Casio Lk270 Instruction Manual

English
Sampling Sounds and Playing Them on the Digital Keyboard
E-19
Use the procedures in this section to sample a sound and play 
it as the melody part on the Digital Keyboard.
 Up to five sampled sounds can be stored in Digital 
Keyboard memory as tone numbers 571 through 575. 
Simply select the tone number where the sound you want is 
located to assign the sound to the keyboard.
1.Press bp and then use bs (10-key) to enter the 
tone number (571 to 575) where you want to 
store the sampled sound.
...

Sampling Sounds and Playing Them on the Digital Keyboard
E-20
■How sampled sounds are played
Pressing Middle C (C4) will play back the original sound. The 
keys to the left and right of C4 play the sound at different 
pitches.
You can use the following procedure to loop a sampled sound 
so it continues to repeat, as you play on the Digital Keyboard.
1.Press bq.
2.While holding down cs, press co.
This enters repeat standby.
3.Press the button (bt to cn) that corresponds to 
the melody sampling tone number...

English
Sampling Sounds and Playing Them on the Digital Keyboard
E-21
You can apply various effects to sampled sounds.
1.Press bp and then use bs (10-key) to enter the 
tone number (571 to 575) to which you want to 
apply effects.
2.Press bp to cycle thorough the available 
effects, described below.
 Avoid assigning the same sampled sound to the keyboard 
for play along and for looped play. Doing so will cause, the 
Loop 1 effect to be applied to the keyboard tone while 
looped play of the sampled sound...

Sampling Sounds and Playing Them on the Digital Keyboard
E-22
5.Output the sound from the external device. In 
the case of a microphone, output the sound in 
the direction of the microphone.
Sampling will start automatically.
6.After the sound you want to sample is finished, 
press 
cs.
Sampling will stop when you release cs.
 Even if you do not press 
cs, sampling will stop 
automatically whenever there is no more sound being 
input from the external device or microphone. Sampling 
also will stop...

English
Sampling Sounds and Playing Them on the Digital Keyboard
E-23
■To change the pitch of a sampled sound
While holding down the keyboard key of the sampled sound 
whose pitch you want to change, use the 
bs (10-key) [–] and 
[+] keys to change the pitch.
 You can change the pitch within a range of –64 to 63 
semitones.
■To delete a keyboard key’s sampled sound
While holding down the keyboard key whose sound you want 
to delete, press 
bq. In response to the “DelSure?” message 
that appears, press...

Sampling Sounds and Playing Them on the Digital Keyboard
E-24
Normally the Digital Keyboard will stop sampling automatically 
whenever it detects there is no sound input. You can use the 
following procedure to enable manual sampling stop, which 
will cause sampling to continue until you press a button to 
stop it. You can use this to insert silence after the sampled 
sound.
1.Press ct and then use the bs (10-key) [4] ( ) 
and [6] ( ) keys to display “SAMPLING” (page 
E-6).
2.Press the bs (10-key) [7]...

English
Sampling Sounds and Playing Them on the Digital Keyboard
E-25
You can use the following procedure to protect each sampled 
sound against accidental deletion.
1.Press bp and then use bs (10-key) to enter the 
tone number of the sampled tone you want to 
protect.
2.Press ct and then use the bs (10-key) [4] ( ) 
and [6] ( ) keys to display “SAMPLING” (page 
E-6).
3.Press the bs (10-key) [7] (ENTER) key.
4.Use the bs (10-key) [4] ( ) and [6] ( ) keys 
to display “Protect”.
5.Press the bs (10-key) [+]...

E-26
Playing Built-in Songs
With this Digital Keyboard, built-in tune data is referred to as 
“songs”. You can listen to the built-in songs for your own 
enjoyment, or you can play along with them for practice.
 In addition to simple listening enjoyment, the built-in songs 
can be used with the lesson system (page E-31) for 
practice.
 You can increase the number of tunes using your SD 
memory cards (page E-56) or computer (page E-58).
Use the following procedure to play back built-in songs.
1.Press bm...

English
Playing Built-in Songs
E-27
Use the procedure below to play back one of the built-in 
songs. You can play along on the keyboard with song 
playback.
1.Press br.
2.Use bs (10-key) to enter the number of the song 
you want.
 See page E-69 for a complete list of available songs.
3.Press bm.
This starts playback of the song. Keyboard keys will light 
as notes are played.
4.Press bm again to stop playback.
Song playback will continue (repeat) until you press bm to 
stop it. You can cancel song repeat...

Playing Built-in Songs
E-28
You can use the procedure in this section to repeat particular 
measures for practice playing along until you master it. You 
can specify the start measure and the end measure of the 
section you want to play and practice.
1.Press 8 to temporarily turn off song repeat 
(“REPEAT” disappears from the display).
2.When song playback reaches the measure you 
want to specify as the start measure, press 
8.
This specifies the measure as the start measure.
3.When playback reaches the...