Digital Projection Projector E-Vision 8000 Series User Manual

							Digital Projection E-Vision 8000 Series  THE KEY COMMANDS Remote Communications Guide
65
The Key Commands
Corresponding remote control key
power.onPOWER ON
power.offPOWER OFF
menuMENU
exitEXIT
inputINPUT
picturePICTURE
networkNETWORK
autosyncAUTO SYNC
aspectASPECT
pipPIP
overscanOVERSCAN
freezeFREEZE
lampmodeLAMP MODE
infoINFO
shutterSHUTTER
idsetID SET
lensshiftLENS SHIFT
testpatternTEST PATTERN
enterENTER
upUP
downDOWN
leftLEFT
rightRIGHT
Notes
 An input command will return 
“NA” when the input command is 
not applicable in some specific 
conditions. 
Rev F July 2014  
						

							Digital Projection E-Vision 8000 Series  WEB CONFIGURATION UTILITY Remote Communications Guide
66
Web Configuration Utility
The LAN IP Address of the projector can be set remotely using the Web Configuration Utility.
• Make sure the projector is connected to a remote computer via LAN.
• From the remote computer, access the default LAN IP address of the projector. The Web Configuration Utility opens.
It is possible to control many of the projector’s settings using the embedded Web Configuration Utility. The following pages contain a few 
examples of such settings.
Examples
Navigate to the Control tab and edit the settings as required.
The Source/general page enables you to:
• switch the projector on and off
• open and close the shutter
• select an input source
Notes
 Eco Network Power must be set to 
Standard, if you wish to control the 
projector via the LAN connection.
 The default LAN IP address is 
192.168.0.100
  If you suspect this has been 
changed, then you can view the 
current Network settings in the 
Control Menu.
 For more information about 
connecting the projector via LAN, 
see the Connection Guide. 
Rev F July 2014  
						

							Digital Projection E-Vision 8000 Series  WEB CONFIGURATION UTILITY Remote Communications Guide
67
Examples - continued from previous page
The Image settings page allows access to settings from the 
Picture menu.
The Lens adjustments page allows access to lens control 
settings. 
Notes 
Rev F July 2014  
						

							Digital Projection E-Vision 8000 Series  WEB CONFIGURATION UTILITY Remote Communications Guide
68
Examples - continued from previous page
The Geometry adjust and Edge Blend pages allow access to 
settings from the Alignment menu.
Notes 
Rev F July 2014  
						

							Digital Projection E-Vision 8000 Series  WEB CONFIGURATION UTILITY Remote Communications Guide
69
Examples - continued from previous page
The Advanced control page allows access to settings 
from the Picture menu, Color sub-menu.
To view and edit your network settings, navigate to 
the Configuration tab.
Notes 
Rev F July 2014