Digital Projection Projector HIGHlite Laser II 3D Series User Manual

page 133
Reference Guide
APPENDIX E: WIRING DETAILS
Trigger 1 & Trigger 2
3.5 mm mini jack
Tip Signal
Sleeve Ground
Output: 12V, 200 mA max
IR input
3.5 mm mini jack
Tip Signal
Ring Not connected
Sleeve Ground
3D Sync IN and 3D Sync OUT
75 ohm BNC
Sync OUT output voltage 5V
Sync IN input voltage 3.3V~5V
TipSleeveNotes
Sleeve
Ring
Tip
pin view of female connector 
Digital Projection HIGHlite Laser II 3D Series 
Rev A August 2016  

page 134
Reference Guide
APPENDIX F: GLOSSARY OF TERMS
Appendix F: Glossar y Of  Terms
1080p
An HDTV resolution which corresponds to 1920 x 1080 pixels (a widescreen aspect ratio of 16:9).
3D active glasses
Wireless battery-powered glasses with LCD shutters. Synchronization info\
rmation is communicated to the glasses by means of an infrared 
(IR) or radio frequency (RF) emitter which is connected to the Sync Out terminal on the projector. IR or RF pulses are transmitted by the 
emitter to signal when...

page 135
Reference Guide
APPENDIX F: GLOSSARY OF TERMS
Blanking (projection)
The ability to intentionally turn off, that is, set to black, areas around the edges of the projected image. It is sometimes referred to as “curtains” 
since it can be used to blank an area of image that literally falls on t\
he curtains at the side of the screen in a movie theater. Usually no image 
resizing or geometric correction takes place and the “blanked” part of the image is lost.
Not to be confused with horizontal and...

page 136
Reference Guide
APPENDIX F: GLOSSARY OF TERMS
Color gamut
The spectrum of color available to be displayed.
Color temperature
The position along the black body curve on the chromaticity diagram, normally quoted in Kelvin. It takes into account the preset values for 
color balance in the service set-up to take up the variations in the prism. The projector allows you to adjust this temperature (i.e. adjust the 
picture color temperature).
Component video
A three-wire or four-wire video interface...

page 137
Reference Guide
APPENDIX F: GLOSSARY OF TERMS
Dark time
The time inserted between frames when using 3D active glasses, to avoid ghosting caused by switching time between left and right eye.
DDC (Display Data Channel)
A communications link between the source and projector. DDC is used on the HDMI, DVI and VGA inputs. The link is used by the source to 
read the EDID stored in the projector.
Deinterlacing
The process of converting interlaced video signals into progressive ones.
DHCP	(Dynamic	Host...

page 138
Reference Guide
APPENDIX F: GLOSSARY OF TERMS
EDID	(Extended	Display	Identification	Data)
Information stored in the projector that can be read by the source.
EDID is used on the HDMI, DVI and VGA inputs, allowing the source to automatically configure to the optimum display settings.
EDTV	(Enhanced	Definition	Television)
A progressive digital television system with a lower resolution than HDTV.
Field
In interlaced video, a part of the image frame that is scanned separately. A field is a...

page 139
Reference Guide
APPENDIX F: GLOSSARY OF TERMS
Ghosting
An artifact in 3D image viewing. Ghosting occurs when an image intended \
for one eye is partially seen by the other eye.
Ghosting can be removed by optimizing the dark time and sync delay.
HDCP (High-bandwidth Digital Content Protection)
An encryption scheme used to protect video content.
HDTV	(High	Definition	Television)
A television system with a higher resolution than SDTV and EDTV. It can be transmitted in various formats, notably 1080p...

page 140
Reference Guide
APPENDIX F: GLOSSARY OF TERMS
Interleaving
The alternation between left and right eye images when displaying 3D.
LED (Light Emitting Diode)
An electronic component that emits light.
Letterboxing
Black margins at the top and bottom of the image. Letterboxing appears w\
hen a wider image is packed into a narrower frame without 
changing the original aspect ratio.
Lumen
A photometric unit of radiant power. For projectors, it is normally used to specify the total amount of emi\
tted...

page 141
Reference Guide
APPENDIX F: GLOSSARY OF TERMS
PAL (Phase Alternate Line)
The television system used in the UK, Australia and other countries - 625 lines transmitted at 50 interlaced fields per second.
Pillarboxing
Black margins at the left and right of the image. Pillarboxing appears w\
hen a narrower image is packed into a wider frame without changing 
the aspect ratio.
Pixel
Short for Picture Element. The most basic unit of an image. Pixels are arranged in lines and column\
s. Each pixel...

page 142
Reference Guide
APPENDIX F: GLOSSARY OF TERMS
Resolution
The number of pixels in an image, usually represented by the number of pixels per line and the number of lines (for example, 1920 x 1200).
RGB (Red, Green and Blue)
An uncompressed Component Video standard.
Saturation
The amount of color in an image.
Scope
An aspect ratio of 2.35:1.
SDTV	(Standard	Definition	Television)
An interlaced television system with a lower resolution than HDTV. For PA L and SECAM signals, the resolution is 576i;...