Comdial Solo II Telephone User Guide

Feature Operation 
If on line listening to busy tone or no answer, 
l Press REDIAL key twice. 
l If using handset, pause a few seconds and hang 
UP. 
-OR- 
l If using speakerphone, station will automatically 
hang up. 
l Station will redial number once a minute for IO 
minutes. 
When party answers, 
l Lift handset. (If on speakerphone, press 
MONITOR key or station will hang up.) 
To cancel call and automatic redial action, 
l Lift and replace handset during ringing. 
To cancel between call attempts, 
l...

Feature Operation 
If your system has been configured for recall, 
l Press TAP to disconnect (as if you had hung up), 
and obtain a new dial tone for another call. 
NOTE: System can be configured for recall or tap, but 
not for both. 
POSITIVE DISCONNECT/RECALL 
l If the hookswitch in the handset cradle is pressed 
and released while the handset is off-hook, a 
timed disconnect of the active line is performed. 
This feature retains the dial tone recall feature for 
use on stations where the TAP key is...

Feature Operation 
MUTE 
To prevent other party from hearing, 
l Press MUTE (monitor light flutters). 
l Press MUTE again to resume conversation 
(monitor light turns off). 
MESSAGE WAITING 
For internal system messaging, the message 
betweenSolo stations, waiting light of one sta- 
tion is controlled by another station designated 
as the Message Center by programming. 
NOTE: The message waiting light is located directly 
above the HOLD key. 
To turn station message waiting light on, 
l Press +# (idle...

Feature Operation 
STATION DIRECTORY 
A pull-out shelf contains a paper station direc- 
tory card which can be used to store identifica- 
tions as follows: 
l Level 2 autodial identification for locations 21-40. 
l Speed dial identification locations for locations 1-O. 
NOTE: The identification for the level 1 auto dial loca- 
tions l-20 should be placed on the station index card 
(located between the memory keys) along with the 
identification of station select key. 
USING THE DATAPORT 
(Auxiliary jack...

OPTIONS 
SPEAKERPHONE OPERATION 
NOTE: A speakerphone can be identified by the 
microphone opening on the front right-hand edge of 
the housing (refer to the illustration provided in the 
front of this manual). 
PLACING A CALL 
l Press line key. 
l Dial number or press memory key. 
When party answers, 
l Speak toward the station. 
ANSWERING A CALL 
l Press line key. 
l Speak toward the set. 
ENDING A CALL 
l Press SPKR. 
SWITCHING FROM HANDSET TO SPEAKERPHONE 
l Press SPKR. 
l Hang up handset. 
SWITCHING...

Thb manual b been dewloped bv Comdiol Corporation (the ‘Cornpaw? and is intended for the use 1 
of its customers and service personnel. The inforination in this markal is subject to cha 
8 without 
notice. While every effort has been made to eliminate enors, the Company disclaims liobl Itv for any 
7 
diiiuttiis arising from the interpretation of the information contained herein. The information 
contained herein &es not ~urwrt to cowr ail ctetnik or vorintions in nnuinmant nor to nrovirb fnr 
every...