Dell P2011h Users Guide

 
Connecting the Blue VGA Cable  
 
   
Connecting the USB cable  
After you have completed connecting the DVI/VGA /DP  cable, follow the procedure below to connect the USB cable to the computer and complete your monitor 
setup:  
1. Connect the upstream USB port (cable supplied) to an appropriate USB port on your computer. (See  bottom  view for details.)   
2. Connect USB peripherals to the downstream USB ports (side or bottom) on the monitor. (See  side  or  bottom  view for details.)   
3. Plug the...

After attaching all necessary cables to your monitor and computer, (See  Connecting Your Monitor  for cable attachment,) use the cable management slot 
to organize all cables as shown above.  
Attaching the Soundbar (Optional)  
 
Removing the Stand  
To remove the stand:  
 
To remove the stand:  
1. Place the monitor on a flat surface.   
2. P ress and hold the Stand release button.    
3. Lift the stand up and away from the monitor.   
Wall Mounting (Optional)  CAUTION:  Do not use with any device...

(Screw dimension: M4 x 10 mm).   
Refer to the instructions that come with the VESA - compatible base mounting kit.   
1. Place the monitor panel on a soft cloth or cushion on stable flat table.    
2. Remove the stand   
3. Use a screwdriver to remove the four screws securing the plastic cover.    
4. Attach the mounting  bracket from the wall mounting kit to the LCD.    
5. Mount the LCD on the wall by following the instructions that came with the base mounting kit.    
Back to Contents Page      NOTE:...

Back to Contents Page    
 
Troubleshooting  
 
   Troubleshooting Your Monitor  
   Built - in Diagnostics  
   Common Problems  
   Product Specific Problems  
   Universal Serial Bus Specific Problems  
   Dell Soundbar Problems  
Troubleshooting Your Monitor  
Self - Test Feature Check  
Your monitor provides a self - test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly 
connected but the monitor screen remains dark, run the...

To run the built - in diagnostics:  
1. Ensure that the screen is clean (no dust particles on the surface of the screen).   
2. Unplug the video cable(s) from the back of the computer or monitor. The monitor then goes into the self - test mode.   
3. Press and hold the  Button 1  and  Button 4  on the front panel   simultaneously for 2 seconds. A gray screen appears.   
4. Carefully inspect the screen for abnormalities.   
5. Press the  Button 4  on the front panel again. The color of the screen changes...

Product Specific Problems  
   
Universal Serial Bus (USB) Specific Problems  Horizontal/Vertical Lines Screen has one or more lines l Reset the monitor to Factory Settings.    
l Perform Auto Adjust via OSD.    
l Adjust Phase and Pixel Clock controls via OSD.    
l Perform monitor self - test feature check and determine if these lines are also in self - test 
mode.    
l Check for bent or broken pins in the video cable connector.    
l Run the built - in diagnostics.   
NOTE:  When using DVI - D input,...

 Problems  
Back to Contents Page  Common Symptoms   What You Experience   Possible Solutions  
No Sound No power to Soundbar  -  the 
power indicator is off  l Turn the Power/Volume knob on the Soundbar clockwise to the middle position; check if 
the power indicator (Blue LED) on the front of the Soundbar is illuminated.   
l Confirm that the power cable from the Soundbar is plugged into the adapter.   
No Sound Soundbar has power  -  power 
indicator is on l Plug the audio line - in cable into the...