Dell Inspiron 7000 Service Manual

Removing and Replacing Parts 4-7
9. Remove the memory modules.
Carefully spread the inner metal tabs of the memory module socket to dis-
engage the module from the socket. The module should pop up slightly. 
Then pull the memory module out of the socket (see Figure 4-9).
)LJXUH0HPRU\0RGXOH5HPRYDO
10. Remove the video card.
Remove the two 3-mm screws securing the video card (see Figure 4-10). 
Gently pull the video card off of the connectors on the bottom of the sys-
tem board by lifting it at...

4-8HOO,QVSLURQ6HUYLFH0DQXDO
11. If present, remove the combo module or secondary battery from the 
options bay.
Unlock the latch lock by flipping it toward the back of the computer (see 
Figure 4-11). Slide the latch release in the direction of the arrow. Keep hold-
ing the latch release with one hand while pulling the combo module or 
secondary battery straight out of the options bay with the other.
)LJXUH&RPER0RGXOHRU6HFRQGDU\%DWWHU\5HPRYDO
NOTE: If the computer is booted with a...

Removing and Replacing Parts 4-9

)LJXUH5HOHDVLQJD=,)&RQQHFWRU
2. Pull up gently on the movable part of the connector until the cable is 
released.
3. Grasp the cable and pull it out of the connector.
To reconnect an interface cable to a ZIF connector, follow these steps: 
1. Use the flat-blade screwdriver or dental pick to open the movable part of 
the ZIF connector.
2. Orient the end of the cable with the ZIF connector, and insert the end of 
the cable into the connector.
3. While holding...

4-10HOO,QVSLURQ6HUYLFH0DQXDO
([SORGHG9LHZRI&RPSRQHQWVDQG
$VVHPEOLHV
Exploded views of the computer, the 13.3-inch and 14.1-inch display assem-
blies, the palmrest assembly, and the base assembly are shown in 
Figures 4-13, 4-14, 4-15, 4-16, and 4-17, respectively. 
)LJXUH([SORGHG9LHZ³&RPSXWHU
hinge covers (2)
keyboard
display assembly
thermal shield
hard-disk drive
batter y combo 
module 

Removing and Replacing Parts 4-11

)LJXUH([SORGHG9LHZ³,QFKLVSOD\$VVHPEO\
front bezel
LCD panel
carrier tray
LCD 
brackets (2)
hinges (2)
back cover
inverter boardLCD wire harness
CCFL cable 

4-12HOO,QVSLURQ6HUYLFH0DQXDO
)LJXUH([SORGHG9LHZ³,QFKLVSOD\$VVHPEO\
front bezel
LCD panel
carrier tray
LCD 
brackets (2)
hinges (2)
back cover
inverter boardLCD wire harness
CCFL cable
interposer 
board
inverter board 
shield 

Removing and Replacing Parts 4-13
)LJXUH([SORGHG9LHZ³3DOPUHVW$VVHPEO\
palmrest
speaker wire 
harness
IR board
display latch
display latch
spring
touch pad board
touch pad
bracket
right speaker
cover
touch pad 
button board
hard-disk drive 
heat shield
speakers (2)
left speaker
cover 

4-14HOO,QVSLURQ6HUYLFH0DQXDO

)LJXUH([SORGHG9LHZ³%DVH$VVHPEO\
LV D S  b o a r d
DC-DC board
processor board
right hinge 
saddle left hinge saddle
audio card audio thermal shieldPC Card cage audio bezelPC card heat sink
bracket
system board
LED board
heat 
exchanger/fan
Kensington lock
latch assembly
MPEG-2 card
MPEG-2 
card-carrier 
tray
plastic base
SODIMM heat 
sink
RJ-11 card 

Removing and Replacing Parts 4-15
)DFWRU\5HSDLU3DUWVDQG$VVHPEOLHV
This section contains a parts list and procedures for removing and replacing 
factory components and subassemblies. This information is provided for refer-
ence only. Dell does not recommend removal and replacement of these parts 
in the field. 
Table 4-1 lists the factory repair parts and assemblies available for the com-
puter. Some parts may only be available as part of a kit or assembly. The 
subsections in this chapter provide...

4-16HOO,QVSLURQ6HUYLFH0DQXDO
Heat Sink Assembly
Heat Exchanger Assembly ASSY,CAGE,MET,THRM SOLN,I7000 
Heat Exchanger, Metal Plate PLT,MET,CPU,NBK,I7000
SODIMM Heat Sink  HTSNK,DIMM,PRM,NBK,I7000 
PMThermal Solution, Metal Blocks w/ Fan CAGE,MET,THRM SOLN,CPU,I7000 
Fan FAN,25MMX25MM,5V,03W,I7000
Spacer SPCR,PLSTC,FAN,NBK,I7000 
Thermal Kit ASSY,PAD,THRM,INTFC,NBK,I7000 
Thermal Pad (Northbridge) PAD,THRM,INTFC,BX-CHIP,I7000
Thermal Pad (over processor) PAD,THRM,INTFC,CPU,I7000
Bottom Case
Bottom...