Home
>
Comdial
>
Communications System
>
Comdial Executech Model 616, 616b ELECTRONIC KEY SYSTEM Instructions Manual
Comdial Executech Model 616, 616b ELECTRONIC KEY SYSTEM Instructions Manual
Here you can view all the pages of manual Comdial Executech Model 616, 616b ELECTRONIC KEY SYSTEM Instructions Manual. The Comdial manuals for Communications System are available online for free. You can easily download all the documents as PDF.
Page 1
COMDWL Executecti MODEL 616 AND 616B ELECTRONIC KEY SYSTEM Committed to U.S. leadership in business communications IMI 66-037 JULY, 1966
Page 2
IMI 66-037 June, 1986 INSTALLATION AND MAINTENANCE INFORMATION FOR THE Model 616 and 616B ELECTRONIC KEY SYSTEMS SERIAL NUMBER _ _ --.. i .w..w..- .ip.+. - i _ i i i.ic .~.i .e..d.dri iii
Page 3
Introduction CHAPTER 1 INTRODUCTION IMI 66-037 SECTION 1 GENERAL INFORMATION MANUAL SCOPE This publication contains installation and maintenance information for the Model 616l3 and 616 electronic key systems and associated electronic key telephone sets. The installation procedures detailed in this manual, for the most part, should be performed by a trained technician. The following service items may, however, he performed by any user at his or her discretion. All other servicing must be...
Page 4
Introduction IMI 66-037 yo+e,l, Variations -------I-- The Model 616 key system unit has been produced in two versions. The currently produced version is designated as 616B KSU. It is an enhanced unit which provides standard key system features, adds station pin upward compatibility for growth, and includes advanced operating features such as expanded toll restriction and class of service printout data. The earlier produced version is designated as 616 KSU and is currently available only as a...
Page 5
Introduction IMI 66-037 e{d_z!?Q Conference LInternalL I-s--.s--s- -------- This system feature allows the stations, while operating in a private mode, to add another station to an existing call or to a multiline call. All-call and zone paging allows the system stations to be used to receive or originate one-way messages in order to find, notify, or summon someone. A station can be enabled by programming to receive all-call and zone paging messages through the station speaker, and to...
Page 6
Introduction IMI 66-037 A system feature provides automatic privacy on all lines at-every station. Automatic privacy prevents other stations from jolnlng a station on an active line unless that station user allows it. Through programming, the system can be configured so that certain lines are normally non-private. When the non-private line is in use at a particular station, users of other stations in the m system can join that station user on the non-private line. This can be accomplished by...
Page 7
Introduction IMI 66-037 The system programming is electronically protected during an AC power failure by a battery-like device called a super-cap. The stored program data will remain in memory for a minimum of 30 hours after AC power fails or is disconnected. The system must be powered continuously for at least 30 minutes prior to the power failure or disconnection for memory preservation to occtir. m_s.y $_a~ Field Station :(@pt.ion) - - - - i ii - i - - - - --W-- There is an optionally...
Page 8
Introduction C,la_s_s_ Qff_ Service ?Y.ogr.amminq i----m- ---w-- IMI 66-037 .iFrom Main StationL --mm ---- --.s---- All class of service (COS) programming is performed from station 10. COS programming is used by the installer to configure and maintain the system, line, and station operating conditions. Class Of Se.rv.ice Printout m---s -- w-B---- -----i-- (Model 616R KSU) Class of service and toll restriction records are made available- by the system as serial, ASCII data. It can be received...
Page 9
3 Introduction I-MI 66-037 A faceplate mounted volume control on each station can be adjusted to set the audio level of the call announce speaker output. A bottom mounted volume control on each station can adjusted to set the audio level of the tone ringer. he - End ;Q End zignal.ling (Qff-?ook Dia1.inq.r W-B m i - - - - - - - - - - - - ii-- - - - - - - The system can generate DTMF tones from a dialing station, send them through the TELCO network, and have them received at the distant end for...
Page 10
Introduction IMI 66-037 Flexible. Rinq,ing &s_.iqnment.s .lpel_a_yg&, Qis_gQl;e& S~b_&gdl *%-r-ii - -- --- - -* S---i- Flexible ringing assignments are programmable on a per line/per station basis. The system can be configured to provide direct ringing for every line at every station; direct ringing for prime line with delayed ringing for all other lines; and prime line ringing only. Ringing can be disabled for each line on an individual basis at each station. Subdued ringing is - automatically...