D-Link Router DIR-865L User Manual

							26D-Link DIR-865L User Manua\f
Section 3 - Confi\buration
Web-based Configuration Utility
Se\fect Admin from the drop-down menu and then enter 
your password. Leave the password b\fank by defau\ft.
To access the confi\buration uti\fity, open a web-browser such as Internet 
Exp\forer and enter the IP address of the router http://192.168.0.1. 
You may a\fso type the name of the router (http://d\binkrouter.\boca\b).  
						

							27D-Link DIR-865L User Manua\f
Section 3 - Confi\buration
Internet Conne\ftion Setup
C\fick Manua\b.Internet .Connection .Setup  to  confi\bure  your 
connection manua\f\fy and continue to the next pa\be.
If you want to confi\bure your router to connect to the Internet 
usin\b  the  wizard,  c\fick Internet .Connection .Setup .Wizard. 
You wi\f\f be directed to the Quick Setup Wizard. P\fease refer to 
pa\be 14.
The next few pa\bes wi\f\f exp\fain each of the ISP connection types. 
You  can  se\fect  the  type  from  the My .Internet .Connection .Is 
drop-down menu.
You may a\fso confi\bure your router to be a wire\fess c\fient/brid\be. 
This  is  usefu\f  if  you  want  to  connect  Ethernet  devices  to  your 
wire\fess  network  if  you  current\fy  have  a  wire\fess  router.  P\fease 
refer to pa\be 43 for more information.
Note: For  802.11ac  performance,  you  must  connect  to  another 
802.11ac wireless router. The DI\b-865L will automatically adjust to 
the connection type of your router.
Also,  if  bridge  mode  is  enabled,  all  router  functions  (NAT,  filtering, 
DHCP ser\fer, etc) will be disabled as well as mydlink and SharePort 
Mobile functions.  
						

							28D-Link DIR-865L User Manua\f
Section 3 - Confi\buration
Se\fect Static.IP to manua\f\fy enter the IP settin\bs supp\fied by 
your ISP.
Enter the IP address assi\bned by your ISP.
Enter the Subnet Mask assi\bned by your ISP.
Enter the Gateway assi\bned by your ISP.
The  DNS  server  information  wi\f\f  be  supp\fied  by  your  ISP 
(Internet Service Provider.)
Maximum Transmission  Unit  -  you  may  need  to  chan\be  the 
MTU  for  optima\f  performance  with  your  specific  ISP.  1500  is 
the defau\ft MTU.
The defau\ft MAC Address is set to the Internet port’s physica\f 
interface MAC address on the Broadband Router. It is not recommended that you chan\be the defau\ft MAC address un\fess 
required by your ISP.  You can use the Copy.Your.PC’s.MAC. Address button to rep\face the Internet port’s MAC address with 
the MAC address of your Ethernet card.
My Internet Conne\ftion:
IP Address:
Subnet Mask:
Default Gateway:
DNS Servers:
MTU:
MAC Address:
Manual Internet Setup
Stati\f (assigned by ISP)
Se\fect Static. IP if a\f\f the Internet port’s IP information is provided to you by your ISP. You wi\f\f need to enter in the IP address, subnet mask, \bateway 
address, and DNS address(es) provided to you by your ISP. Each IP address entered in the fie\fds must be in the appropriate IP form, which are four 
octets separated by a dot (x.x.x.x). \uThe Router wi\f\f not accept the IP address if it is not in\u this format.  
						

							29D-Link DIR-865L User Manua\f
Section 3 - Confi\buration
Se\fect Dynamic.IP .(DHCP)  to  obtain  IP  Address  information 
automatica\f\fy from your ISP. Se\fect this option if your ISP does not 
\bive you any IP numbers to use. This option is common\fy used for 
cab\fe modem services.
The Host Name is optiona\f but may be required by some ISPs. Leave 
b\fank if you are not sure.
Check the box if you are havin\b prob\fems obtainin\b an IP address 
from your ISP.
Enter the Primary and secondary DNS server IP addresses assi\bned 
by  your  ISP.  These  addresses  are  usua\f\fy  obtained  automatica\f\fy 
from your ISP. Leave b\fank if you did not specifica\f\fy receive these 
from your ISP.
Maximum Transmission Unit - you may need to chan\be the MTU 
for optima\f performance with your specific ISP. 1500 is the defau\f\ut MTU.
The defau\ft MAC Address is set to the Internet port’s physica\f interface MAC address on the Broadband Router. It is not recommended 
that you chan\be the defau\ft MAC address un\fess required by your ISP.  You can use the Copy. Your.PC’s.MAC. Address button to 
rep\face the Internet port’s MAC address with the MAC address of your Ethernet card.
My Internet 
Conne\ftion:
Host Name:
MAC Address:
Dynami\f (Cable)
Primary/Se\fondary 
DNS Server:
MTU:
Use Uni\fasting:  
						

							30D-Link DIR-865L User Manua\f
Section 3 - Confi\buration
Se\fect PPPoE.(Username/Password) from the drop-down menu.
Se\fect Static.IP  if  your  ISP  assi\bned  you  the  IP  address,  subnet  mask, 
\bateway, and DNS server addresses. In most cases, se\fect Dynamic.
Enter the IP address (Static PPPoE on\fy).
Enter your PPPoE user name.
Enter your PPPoE password and then retype the password in the next box.
Enter the ISP Service Name (optiona\f).
Se\fect either A\bways-on, \fn-Demand, or Manua\b.
Enter  a  maximum  id\fe  time  durin\b  which  the  Internet  connection 
is  maintained  durin\b  inactivity.  To  disab\fe  this  feature,  enab\fe  Auto-
reconnect.
Se\fect Receive. DNS.from. ISP to automatica\f\fy use your ISP’s DNS servers 
or se\fect Enter.DNS.Manua\b\by and enter the Primary and Secondary DNS Server Addresses of your choice.
Maximum Transmission Unit - you may need to chan\be the MTU for optima\f performance with your specific ISP. 1492 is the defau\ft MTU.
The defau\ft MAC Address is set to the Internet port’s physica\f interface MAC address on the Broadband Router. It is not recommended 
that you chan\be the defau\ft MAC address un\fess required by your ISP.  You can use the Copy. Your.PC’s.MAC. Address button to 
rep\face the Internet port’s MAC address with the MAC address of your Ethernet card.
My Internet 
Conne\ftion:
Address Mode:
IP Address:
User Name:
Password:
Servi\fe Name:
Re\fonne\ft 
Mode:
Maximum Idle 
Time:
DNS Mode/ 
Addresses:
MTU:
MAC Address:
Internet Setup
PPPoE (DSL)
Choose  PPPoE  (Point  to  Point  Protoco\f  over  Ethernet)  if  your  ISP  uses  a  PPPoE  connection. Your  ISP  wi\f\f  provide  you  with  a 
username and password. This option is typica\f\fy used for DSL services. Make sure to remove your PPPoE software from your 
computer. The software is no \fon\ber need\ued and wi\f\f not work throu\bh a router.  
						

							31D-Link DIR-865L User Manua\f
Section 3 - Confi\buration
Se\fect PPTP.(Username/Password) from the drop-down menu.
Se\fect Static if your ISP assi\bned you the IP address, subnet mask, 
\bateway, and DNS server addresses. In most cases, se\fect Dynamic.
Enter the IP address (Static PPTP on\fy).
Enter the Primary and Secondary DNS Server Addresses (Static PPTP 
on\fy).
Enter the Gateway IP Address provided by your ISP.
Enter the Server IP provided by your ISP (optiona\f).
Enter your PPTP username.
Enter your PPTP password and then retype the password in the next 
box.
Se\fect either A\bways-on, \fn-Demand, or Manua\b.
Enter  a  maximum  id\fe  time  durin\b  which  the  Internet  connection 
is maintained durin\b inactivity. To disab\fe this feature, enab\fe Auto-
reconnect.
Internet Setup
PPTP
Choose PPTP (Point-to-Point-Tunne\fin\b Protoco\f ) if your ISP uses a PPTP connection. Your ISP wi\f\f provide you with a username 
and password. This option is typica\f\fy used for DSL services. 
My Internet 
Conne\ftion:
Address Mode:
PPTP IP Address:
PPTP Subnet 
Mask:
PPTP Gateway:
PPTP Server:
Username:
Password:
 
Re\fonne\ft 
Mode:
Maximum Idle 
Time:  
						

							32D-Link DIR-865L User Manua\f
Section 3 - Confi\buration
The DNS server information wi\f\f be supp\fied \uby your ISP (Internet Service Provider.)
Maximum Transmission Unit - you may need to chan\be the MTU for optima\f performance with your specific ISP. 1400 is the defau\ft 
MTU.
The defau\ft MAC Address is set to the Internet port’s physica\f interface MAC address on the Broadband Router. It is not recommended 
that you chan\be the defau\ft MAC address un\fess required by your ISP.  You can use the C\bone.Your.PC’s.MAC. Address button to 
rep\face the Internet port’s MAC address with the MAC address of your Ethernet card.
DNS Servers:
MTU:
MAC Address:  
						

							33D-Link DIR-865L User Manua\f
Section 3 - Confi\buration
Se\fect L2TP.(Username/Password) from the drop-down menu.
Se\fect Static  if  your  ISP  assi\bned  you  the  IP  address,  subnet 
mask, \bateway, and DNS server addresses. In most cases, se\fect 
Dynamic.
Enter the L2TP IP addr\uess supp\fied by your ISP (Static on\fy).
Enter the Subnet Mask supp\fied by your ISP (Static on\fy).
Enter the Gateway IP Address provided by your ISP.
Enter the Server IP provided by your ISP (optiona\f).
Enter your L2TP username.
Enter  your  L2TP  password  and  then  retype  the  password  in 
the next box.
Se\fect either A\bways-on, \fn-Demand, or Manua\b.
Enter  a  maximum  id\fe  time  dur in\b  which  the  I nter net 
connection  is  maintained  durin\b  inactivity.  To  disab\fe  this 
feature, enab\fe Auto-reconnect.
My Internet 
Conne\ftion:
Address Mode:
L2TP IP Address:
L2TP Subnet 
Mask:
L2TP Gateway:
L2TP Server IP:
Username:
Password:
Re\fonne\ft 
Mode:
Maximum Idle 
Time: 
Internet Setup
L2TP
Choose L2TP (Layer 2 Tunne\fin\b Protoco\f) if your ISP uses a L2TP connection. Your ISP wi\f\f provide you with a username and 
password. This option is typica\f\fy used for DSL services.   
						

							34D-Link DIR-865L User Manua\f
Section 3 - Confi\buration
DNS Servers:
MTU:
Clone MAC 
Address:
Enter the Primary and Secondary DNS Server Addresses (Static L2TP on\fy).
Maximum Transmission Unit - you may need to chan\be the MTU for optima\f performance with your specific ISP. 1400 is the defau\ft 
MTU.
The defau\ft MAC Address is set to the Internet port’s physica\f interface MAC address on the Broadband Router. It is not recommended 
that you chan\be the defau\ft MAC address un\fess required by your ISP.  You can use the C\bone.Your.PC’s.MAC. Address button to 
rep\face the Internet port’s MAC address with the MAC address of your Ethernet card.  
						

							35D-Link DIR-865L User Manua\f
Section 3 - Confi\buration
Internet Setup
DS-Lite
Another Internet Connection type is DS-Lite.
DS-Lite 
Configuration:
Se\fect  the  DS-Lite  DHCPv6  option  to  \fet  the  router  a\f\focate 
the  AFTR  IPv6  address  automatica\f\fy.  Se\fect  the  Manua\f 
Confi\buration to enter the AFTR IPv6 address in manua\f\fy.
AFTR IPv6 
Address:
After se\fectin\b the Manua\f Confi\buration option above, enter 
the AFTR IPv6 address used here.
B4 IPv4 Address:Enter the B4 IPv4 address va\fue used here.
WAN IPv6 
Address:
Once connected, the WAN IPv6 address wi\f\f be disp\fayed here.
IPv6 WAN 
Default Gateway
Once  connected,  the  IPv6 WAN  Defau\ft  Gateway  address  wi\f\f 
be disp\fayed here.
DS-Lite is an IPv6 connection type. After se\fectin\b DS-Lite, the fo\f\fowin\b parameters wi\f\f be avai\fab\fe for confi\buration: