Dell Alienware M17x Service Guide

021021/
CHAPTER 5: PROCESSOR THERMAL FAN 
Processor Thermal Fan
WARNING:  Before  working  inside  your  computer,  read  the  safety information that shipped with your computer. For additional safety best practices  information,  see  the  Regulatory  Compliance  Homepage  at 
www.dell.com/regulatory_compliance. 
CAUTION:  To  avoid  electrostatic  discharge,  ground  yourself  by  using  a wrist  grounding  strap  or  by  periodically  touching  an  unpainted  metal surface (such as a connector on the...

022022/
CHAPTER 5: PROCESSOR THERMAL FAN 
1
2
3
1processor thermal fan cable connector3processor thermal fan
2captive screws (3) 
Removing the Processor Thermal Fan
Follow the instructions in “Before You Begin” on page 1. 6.
Remove the battery pack (see “Removing the Battery Pack” on page 2. 11).
Remove the compartment door (see “Removing the Compartment Door” on 3. page 14).
Loosen the three captive screws that secure the processor thermal fan to 4. the computer.
Disconnect the processor thermal fan...

CHAPTER 6: COIN-CELL BATTERY 
023023/
CHAPTER 6: COIN-CELL BATTERY
CHAPTER 6: COIN-CELL BATTERY 

024024/
CHAPTER 6: COIN-CELL BATTERY 
Coin-Cell Battery
WARNING:  Before  working  inside  your  computer,  read  the  safety information that shipped with your computer. For additional safety best practices  information,  see  the  Regulatory  Compliance  Homepage  at 
www.dell.com/regulatory_compliance. 
CAUTION:  To  avoid  electrostatic  discharge,  ground  yourself  by  using  a wrist  grounding  strap  or  by  periodically  touching  an  unpainted  metal surface (such as a connector on the back of...

025025/
CHAPTER 6: COIN-CELL BATTERY 
1
2
1coin-cell battery cable connector2coin-cell battery
Removing the Coin-Cell Battery
Follow the instructions in “Before You Begin” on page 1. 6.
Remove the battery pack (see “Removing the Battery Pack” on page 2. 11).
Remove the compartment door (see “Removing the Compartment Door” on 3. page 14).
Disconnect the coin-cell battery cable from the system board connector.4. 
Lift the coin-cell battery off the computer base.5. 
Replacing the Coin-Cell Battery
Place the...

CHAPTER 7: MEMORY MODULE(S) 
026026/
You  can  increase  your  computer  memory  by  installing  memory  modules  on the  system  board.  See  the  specifications  in  your  Mobile  Manual  or  in  the Comprehensive  Specifications  at  support.dell.com  for  information  on  the memory  supported  by  your  computer.  Install  only  memory  modules  that  are supported by your computer.
NOTE: Memory  modules  purchased  from  Dell  are  covered  under  your 
computer warranty. 
Your  computer  has  two...

027027/
CHAPTER 7: MEMORY MODULE(S) 
Memory Module(s)
WARNING:  Before  working  inside  your  computer,  read  the  safety information that shipped with your computer. For additional safety best practices  information,  see  the  Regulatory  Compliance  Homepage  at 
www.dell.com/regulatory_compliance. 
CAUTION:  To  avoid  electrostatic  discharge,  ground  yourself  by  using  a wrist  grounding  strap  or  by  periodically  touching  an  unpainted  metal surface (such as a connector on the back of...

028028/
CHAPTER 7: MEMORY MODULE(S) 
Removing the Memory Module(s)
Follow the instructions in “Before You Begin” on page 1. 6.
Remove the battery pack (see “Removing the Battery Pack” on page 2. 11).
Remove the compartment door (see “Removing the Compartment Door” on 3. page 14).
Loosen the captive screw and slide the memory module door out of the 4. computer base.
CAUTION: If you need to remove memory modules from both connectors, remove the memory module in the upper connector before you remove the...

029029/
CHAPTER 7: MEMORY MODULE(S) 
Use your fingertips to carefully spread apart the spring-locks on the memory 5. module connector until the module pops up.
Remove the memory module.6. 
12
45
3
1memory module4tab
2spring locks (2)5notch
3memory module connector
Replacing the Memory Module(s)
CAUTION:  If  you  need  to  install  memory  modules  in  two  connectors, install  a  memory  module  in  the  lower  connector  before  you  install  a module in the upper connector.
Align the notch on the...

030030/
CHAPTER 7: MEMORY MODULE(S) 
Replace and tighten the captive screw that secures the memory module 3. door to the computer base.
Replace the compartment door (see “Replacing the Compartment Door” on 4. page 14).
Replace the battery pack (see “Replacing the Battery Pack” on page 5. 11).
CAUTION: Before turning on the computer, replace all screws and ensure that  no  stray  screws  remain  inside  the  computer.  Failure  to  do  so  may result in damage to the computer.
Turn on the computer. 6. As...