Dell U2410f Manual

							 
Notes,  Caution s, and  Warning s  
Throughout this guide, blocks of text may be accompanied by an icon and printed in bold type or in italic type. These blocks are notes, notices, and cautions, 
and they are used as follows:  
Some warnings may appear in alternate formats and may be unaccompanied by an icon. In such cases, the specific presentation of the caution is mandated by 
regulatory authority.  
Information in this document is subject to change without notice.  
2009 -  
Reproduction of these material in any manner whatsoever without the written permission of Dell Inc.   is strictly forbidden.  
Trademarks used in this text:  Dell , the  DELL  logo   are trademarks of Dell Inc;  Microsoft  and  Windows  either registered trademarks or trademarks of Microsoft Corporation in the 
United States and/or other countries.    
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any 
proprietary interest in trademarks and trade names other than its own.  
Model U2410f  
6  About Your Monitor  
Setting Up the Monitor  
Operating the Monitor  
Solving Problems  
Appendix  
  NOTE:  A NOTE indicates important information that helps you make better use of your computer.
  CAUTION:  A CAUTION indicates potential damage to hardware or loess of data if instructions are not 
followed.  
WARNING:  A WARNING   indicates a potential for property damage, personal injury or death.  
						

							Back to Contents Page    
 
 
Package Contents  
Product Features  
Identifying Parts and Controls  
Monitor Specifications  
Universal Serial Bus (USB) Interface  
Card Reader Specifications  
Plug and Play Capability  
LCD monitor Quality and Pixel Policy  
Maintenance Guidelines  
 
 
Package Contents    
Your monitor ships with the components shown below. Ensure that you have received all the components and  contact Dell  if something is missing.  
 
  NOTE:  Some items may be optional and may not ship with your Monitor. Some features or media may not 
be available in certain countries.
  l Monitor   
  l Stand   
  l Power Cable     
						

							 
Product Features  
The  U2410 - film transistor (TFT), liquid crystal display (LCD). The monitor features include:   
■  24 - inch ( 518.4 mm x 324 mm) viewable area display measured diagonally.   
■  1920 x 1200 resolution, plus full - screen support for lower resolutions.   
■  Wide viewing angle to allow viewing from a sitting or standing position, or moving side - to - side.   
■  Tilt, swivel, rotation and height adjustment capabilities.   
■  Removable pedestal and Video Electronics Standards Association (VESA) 100 mm mounting holes for flexible mounting solutions.   
■  Plug and Play capability if supported by your system.   
■  On - Screen Display (OSD) adjustments for ease of set - up and screen optimization.   
■  Software and documentation CD includes an information file (INF), Image color Matching File (ICM), and product documentation.    
■  Security lock slot.    
Identifying Parts and Features  
Front View     l VGA Cable (attached to the monitor)   
  l DVI Cable   
  l DP Cable   
    l USB up stream  cable (enables the USB ports and card reader on the monitor) 
    l Drivers and Documentation  media   
l Quick Setup Guide    
l Safety Information     
						

							     
Back View  
 
 Front View Control Panel
Label Description
1 - 3 Shortcut keys 
*The default settings are  Preset Modes  Select , Brightness/Contrast 
Select  and  Input Source  Select .  
1   Preset Modes Select
2   Brightness/Contrast Select
3   Input Source Select
4   OSD  M enu  S elect 
5   E xit
6   Power B utton (with power light indicator)
NOTE: 1~5 buttons are capacitive touch buttons, which are activated by placing your finger on the blue LED.     
						

							 
 
 
 
   
Side View   Label Description/Use
1 VESA Mounting Holes (100mm)  
(Behind attached VESA Plate)   T o mount the monitor.  
2  Connectors Label To indicate the positions and types of 
connectors.
3 Security Lock Slot T o help secure your monitor.
4 Dell Soundbar Mounting Brackets To attach the optional Dell Soundbar.
5 Barcode Serial Number Label T o contact Dell for technical support.
6 Regulatory Rating  Label   Lists the regulatory approvals.
7 Cable Management Slot T o organize cables by placing them through the 
slot.  
						

							Bottom View  
 
 
 
  Bottom View   Left View 
Label Description
1 Card Reader. See  Card Reader Specifications    
2 USB Down Stream Ports
Label Description
1   AC Power Cord Connector  
2  
						

							   
Monitor Specifications  
The following sections give you information about the various power management modes and pin assignments for various connectors for your monitor.  
Power Management Modes  
If you have VESAs DPMS compliance display card or software installed in your computer, the monitor automatically reduces its power consumption when not in 
use. This is referred to as Power Save Mode. If input from keyboard, mouse or other input devices is detected by the computer, the monitor will automatically 
wake up. The following table shows the power consumption and signaling of this automatic power -  
Activate the computer and wake up the monitor to gain access to the  OSD .    
Pin Assignments  
VGA Connector  
 3   DisplayPort Connector
4   HDMI Connector
5 DVI Connector - 1
6 D VI  Connector - 2
7 VGA Connector
8 Composite Video Connector  
9
10   Audio Out (Support two channel output )
1 1 USB Upstream Port  
1 2
USB Downstream Port
13 Stand Lock  （ Use a M3x14 threaded screw to 
lock stand, screw not provided ） 
VESA Modes   Horizontal 
Sync   Vertical Sync   Video   Power 
Indicator   Power Consumption  
Normal operation (with 
max luminance, Dell 
Soundbar and USB 
active)    Active   Active   Active   Blue   132 W (Maximum)  
Normal operation Active Active Active Blue 75 W (Typical)
Active - off mode   Inactive   Inactive   Blanked   Amber   Less than 1 W  
Switch off   -     -     -     Off   Less than 1 W  
 
NOTE:  This monitor is TCO 03 power management compatible.    
NOTE:  Zero power consumption in OFF mode can only be achieved by disconnecting the power cable from the 
monitor.    
Pin 
Number   15 - pin Side of the 
Connected Signal Cable  
1   Video -  
2   Video - Green  
3   Video - Blue  
4   GND  
5   Self - test  
6   GND - R    
						

							 
 
Composite  V ideo Connector  7   GND - G  
8   GND - B  
9   Computer 5V/3.3V  
10   GND - sync  
11   GND  
12   DDC data  
13   H - sync  
14   V - sync  
15   DDC clock  
Pin Number   24 - pin Side of the Connected Signal Cable  
1 TMDS RX2 -
2 TMDS RX2+
3 TMDS Ground
4 Floating
5 Floating
6 DDC Clock
7 DDC Data
8 Floating
9 TMDS RX1 -
10 TMDS RX1+
11 TMDS Ground
12 Floating
13 Floating
14 +5V/+3.3V power  
15
16 Hot Plug Detect
17 TMDS RX0 -
18 TMDS RX0+
19 TMDS Ground
20 Floating
21 Floating
22 TMDS Ground
23 TMDS Clock+
24 TMDS Clock -  
						

							 
Luma composite chroma  
 
Component  Video Connector  
 
 
DisplayPort Connector  
 
  Pin Number 3 - pin Side of the C onnected  Signal Cable (Cable not 
included)
1 Y (Luminance signal)
2 Pb (Color differential signal)
3 Pr (Color differential signal)
Pin 
Number   20 - pin Side of the Connected Signal 
Cable  
1 ML0(p)
2 GND
3 ML0(n)
4 ML1(p)
5 GND
6 ML1(n)
7 ML2(p)
8 GND
9 ML2(n)
10 ML3(p)
11 GND
12 ML3(n)
13 GND
14 GND 
15 AUX(p)
16 GND
17 AUX(n)
18 HPD
19 Re - PWR
20 PWR  
						

							 
HDMI Connector  
 
  Pin 
Number   19 - pin Side of the Connected Signal 
Cable  
1 TMDS DATA 2+
2 TMDS DATA 2 SHIELD
3 TMDS DATA 2 -
4 TMDS DATA 1+ 
5 TMDS DATA 1 SHIELD
6 TMDS DATA 1 -
7 TMDS DATA 0+
8 TMDS DATA 0 SHIELD
9 TMDS DATA 0 -
10 TMDS CLOCK
11 TMDS CLOCK SHIELD
12 TMDS CLOCK -  
13 Floating
14 Floating  
15 DDC CLOCK (SDA)
16 DDC DATA (SDA)
17 GROUND
18 +5V POWER
19 HOT PLUG DETECT
Flat Panel  Specifications    
Screen type   Active matrix  -  TFT LCD  
Panel type IPS
Screen dimensions   24 inches (24 - inch diagonal viewable image size)  
Preset display area:    
Horizontal   518.4mm (20.41 inches)  
Vertical   324.0mm  (12.75 inches)  
Pixel pitch   0.27mmx0.27mm   
Viewing angle   178  
Luminance output   4 00 cd/m  ( typ)  
Contrast ratio   1000 :1 (typ),  80,000:1 (Max, Dynamic Contrast on)  
Faceplate coating   Antiglare with hard - coating 3H  
Backlight   7  CCFL U - type system  
Response Time 6 ms panel typical (Grey to Grey)
Color Gamut   110 % (typ.)