compaq lte elite User Manual

Parity: When the Parity feature is enabled, the controller checks the
parity of received data from the SCSI-2 bus. The controller
always generates parity when transmitting data onto the SCSI-2
bus.
Disconnect: When the Disconnect feature is enabled, the controller
overlaps communications across the SCSI-2 bus. The controller
can request operation from multiple SCSI-2 devices in
parallel, increasing overall bus performance. If Disconnect is
disabled or a SCSI-2 device does not support this mode, the...

1. Install the SCSI-2 drive (Section 9.15).
2. Connect the SCSI-2 signal and power cables (Figure F-2) as follows:
- Connect one end of the SCSI-2 signal cable [1] to the connector on the
system board.
- Connect the other end [2] to the connector on the rear of the drive.
- Connect the outside connector of the drive power cable [3] to the
connector on the rear of the drive.
- Be sure that the other end of the drive power cable [4] is connected
to the vertical circuit board.
NOTE: Cables and connectors...

5. Install the SCSI-2 drivers to allow the computer to recognize the SCSI-2
drive in the expansion base (Section F.6).
6. If you installed a SCSI-2 hard drive, format and partition the drive.
Refer to the Compaq EZ-SCSI Software Reference Guide for additional
information.
7. Reboot the computer by pressing the Ctrl+Alt+Delete keys to integrate
the new information.
8. If the computer does not automatically reconfigure the system when you
turn it on, run Computer Setup ( Section 6.7).
9. Run Computer...

The SCSI drivers enable the computer to communicate with optional SCSI-2 
devices. For detailed information about the SCSI-2 drivers and utilities, 
refer to the Compaq EZ-SCSI Software Reference Guide. 
IMPORTANT: To ensure that the computer recognizes a SCSI-2 device andinstalls all necessary drivers, turn on the device before 
turning on the computer and ensure that the device is turned on 
when you install the device drivers.
Installing SCSI-2 Drivers on the Compaq LTE Elite 
The SCSI-2 drivers are...

Appendix G - Cleaning the Trackball Assembly 
 
Introduction 
This appendix covers the procedures for cleaning the trackball assembly.
Under normal circumstances, the display bezel and trackball can be wiped
clean with a dry, soft, lint-free cloth. If, however, the cursor or
trackball skips or moves abnormally, the ball should be removed and
cleaned.
G.1 Removing The Ball 
To remove and clean the ball, complete the following steps:
1. Turn off the computer.
2. Fully open the display.
3. Place the...

4. Remove the retaining ring.
5. Remove the ball by tilting the display forward so that the ball falls
out into your hand.
6. Clean the ball with an alcohol pad and dry it with a lint-free cloth.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>