Land Rover Defender 90 110 Workshop Book 4 Rover

							CHASSIS AND BODY 
I e 0 
76 
ST1967M 
11. Locate the packing  strip and  secure  the opposite 
runner  with the  two  screws. Ensure that all three 
screw  heads  are well  below  the bottom 
of the 
runners  to prevent  damage 
to the glass. 
12. Locate the  regulator in the  window lift  channels. 
13. Carry-out  the instructions  to fit  the  mounting 
14. Fit the  door trim,  window  regulator,  door pull and 
panel. 
bezels. 
REMOVING LOCKING BARREL -front doors 
  To remove 
ST1981M 
6. Withdraw  the lock  barrel  from the  exterior  door 
handle  complete  with the locking  sleeve. 
ST1980M 
1. Remove  the  regulator  handle,  door pull, bezels, 
2. Carry-out  the instructions  to remove  the mounting 
3. Raise  and support  the  glass to gain  access  to the 
4. Release  the spring clip  and disconnect  the rod from 
5. Remove  the single  screw  and withdraw  the lock 
door 
trim and weather  protection sheet. 
panel. 
latch  mechanism. 
the 
lock operating  lever. 
7. To remove the bane1 from  the  plastic retaining 
sleeve,  depress  the spring  loaded  button  and 
withdraw  the sleeve. 
lever  assembly. 
7 
ST1979M 
continued 
19  
						

							1761 CHASSIS AND BODY 
Refit the lock  barrel 
Note: 
If a new  barrel is being  fitted,  check  that  the 
number on  the  barrel coincides with the number 
on the 
accompaaing key. 
8. Push  the  plastic retaining  sleeve over the barrel 
until  the spring  loaded peg  locks it into position. 
9. Fit the  barrel  and plastic  sleeve  assembly  to  the 
locking  sleeve  and insert  into the exterior  handle 
reversing  instruction 
6. 
10. Assemble  the lock  lever components as  illustrated 
and 
from the  inside of the door  panel, fit them  to 
the  barrel  assembly with  the single  screw. 
ST1978M 
11. Connect  the  operating  rod  to the lock lever  and 
secure  with the spring  clip, reversing  instruction 
4. 
12. 
Fit  the  mounting  panel  and weather  protection 
sheet. 
Fit the  door  trim, regulator  handle, door 
pull  and bezels. 
20