dell inspiron 8200 User Manual

Keyboard: Dell Inspiron 8200
 
1 blank key
2 keyboard
3 right side of computer
5.  Lift the right end of the keyboard and slide it slightly toward the righ\
t side of the  computer to disengage the tabs at the left end. 
6.  Pivot the keyboard and balance it upright on the left side of the comput\
er. 
file:///F|/Service%20Manuals/Dell/Inspiron/8200/keyboard.htm (3 of 5) \
[2/28/2004 7:40:51 AM] 

Keyboard: Dell Inspiron 8200
 
1 keyboard cable
2 keyboard interface 
connector
3 system board
7.  Disconnect the keyboard cable and lay the keyboard aside. 
Replacing the Keyboard 
1.  While bracing the keyboard upright on its left end, connect the keyboard\
 cable  to the keyboard interface connector on the system board. 
file:///F|/Service%20Manuals/Dell/Inspiron/8200/keyboard.htm (4 of 5) \
[2/28/2004 7:40:51 AM] 

Keyboard: Dell Inspiron 8200
NOTICE: Position the keyboard/track-stick flex cable so that it is not pinched 
when you replace the keyboard in the bottom case. 
2.  Insert the metal tabs at the left end of the keyboard under the edge of \
the  bottom case, and fit the keyboard into place. 
3.  Check that the keyboard is correctly installed. The keys should be flush\
 with the  left and right surfaces of the palm rest. 
4.  Turn the computer over and reinstall the four M2.5 x 20-mm screws. For e\
xtra...

Display: Dell Inspiron 8200
Back to Contents Page 
Display 
Dell™ Inspiron™ 8200
  Display Overview
  Hinge Cover
  Display Assembly
  Display Bezel
  Display Panel
  Display Latch
Display Overview
NOTICE: Disconnect the computer and attached devices from electrical outlets 
and remove any installed batteries. 
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by 
periodically touching unpainted metal on the computer. 
file:///F|/Service%20Manuals/Dell/Inspiron/8200/display.htm (1...

Display: Dell Inspiron 8200
 
1 display 
2 hinge cover
3 M2.5 x 6-mm screws (3)
4 bottom case
5 display flex cable
file:///F|/Service%20Manuals/Dell/Inspiron/8200/display.htm (2 of 10) \
[2/28/2004 7:40:53 AM] 

Display: Dell Inspiron 8200
Hinge Cover
 
1 hinge cover
1.  Follow the instructions in 
Preparing to Work Inside the Computer. 
2.  Use a nonmarring plastic scribe to loosen the hinge cover at the back an\
d at  each side of the computer. 
3.  Open the computer and use the scribe to pry between the 
 key and the 
hinge cover until the hinge cover pops off. 
4.  Open the display and lift off the hinge cover. 
Display Assembly
file:///F|/Service%20Manuals/Dell/Inspiron/8200/display.htm (3 of 10) \...

Display: Dell Inspiron 8200
 
1M2.5 x 6-mm screws (2)
1.  Remove the 
hinge cover. 
NOTICE: Remove the display flex cable before you remove the display 
assembly. 
file:///F|/Service%20Manuals/Dell/Inspiron/8200/display.htm (4 of 10) \
[2/28/2004 7:40:53 AM] 

Display: Dell Inspiron 8200
 
1 M2.5 x 6-mm screw
2 strain relief
3 display flex cable
4 pull loop
2.  Remove the M2.5 x 6-mm flex-cable strain relief screw, and then use the \
pull  loop to remove the display flex cable from the graphics card. 
NOTICE: When reconnecting the flex cable, press down on both ends of the 
connector, not in the middle. Pressing the middle of the connector can d\
amage 
fragile components. 
3.  Open the display and, from the back of the computer, remove the two M2.5\
 x 6- mm...

Display: Dell Inspiron 8200
 
file:///F|/Service%20Manuals/Dell/Inspiron/8200/display.htm (6 of 10) \
[2/28/2004 7:40:53 AM] 

Display: Dell Inspiron 8200
1M2.5 x 4-mm screws (6) 8M2 x 3-mm screws 
(6)
2 rubber screw covers (4) 9top cover
3 display bezel 10hinge cover
4 plastic tabs (6) 11display flex cable
5 M2.5 x 4-mm screw 12display panel
6 flex-cable mounting 
bracket 13
plastic screw covers 
(2)
7 display latch   
Display Bezel
1.  Use a scribe to pry out the four rubber screw covers located across the \
top of 
the bezel. 
2.  Remove the four M2.5 x 4-mm screws located across the top of the bezel. \
3.  Use a scribe at...