Casio Projector XJ-F20XN User Manual

71
No sound output from the 
AUDIO OUT terminalThe projector’s volume level setting may be too low or muted. Use the remote 
controller [VOLUME +] and [VOLUME –] keys to adjust the volume level. See page 
20.
The volume level setting of the device connected to the projector is too low or the 
other device is not outputting audio. Adjust the volume level of the connected 
device.
The audio output of the connected device may not be connected correctly to the 
projector’s AUDIO IN terminal. Check the...

72
Important!Try performing the following steps, which may or may not return the projector to normal 
operation.
If normal operation does not resume after you perform the above steps, take the projector to 
your retailer or authorized CASIO service center.
Power suddenly turns off 
and the projector restarts.The projector periodically performs a self-check operation. In rare cases, the result of 
a self-check may cause the projector to restart automatically. This normally does not 
indicate...

73
Appendix
This section explains how to establish a component video connection between the projector and a 
video device.
Component video output terminals come in 3-terminal sets: Y·Cb·Cr or Y·Pb·Pr. Be sure to match 
the colors of the plugs on a component video cable with the colors of the terminals (Green: Y; 
Blue: Cb/Pb; Red: Cr/Pr).
Note that connection only to an analog component video output terminal is supported.
Connection to a digital output terminal is not supported.
XJ-V Series
Connecting...

74
XJ-F Series
NoteNote that regardless of whether the image being projected is being input via the projector’s 
S-VIDEO terminal or VIDEO terminal, the projector outputs audio that is input via the 
projector’s AUDIO IN L/R terminals.
Connecting to a Composite Video Output or S-Video 
Output (XJ-F Series Only)
Projector
Video device
Stereo mini plug  Pin plug type audio cable 
(commercially available)To component video 
output terminals
Component video cable (commercially available)To audio output...

75
Power can be supplied to external equipment via the USB-A/DC 5V port of an XJ-F20XN, XJ-F200WN, 
or XJ-F210WN model projector, or via the DC 5V port of an XJ-F10X or XJ-F100W model projector.
Important!Turning off projector power also cuts power being supplied to external equipment. Note that 
power being supplied is also cut when the projector is turned off due to restarting by its 
self-check function or Auto Power Off, due to some error, or for any other reason. Depending 
on the external...

76
With an XJ-V Series projector, you can update firmware (software in the projector flash ROM) using a 
computer. With an XJ-F Series projector, you can update firmware and also transfer images to the 
projector to be used as a user logo.
For details about these operations, refer to the “Projector Firmware Update Guide” and “User Logo 
Transfer Guide”, which are available for download from the CASIO projector website.
To update firmware and transfer a user logo
Use a commercially available USB cable to...

77
The projection distance values below are for reference when setting up the projector.
“h” in the illustration and table indicates the distance between the center of the projector lens and 
the bottom edge of the projection screen.
Projection Distance and Screen Size
Projection Size
Approximate Projection Distance
XJ-V10X/XJ-F10X/XJ-F20XNXJ-V100W/XJ-V110W/XJ-F100W/
XJ-F200WN/XJ-F210WN
Screen 
SizeDiagonal
(cm)Minimum 
Distance
(m / feet)Maximum 
Distance
(m / feet)hMinimum 
Distance
(m / feet)Maximum...

78
The following shows how images are projected in accordance with the type of the input signal and the 
aspect ratio setting of the projector.
XJ-V100W/XJ-V110W/XJ-F100W/XJ-F200WN/XJ-F210WN
Input source: RGB or HDMI(PC)
Input source: Video*, S-Video*, Component or HDMI(DTV)
*XJ-F100W/XJ-F200WN/XJ-F210WN only
Aspect Ratio Setting and Projection Image
Input SignalNormalFull16:94:3True
SVGA (800 × 600)
XGA (1024 × 768)
WXGA (1280 × 800)
SXGA (1280 × 1024)
Input SignalNormal16:916:104:3Letter Box
4:3 Aspect...

79
XJ-V10X/XJ-F10X/XJ-F20XN
Input source: RGB or HDMI(PC)
Input source: Video*, S-Video*, Component or HDMI(DTV)
*XJ-F10X/XJ-F20XN only
Input SignalNormalFull16:916:10
SVGA (800 × 600)
XGA (1024 × 768)
WXGA (1280 × 800)
SXGA (1280 × 1024)
Input SignalNormal16:916:104:3
4:3 Aspect Image
Squeezed Image
Letter Box Image
16:9 Aspect Image 

80
Important!Even if a signal is listed in the table below, it does not guarantee that you will be able to 
display its images correctly.
RGB Signal
Supported Signals
Signal NameResolutionHorizontal Frequency 
(kHz)Vertical Frequency 
(Hz)
VESA640 × 480/60 640 × 480 31.5 60
640 × 480/72 640 × 480 37.9 73
640 × 480/75 640 × 480 37.5 75
640 × 480/85 640 × 480 43.3 85
800 × 600/56 800 × 600 35.2 56
800 × 600/60 800 × 600 37.9 60
800 × 600/72 800 × 600 48.1 72
800 × 600/75 800 × 600 46.9 75
800 × 600/85 800...