Digital Projection Showlite 5000sx+ Lcd Projector Users Manual

2-3
GT13ZLB (H
1.2) -(H
1.5)
GT34ZLB (H
3.2) -(H
4.8) GT24ZLB (H
2.2) -(H
3.2)
GT20ZL (H
2.0) -(H
2.6) GT19ZL (H
1.7) -(H
2.2)
GT10RLB (H
1.0) 
Throw distance
For screen sizes between 40 and 500 not indicated on the above table, use formulas below.
Projection Distance= Screen Width (H) 
 Lens Magnification
Throw distance for GT10RLB (m/inch)=H 
 1.0  Distance from 0.8m to 5.0m/31.5 to 196.9
Throw distance for GT13ZLB (m/inch)=H 
 1.2 through H 
 1.5  Distance from 1.0m to 9.0m/39.37 to 354.3
Throw...

2-4
1H
1H0.32H
0.5V 0.5V
0.5V
0.32H0.32H
0.32H
1V1V
0.5V
1V
Desktop/Front
Vertical
Ceiling/Front
Vertical
Normal position
Normal position
Normal position
Horizontal
Normal projection position
x Lens Shift Adjustable Range
The top right diagram shows the location of the image position in the lens. The lens can be shifted within the shaded area as shown
using the normal projection position as a starting point.
Maximum Possible Range for GT20ZL:
Up: 0.5 V (V: height of projected image)
Down: 0.5 V
Right:...

2-5
Lens Shift Adjustable Range (continued)
The top right diagram shows the location of the image position in the lens. The lens can be shifted within the shaded area as shown
using the normal projection position as a starting point.
Maximum Possible Range for GT13ZLB/GT19ZL/GT24ZLB/GT34ZLB:
Values in parentheses for GT13ZLB.
Up: 0.39V (0.32V) (V: height of projected image)
Down: 0.39V (0.32V)
Right: 0.24H (0.19H) (H: height of projected image)
Left: 0.24H (0.19H)
NOTE: Lens shift is not available on the...

2-6
2
c Optional Lens Installation
This section describes how to install the lens.
Before installation
*Determine the optional lens to be used to obtain a desired projection distance. There are six optional lenses available:
GT13ZLB, GT19ZL, GT20ZL, GT24ZLB and GT34ZLB (Zoom lens)
GT10RLB (Short throw fixed-focus lens)
*Press the power button (ON/STAND BY) on the projector or POWER OFF button on the remote control for a minimum of two seconds to turn off the
power, wait 90 seconds (2 minutes in the...

2-7
IN
OUT REMOTE 2
AC IN 
AUDIO
AUD
IO OUT
R
R/Cr
G/Y
B/Cb
V
H/HV
RL/MONO
RL/MONORL/MONOL/MONO
DVI
R
GB OUT
RGB 1RGB 2
VIDEOS-VIDEO
AUDIOSLOT 1S
LOT
 2
4
3
IN
O
U
T R
E
M
O
T
E
 2
A
C
 IN
 
AUDIO
A
U
D
IO
 O
U
T
R
R/Cr
G/Y
B/Cb
V
H/H
V
RL/MO
NO
RL/MONORL/MONOL/M
ONO
D
V
I
R
G
B
 O
U
T
R
G
B
 1R
G
B
 2
V
ID
E
OS-V
ID
EO
AUDIOS
L
O
T
 1S
L
O
T
 2
2
1
4. Reinstall the lens hood.q Remove the front lens cap from the lens unit.
w Inser t the lens hood so that the grooves on the 4 corners of the lens hood
are...

2-8
v Making Connections
NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning on the power to the notebook PC. In most cases
signal cannot be output from RGB output unless the notebook PC is turned on after connecting with the projector.
* If the screen goes blank while using your remote control, it may be the result of the computers screen-saver or power management software.
* If you accidentally hit the POWER button on the remote control, wait...

2-9
To connect SCART output (RGB)
Before connections: An exclusive SCART adapter (ADP-SC1) and a
commercially available SCART cable are required for this connection.
NOTE:
• Audio signal is not available for this connection.
• The RGB 1 IN connector does not support Plug & Play.
USB A USB B PC CARD
PC CONTROL
IN
IN1 2
OUT
OUT SC TRIGGER REMOTE 2REMOTE 1LAN
AC IN 
AUDIO
AUDIOAUDIO OUTR
R/Cr
G/Y
B/Cb
VH/
  HVRL/MONO
RL/MONORL/MONOL/MONO
SLOT 1 SLOT 2DVI
RGB OUTRGB 1RGB 2VIDEOS-VIDEORGB 2
Video equipment...

2-10
AUDIO OUTL
AUDIO INLR
R
ComponentYCbCr
USB A USB B PC CARD
PC CONTROL
IN
IN OUT
OUT SC TRIGGER REMOTE 2REMOTE 1LAN
AC IN 
AUDIO
AUDIOAUDIO OUT
R
R/Cr
G/Y
B/Cb
V
H/
   HV
RL/MONO
RL/MONORL/MONO L/MONO
SLOT 1 SLOT 2DVI
RGB OUT
RGB 1
RGB 2
VIDEOS-VIDEO
RGB 1
RGB 2
Connecting Your DVD Player
DVD player
You can connect your projector to a DVD player with component output or
Video output. To do so, simply:
1. Turn off the power to your projector and DVD player.
2. If your DVD player has the component...

2-11
AUDIO OUTLRVIDEO OUTS-VIDEO VIDEO
AUDIO INLR
USB A USB B PC CARD
PC CONTROL
IN
IN OUT
OUT SC TRIGGER REMOTE 2REMOTE 1LAN
AC IN 
AUDIO
AUDIOAUDIO OUT
R
R/Cr
G/Y
B/Cb
V
H/
   HV
RL/MONO
RL/MONORL/MONOL/MONO
SLOT 1 SLOT 2DVI
RGB OUT
RGB 1
RGB 2
VIDEOS-VIDEOVIDEOS-VIDEO
VCR/ Laser disc player
Connecting Your VCR or Laser Disc Player
Audio equipment S-video cable (not supplied)
Video cable (not supplied)
Audio cable (not supplied)
Use common RCA cables (not provided) to connect your VCR, laser disc...

2-12
2. Installation
Connecting to a Network
With the LAN connection, you can control the projector over the network using a computer to switch the unit on/off, select the input and others.
*To control the projector over the network using a computer, use the Dynamic Image Utility 2.0 contained on the User Supportware CD-ROM or the
HTTP Server feature.
*With the Image Express Utility 1.0 contained on the supplied User Supportware CD-ROM, you can project your PC screen image to the projector
over the...