Digital Projection Projector HIGHlite Laser II 3D Series User Manual

page 123
Reference Guide
APPENDIX D: MENU MAP
Menu Sub Menus
EDGE BLEND
Edge Blend Off, On
Align Pattern Off, On
Blend Width
To p (slider, value range 0, 100 ~ 500)
Bottom (slider, value range 0, 100 ~ 500)
Left (slider, value range 0, 100 ~ 500)
Right (slider, value range 0, 100 ~ 500)
Black Level Uplift
Select Area:
To p (slider, value range 0 ~ 32 [0])
Bottom (slider, value range 0 ~ 32 [0])
Left (slider, value range 0 ~ 32 [0])
Right (slider, value range 0 ~ 32 [0])
Color Adjustment:
All (slider,...

page 124
Reference Guide
APPENDIX D: MENU MAP
Menu Sub Menus 
SETUP
Orientation Front Tabletop, Front Ceiling, Rear Tabletop, Rear Ceiling
High Altitude On, Auto
Screen Setting 16:10, 16:9, 4:3
ColorMax
Measured Data
 Red x (numeric, value range 0.550 ~ 0.750 [0.662])
 Red y (numeric, value range 0.250 ~ 0.450 [0.334])
 Green x (numeric, value range 0.200 ~ 0.400 [0.322])
 Green y (numeric, value range 0.400 ~ 0.750 [0.656])
 Blue x (numeric, value range 0.050 ~ 0.250 [0 .13 8 ])
 Blue y (numeric, value...

page 125
Reference Guide
APPENDIX D: MENU MAP
Menu Sub Menus
SETUP 
(continued)
Power On/Off Management
Auto Power Off Off, On
Auto Power On Off, On
Scheduled On/Off Off, On
 Numeriuc input - a selection of on/off times duiring the week.
Clock Adjust
Date (numeric input, YYYY/MM/DD)
Time (numeric input, HH:MM)
Time Zone (numeric input, UTC -11 ~ 12)
Startup Logo Off, On
Blank Screen Logo, Black, Blue, White
Trigger 1 Off, Screen, 5:4, 4:3, 16:10, 16:9, TheaterScope, Source, Unscaled, RS232
Trigger 2 Off,...

page 126
Reference Guide
APPENDIX D: MENU MAP
Menu Sub Menus
NETWORK
Network Mode Projector Control, Service
Standby Power Off, On
DHCP Off, On
IP (numeric input, IP address format)
Subnet Mask (numeric input, IP address format)
Gateway (numeric input, IP address format)
DNS (numeric input, IP address format)
MAC (information only)
AMX Off, On
PIP
PIP Off, On
Source HDMI1, HDMI2, VGA, COMP, DisplayPort, HDBaseT, 3G-SDI
Position Top Left, Top Right, Bottom Left, Bottom Right, PBP
Notes
 Some of the...

page 127
Reference Guide
APPENDIX D: MENU MAP
Menu Sub Menus 
INFORMATION
Model Name (information only)
Serial Number (information only)
Software Version 1 (information only)
Software Version 2 (information only)
Active Source (information only)
Signal Format
Active Source
Timing (information only)
H Refresh (information only)
V Refresh (information only)
Pixel Clock (information only)
PIP Source
(same as Active Source above)
Laser Hours (information only)
System Status
Wheel 1/2 Speed (information...

page 128
Reference Guide
APPENDIX E: WIRING DETAILS
Appendix E: Wiring Details
Signal inputs and outputs
VGA
15 way D-type connector
1 R
2 G
3 B
4 unused
5 Digital Ground (H Sync)
6 R Ground
7 B Ground
8 G Ground
9 +5V
10 Digital Ground (V Sync/DDC)
1 unused
12 SDA
13 H Sync
14 V Sync
15 SCL
Notes
VGA: pin view of female connector 
Digital Projection HIGHlite Laser II 3D Series 
Rev A August 2016  

page 129
Reference Guide
APPENDIX E: WIRING DETAILS
HDMI 1 and 2
19 way type A connector
1 TMDS Data 2+
2 TMDS Data 2 Shield
3 TMDS Data 2-
4 TMDS Data 1+
5 TMDS Data 1 Shield
6 TMDS Data 1-
7 TMDS Data 0+
8 TMDS Data 0 Shield
9 TMDS Data 0-
10 TMDS Clock+
11 TMDS Clock Shield
12 TMDS Clock-
13 CEC
14 not connected
15 SCL (DDC Clock)
16 SCA (DDC Data)
17 DDC/CEC Ground
18 +5 V Power
19 Hot Plug Detect
HDMI: pin view of panel connector
Notes 
Digital Projection HIGHlite Laser II 3D Series 
Rev A August...

page 130
Reference Guide
APPENDIX E: WIRING DETAILS
DisplayPort
DisplayPort 1.2
Pin 1   ML_Lane 0 (p)     Lane 0 (positive)  
Pin 2   GND       Ground  
Pin 3   ML_Lane 0 (n)     Lane 0 (negative)  
Pin 4   ML_Lane 1 (p)     Lane 1 (positive)  
Pin 5   GND       Ground  
Pin 6   ML_Lane 1 (n)     Lane 1 (negative)  
Pin 7   ML_Lane 2 (p)     Lane 2 (positive)  
Pin 8   GND       Ground  
Pin 9   ML_Lane 2 (n)     Lane 2 (negative)  
Pin 10   ML_Lane 3 (p)     Lane 3 (positive)  
Pin 11   GND       Ground...

page 131
Reference Guide
APPENDIX E: WIRING DETAILS
3G-SDI In, 3G-SDI Out
75 ohm BNC
COMPONENT
5 x 75 ohm BNC
RGBHV  RGsB  YPbPr  YCbCr
Green    Green + Sync  Y    Y
Blue   Blue  Pb  Cb
Red     Red   Pr   Cr
Hsync
Vsync
HDBaseT input
RJ45 socket.
3G-SDI connector
Notes
 3G-SDI signals are very high 
speed digital signals which require 
better quality coaxial cable than 
conventional analogue video. The 
data rate is 3 Gigabits per second.
  In choosing cable length and 
connectors for any installation...

page 132
Reference Guide
APPENDIX E: WIRING DETAILS
Control connections
LAN
RJ45 socket
(Shared with HDBaseT)
RS232
9 way D-type connector
1 unused
2 Received Data (RX)
3 Transmitted Data (TX)
4 unused
5 Signal Ground
6 unused
7 unused
8 unused
9 unused
Notes
 Only one remote connection (RS232 
or LAN) should be used at any one 
time.
HDBaseT/LAN port
RS232:  
pin view of female connector 
Digital Projection HIGHlite Laser II 3D Series 
Rev A August 2016