “Options (1)” Menu ..................... 74
Displaying Dual Pictures (Pict in Pict) ............... 74
Setting the Resize Mode ................................... 74
Shifting the Projected Image Vertically
(Digital Shift) ................................................ 75
Setting On-screen Display ................................. 75
Setting the Video System ................................... 76
Capturing Projected Images ............................. 76
Selecting the...