Dell P2010h Users Guide

 
Connecting the USB cable  
After you have completed connecting the DVI/VGA /DP  cable, follow the procedure below to connect the USB cable to the computer and complete your monitor 
setup:  
1. Connect the upstream USB port (cable supplied) to an appropriate USB port on your computer. (See  bottom  view for details.)   
2. Connect USB peripherals to the downstream USB ports (side or bottom) on the monitor. (See  side  or  bottom  view for details.)   
3. Plug the power cables for your computer and...

 
To attach the soundbar:  
Removing the Stand  
 
To remove the stand:  
1. Place the monitor on a flat surface.   
2. P ress and hold the Stand release button.    
3. Lift the stand up and away from the monitor.   
Wall Mounting (Optional)  NOTICE:  Do not use with any device other than the Dell Soundbar. 
NOTE:  The soundbar power connector (+12 V DC output) is for the optional Dell Soundbar only. 
1. Working from the back of the monitor, attach the Soundbar by aligning the two slots with the two tabs...

(Screw dimension: M4 x 10mm).  
 
Refer to the instructions that come with the VESA compatible base mounting kit.  
 
1. Place the monitor panel on a soft cloth or cushion on stable flat table.  
2. Remove the stand.  
3. Use a screwdriver to remove the four screws securing the plastic cover.  
4. Attach the mounting bracket from the wall mounting kit to the LCD.  
5. Mount the LCD on the wall by following the instructions that came with the base mounting kit.  
Back to Contents Page  NOTE:   For use...

Back to Contents Page    
 
Troubleshooting  
 
   Self - Test  
   Built - in Diagnostics  
   Common Problems  
   Product Specific Problems  
   Universal Serial Bus Specific Problems  
   Dell Soundbar Problems  
Self - Test  
Your monitor provides a self - test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly 
connected but the monitor screen remains dark, run the monitor self - test by performing the following steps:   
1. Turn...

To run the built - in diagnostics:  
1. Ensure that the screen is clean (no dust particles on the surface of the screen).   
2. Unplug the video cable(s) from the back of the computer or monitor. The monitor then goes into the self - test mode.   
3. Press and hold the  Button 1  and  Button 4  on the front panel, simultaneously for 2 seconds. A gray screen appears.   
4. Carefully inspect the screen for abnormalities.   
5. Press the  Button 4  on the front panel again. The color of the screen changes...

Product Specific Problems  
Universal Serial Bus (USB) Specific Problems  
 Problems  Wrong Color Picture color not good l Change the Color Setting Mode in the Color Settings OSD to Graphics or Video 
depending on the application.   
l Try different Color Preset Settings in Color Settings OSD. Adjust R/G/B value in Color 
Settings OSD if the Color Management is turned off.  
l Change the Input Color Format to PC RGB or YPbPr in the Advance Setting OSD.  
l Run the built - in diagnostics.   
Image...

Back to Contents Page   setting.   
l Clean and reseat the audio line - in plug.   
Unbalanced Sound Output Sound from only one side of 
Soundbar l Clear any obstructions between the Soundbar and the user.   
l Confirm that the audio line - in plug is completely inserted into the jack of the sound card 
or audio source.   
l Set all Windows audio balance controls (L - R) to their midpoints.   
l Clean and reseat the audio line - in plug.   
l Troubleshoot the computers sound card.   
l Test the Soundbar...