Home > Digital Projection > Projector > Digital Projection Projector HIGHlite 740 Series User Manual

Digital Projection Projector HIGHlite 740 Series User Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Digital Projection Projector HIGHlite 740 Series User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 577 Digital Projection manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							page 142
    Reference Guide
    APPENDIX F: GLOSSARY OF TERMS
    SPDIF
    Sony/Philips Digital Interface. A digital audio interface standard.
    Synchronization
    A timing signal used to coordinate an action.
    TheaterScope
    An aspect ratio used in conjunction with a special anamorphic lens to display 2.35:1 images packed into a 16:9 frame.
    Throw distance
    The distance between the screen and the projector.
    Throw ratio
    The ratio of the throw distance to the screen width.
    TRC (Throw ratio correction)
    A special number used in calculating throw distances and throw ratios when the image does not fill the width of the DMD™.
    TRC is the ratio of the DMD™ aspect ratio to the image source aspect \
    ratio:
    DMD™ aspect ratioSource aspect ratio
    TRC =
    TRC is only used in calculations if it is greater than 1.
    UXGA
    A display resolution of 1600x1200 pixels with a 4:3 screen aspect ratio. (Stands for Ultra Extended Graphics Array.)
    Notes
       
    Digital Projection HIGHlite 740 Series 
    Rev I Februar y 2015  
    						
    							page 143
    Reference Guide
    APPENDIX F: GLOSSARY OF TERMS
    Vertical Scan Rate
    The rate at which the frames of the incoming signal are refreshed. The rate is set by the vertical synchronization from the source and 
    measured in Hertz.
    Vignetting
    Optical cropping of the image caused by the components in the projection\
     lens.  This can happen if too much offset is applied when 
    positioning the image using the lens mount.
    Vista
    An aspect ratio of 1.66:1.
    Warp
    A set of projector functions that allow you to intentionally distort the image, for example to fit an arbitrarily shaped screen.
    WUXGA
    A display resolution of 1920 x 1200 pixels with a 16:10 screen aspect ratio. (Stands for Widescreen Ultra Extended Graphics Array.)
    Y
    This is the luminance input (brightness) from an S-Video or Component Video signal.
    YUV
    See Pr, Pb.
    Notes
       
    Digital Projection HIGHlite 740 Series 
    Rev I Februar y 2015  
    						
    							page 144
    Reference Guide
    TECHNICAL SPECIFICATIONS
    Technical Specifications
    Digital Projection reserves the right to change product specifications without prior notice.
    Models
    The specifications on these pages refer to the following projectors:
    Series name(s)ResolutionPart numberLumensContrast ratio
    HIGHlite 740 
    WUXGA
    WUXGA114-6909,0002,000:1
    HIGHlite 740 
    1080p
    1080p113-90110,0002,000:1
    Color system:  3-chip DLP®
    Display type:  3 x 0.67” DarkChip™ DMD™ (WUXGA)
        3 x 0.65” DarkChip™ DMD™ (1080p)
    DMD specification (native):
    WUXGA1080p
    1920 x 1200 pixels1920 x 1080 pixels
    +/- 12° tilt angle
    Fast transit pixels for smooth greyscale and improved contrast.
    Notes
       
    Digital Projection HIGHlite 740 Series 
    Rev I Februar y 2015  
    						
    							page 145
    Reference Guide
    TECHNICAL SPECIFICATIONS
    Inputs and outputs
    TypeConnectorQtyTypeConnectorQty
    Video & ComputerCommunication & Control
    DVI-D / DVI-ADVI-I13D Sync OutBNC1
    HDMI 1.3HDMI13D Sync InBNC1
    3G-SDIBNC1LANRJ451
    VGA / Analog RGB15-pin D-Sub1RS2329-pin D-Sub1
    Component Video4 x BNC1Wired Remote In3.5 mm Stereo Jack1
    S-Video4-pin Mini DIN1Wired Remote Out3.5 mm Stereo Jack1
    Composite VideoRCA1Service PortUSB Type B1
    Composite VideoBNC1
    Audio
    SPDIF Digital OutputRCA1
    Bandwidth
    • 170 MHz on analog RGB
    • 165 Megapixels per second on HDMI and DVI 
    Remote control and keypad
    • Addressable IR remote control, wireless and wired with loop-through
    • On-board keypad
    Automation control
    • RS232
    • LAN
    Color temperature
    • User selectable from 3200 to 9000 K
    Notes
       
    Digital Projection HIGHlite 740 Series 
    Rev I Februar y 2015  
    						
    							page 146
    Reference Guide
    TECHNICAL SPECIFICATIONS
    Lamps
    Lamp typePart numberTypical lamp life 
    (full power)
    Typical lamp life 
    (Eco mode)
    2 x 370 W 
    High Intensity Discharge114-303
    1500 hours
    Up to 3000 hours in 
    lamp sequential mode
    2000 hours
    Up to 4000 hours in 
    lamp sequential mode
    Lenses
    Detailed information about available lenses can be found in Appendix A: Lens Part Numbers.
    Further information about lens offsets can be found in Positioning The Image > Maximum offset range.
    Lens mount
    • Motorised shift, zoom and focus. Programmable shift.
    Mechanical mounting
    • Front/Rear Table
    • Front/Rear Ceiling
    • Adjustable Front/Rear Feet
    • Optional RapidRig™ frame with integrated pitch, roll and yaw adjustme\
    nts.
    Orientation
    • Table Top or Inverted: Yes 
    • Pointing Up:   Ye s
    • Pointing Down:  Yes 
    • Roll (Portrait):   Ye s
    Notes
     Information on lenses in this guide:
    •	 Appendix A: Lens Part Numbers 
    - detailed descriptions of available 
    lenses.
    •	 Maximum offset range - lens 
    offsets.
    •	 Choosing A Lens - a step-by-step 
    guide on calculating throw ratios.
    •	 Appendix B: Lens Charts - quick 
    reference charts depicting throw 
    distances for commonly used aspect 
    ratios.
     See also the lens calculator on the 
    Digital Projector website.
     Lens presets store X and Y 
    position only, not zoom and focus 
    information.
       
    Digital Projection HIGHlite 740 Series 
    Rev I Februar y 2015  
    						
    							page 147
    Reference Guide
    TECHNICAL SPECIFICATIONS
    Electrical and physical specifications
    • Power requirements90-240 VAC, 50-60 Hz (single phase)
    • Power Consumption950 W
    • Thermal Dissipation3241 BTU/hr
    • Fan Noise39 dBA
    • Operating Temperature0°C to 40°C (32 to 104 F)
    • Storage Temperature-20°C to 60°C (-4 to 140 F)
    • Operating Humidity20% to 90% non-condensing
    • Weight27 kg (60 lb)
    • DimensionsL: 66.5 cm W: 50 cm H: 22 cm 
    (L: 26.2 in. W: 19.7 in. H: 8.7 in.)
    Safety & EMC regulations
    • CE, FCC Class A & B, UL, CCC, KC
    Accessories
    AccessoryPart number
    Rigging frame112-267 (USA)
    115-919 (RoW)
    Ceiling mount kit w/ plate & 500 mm pole113-121 (USA)
    112-942 (RoW)
    Infrared remote (replacement)105-023
    Notes
       
    Digital Projection HIGHlite 740 Series 
    Rev I Februar y 2015  
    						
    							Digital Projection Limited
    Greenside Way, Middleton Manchester M24 1XX, UK
    Registered in England No. 2207264 Registered Office: as above
    Tel (+44) 161 947 3300 Fax (+44) 161 684 7674
    [email protected] [email protected]
    www.digitalprojection.co.uk
    Digital Projection Inc.
    55 Chastain Road, Suite 115 Kennesaw, GA 30144, USA
    Tel (+1) 770 420 1350 Fax (+1) 770 420 1360
    [email protected] www.digitalprojection.com
    Digital Projection China
    中国 北京市  朝阳区 芍药居北里101号 世奥国际中心A座2006室(100029)
    Rm A2006 ShaoYaoJu 101 North Lane Shi Ao International Center Chaoyang District Beijing 100029, PR CHINA 
    Tel (+86) 10 84888566 Fax (+86) 10 84888566-805
    [email protected] www.dp-china.com.cn
    Digital Projection Asia
    16 New Industrial Road #02-10 Hudson Technocentre Singapore 536204
    Tel (+65) 6284-1138 Fax (+65) 6284-1238
    www.digitalprojectionasia.com 
    114-751I HIGHlite 740 Series User Manual
    Contact Information:  
    						
    All Digital Projection manuals Comments (0)

    Related Manuals for Digital Projection Projector HIGHlite 740 Series User Manual